Transport Canada recall 2017108
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2017108 |
| Manufacturer's number | WTN-74 |
| Reported | 2017-03-02 |
| Component | Visual System |
| Notification type | Safety Mfr |
| Units potentially affected | 3251 |
What is wrong
On certain vehicles, the rear view camera image may not display properly due to a software issue within the infotainment unit. During the initial boot-up, a blank screen might occur, or if multiple processes occur at the same time, the screen might freeze. This could increase the risk of a crash causing injury and/or damage to property while reversing. Correction: Dealers will reprogram the software of the infotainment unit.
| 2017 SUBARU IMPREZA |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| Subarunet Announcement | 2025-04-01. Other. Update safety recall: WRG-22 Impreza headlamp non -compliance final phase mailing to owners. |
|---|---|
| 07-184-20R | 2021-03-04. Service bulletin. This bulletin announces a design change made to the power window main switches. |
| 15-210-17 | 2021-02-18. Service bulletin. This bulletin provides a service procedure for replacement of the A/C compressor clutch stator. |
| 15-232-18 | 2018-10-01. Service bulletin. This Service Information bulletin announces a change made to the lens portion of the fog light assembly. The new lens has optimized light distribution characteristics while remaining interchangeable with the original type. |
| 12-207-16 | 2018-04-02. Service bulletin. This bulletin announces a change to the procedure used in production of the rear door glass assembly. The bottom edge of the door glass is pressed into a metal channel lined with rubber. The channel attaches the door glass assembly to the window regulator. In below-freezing temperature conditions, water freezing in the channel combined with the door glass sticking to the door weatherstrip can increase chance of the glass separating from the channel when attempting to operate (lower) the window. A lubricant has been added to the rubber portion to insure the glass gets fully seated during assembly which maximizes the clamping force of the channel on the glass. |
| 01-174-16 | 2017-08-14. Service bulletin. This Service Information bulletin provides a guideline to use for placement of required or mandated windshield stickers (inside and / or outside) on vehicles equipped with EyeSight Driver Assist Technology and High Beam Assist (HBA) features. Examples of these types of stickers include: * Government facility / Military base access stickers * State-mandated Vehicle Safety Inspection and Emission Compliance stickers * Parking Permit Stickers The cameras used by both of these features require a clear, unobstructed "view" through the windshield for their proper operation. The illustration below shows the "Prohibited area" in gray. Any stickers mandated to be placed within the Prohibited area should be placed to the right of the EyeSight stereo camera and HBA camera, outside of the Prohibited area as shown in the illustration below. Viewed from inside the vehicle, the left edge of the sticker must be placed no more than 14 inches (slightly less is preferred as a "cushion" for measuring variation) from the right edge of the windshield as shown in the illustration and indicated by the box outlined in blue. Always consult state and local regulations applicable to windshield sticker placement. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.