WenmarOpen by Wenmar Pro

Transport Canada recall 2016603

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

Campaign
Published byTransport Canada (Canada)
Campaign number2016603
Manufacturer's number816-F
Reported2016-12-02
ComponentBrakes
Notification typeSafety Mfr
Units potentially affected184

What is wrong

On certain vehicles, the stop lamps may fail to activate due to a defective weld and incomplete circuit within the stop lamp switch. If the stop lamp switch fails during the application of the service brakes, the brake lights on the vehicle and trailer will not illuminate, thereby increasing the possibility of a crash causing injury and/or damage to property. Correction: Dealers will inspect and replace any 08-01760 stop lamp switches with a suspect date code (1056, 1026, 0821, 1386 and 1456).

Vehicles this campaign lists
2017 PETERBILT 325
2017 PETERBILT 330
2017 PETERBILT 337
2017 PETERBILT 348
2017 PETERBILT 365
2017 PETERBILT 367
2017 PETERBILT 386
2017 PETERBILT 389
2017 PETERBILT 587

A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.

Bulletins for the same vehicles and component

Bulletins for the same vehicles and component
13-0602022-09-06. Service bulletin. The service information for Bendix Air Dryer maintenance is being updated to include new procedures.
13-0542020-08-05. Service bulletin. Fix-As-Fail - Bendix New-Gen Lightweight Steer Axle Drum Brake Spider Cracking
18PBB2020-05-06. Service bulletin. Safety Recall Bulletin: Updated with permanent repair path for phase 1 vehicles. The Tractor ABS Lamp May Not Illuminate When ABS Controller Loses Battery and/or Ignition Power. NHTSA recall number is 18V368. Non compliance to FMVSS and CMVSS 121 and 136. Resolution is to Reflash software.
20 PBC2020-05-06. Service bulletin. Safety Recall Interim Bulletin: The Tractor ABS Lamp May Not Illuminate When ABS Controller Loses Battery and/or Ignition Power. NHTSA recall number is 20V199 Non compliance to FMVSS and CMVSS 121 and 136. Resolution is to Reflash software.
PB 13-0502019-10-04. Service bulletin. Information: Chassis built after 01/11/2016 with hydraulic brakes were provided with a jumper harness in the glove box or tool box that is required when programming the ABS. If this harness is no longer in the vehicle, order from PACCAR Parts.

A bulletin is the manufacturer's note to its dealers. It is not part of this recall.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.