WenmarOpen by Wenmar Pro

Transport Canada recall 2017385

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

Campaign
Published byTransport Canada (Canada)
Campaign number2017385
Manufacturer's numberPM691
Reported2017-08-04
ComponentAirbag
Notification typeSafety Mfr
Units potentially affected768

What is wrong

On certain vehicles, the passenger's frontal airbag may not deploy correctly due to an issue in manufacturing. As a result of long-term storage, there could be insufficient compression strength of the coolant within the inflator housing of the passenger's frontal airbag, which may cause the airbag to fail to deploy properly in the event of a crash (where deployment is warranted), which could increase the risk of injury to the front passenger occupant. Correction: Dealers will replace the passenger's frontal airbag inflator. Note: This is an expansion of recall 2017-215.

Vehicles this campaign lists
2014 NISSAN SENTRA
2016 NISSAN SENTRA
2017 NISSAN SENTRA

A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.

Bulletins for the same vehicles and component

Bulletins for the same vehicles and component
NTB19-071D2024-10-22. Service bulletin. DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. IF YOU CONFIRM DTC B00A0-00 (OCCUPANT DETECTION SENSOR UNIT) is stored, AND OCS zero point reset cannot be performed, (continued on the next page)
NTB19-071C2023-04-10. Service bulletin. DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB19-071B2022-06-03. Service bulletin. DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB16-0462021-05-24. Service bulletin. Occupant Clfassification System Light Operation Logic Change
NTB160462021-05-10. Service bulletin. SERVICE INFORMATION Nissan is issuing this Technical Service Bulletin to clarify that a change has been made for the logic that controls the Occupant Classification System (OCS) and 'passenger airbag indicator' (PABI), as described in the Owner?s Manual. This TSB applies only to vehicles using the 2-sensor OCS. Those changes are: * PABI light is ON with an empty front passenger seat. Please see this bulletin for further details.
NTB00042D2021-05-10. Service bulletin. SERVICE INFORMATION Changes or modifications to the front seat assembly trim materials may affect the proper operation of the Front Seat-Mounted Side-Impact Supplemental Air Bags and Passenger Occupant Classification Sensor and could result in serious personal injury or death. Nissan STRONGLY RECOMMENDS AGAINST making any change to seat trim materials from the factory equipped condition. This specifically applies to replacing the seat trim with non-factory materials; adding leather/cloth seat covers, seat pads, or seat storage pouches, etc. around or over the seat back and the passenger seat cushion. See this bulletin for further detail.
NTB141112021-05-10. Service bulletin. SERVICE INFORMATION The OCS (Occupant Classification System) sensors for the Applied Vehicles are now available as service parts. See this bulletin for further detail.
NTB08055C2021-05-10. Service bulletin. SERVICE INFORMATION Information necessary to service the Supplemental Restraint System (SRS) safely is included in the "RESTRAINTS" section of the Electronic Service Manual (ESM) for each vehicle. IMPORTANT: Turn the ignition switch OFF, disconnect both battery terminals, and wait at least 3 minutes before performing any service on the SRS. See this bulletin for further detail.
NTB19-071A2021-04-13. Service bulletin. DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB19-0712019-10-09. Service bulletin. DTC B00A0-00 STORED IF YOU CONFIRM DTC B00A0-00 (OCCUPANT DETECTION SENSOR UNIT) is stored And OCS zero point reset cannot be performed (continued on the next page) And The following screen displays: ACTION 1. Check the Occupant Classification System (OCS) control unit using the ODS Analysis tool software. • Refer to SERVICE PROCEDURE on page 5. HINT: “OCS” may also be referred to as “ODS”. 2. Perform “75-zero RESET”.

A bulletin is the manufacturer's note to its dealers. It is not part of this recall.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.