Transport Canada recall 2016535
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2016535 |
| Manufacturer's number | S84 |
| Reported | 2016-10-28 |
| Component | Airbag |
| Notification type | Safety Mfr |
| Units potentially affected | 12 |
What is wrong
On certain vehicles, the driver’s knee airbag inflator may have been assembled with an improper weld. Failure of the airbag to fully deploy during a crash (where deployment is warranted) could increase the risk of personal injury to the seat occupant. Correction: Dealers will replace the knee airbag assembly.
| 2017 JEEP CHEROKEE |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| S1721000016 | 2023-12-18. Service bulletin. Service 4wd Light On, AWD System Service Required Message Illuminated. Diagnostic Trouble Code (DTC) C14A7-97 PTU Motor Component Or System Operation Obstructed Or Blocked, Set. |
|---|---|
| 9003807 | 2022-10-31. Service bulletin. HVAC Control, Actuator, Powertrain Control Module (PCM) MIL light for B104E Blend door circuit High (stored). The HVAC temperature door feedback voltage is monitored by the PCM. If the PCM detects a loss of voltage from the HVAC Temperature door it may set a B104E in the PCM. If B104E is set in the PCM please refer to the service manual for Fault Code: B104E. Please call George Sakr at cell (248) 613-7319. If no response in 15 minutes, proceed with repair. There are no Powertrain components that need to be changed for this condition. |
| 9003825 | 2022-09-15. Service bulletin. LATCH, Hood For the following concerns, please verify secondary plunger switch before replacing hood latch with primary switch. Please refer to service information for complete diagnostics of the secondary plunger switch which is located in the left front under hood on RU, MP, and WK/WD and left rear under hood on KL. 1) Electronic Stop Start Message on Cluster or DTC P152F without hood ajar illuminated. 2) KL Hood ajar light is on or unlatched hood due to high closing effort. (KL hood may have a higher closing effort to latch the hood as rubber bumper interference is set purposely high to prevent hood flutter at highway speeds) If stop start message or DTC P152F is present on vehicles without a hood ajar light illuminated, the issue is not related to the primary hood latch switch. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.