Transport Canada recall 2016252
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2016252 |
| Manufacturer's number | 16S24 |
| Reported | 2016-05-24 |
| Component | Brakes |
| Notification type | Safety Mfr |
| Units potentially affected | 43682 |
What is wrong
On certain vehicles, brake fluid from the master cylinder may leak into the brake booster. Depending on the volume of fluid that leaks, the driver could experience visual and audible warnings due to the low fluid level in the master cylinder. If the vehicle is operated in this condition, the driver may experience increased brake pedal travel, increased pedal effort, and extended stopping distances, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the master cylinder. The brake booster will also be replaced if there is evidence that brake fluid has leaked into the booster.
| 2013 FORD F-150 | |
|---|---|
| 2014 FORD F-150 |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| SSM 50876 | 2022-06-30. Service bulletin. Some 2013-2014 F-150 vehicles equipped with a 3.5L EcoBoost engine may require service to the brake vacuum pump. The brake vacuum pump removal and installation procedure in Workshop Manual (WSM), Section 206-07, has been updated to include RTV sealing surface cleaning and preparation. |
|---|---|
| TSB-20-2028 | 2020-03-03. Service bulletin. Some 2013-2018 F-150/Expedition/Navigator vehicles equipped with 4-wheel drive (4WD) may exhibit an intermittent grinding noise while driving in 2-wheel drive (2WD) mode most commonly on acceleration. This may be due to a loss of vacuum to the integrated wheel end (IWE) actuators and/or wear of the IWE components. To correct the condition, follow the Service Procedure steps to reprogram the transfer case control module (TCCM) and replace any worn vacuum and/or IWE components. |
| ASI-32295 | 2013-10-29. Service bulletin. FORD: ON SOME VEHICLES, DURING A PROGRAMMABLE MODULE INSTALLATION (PMI) OF ANTI LOCK BRAKE (ABS) MODULE AN IDS ERROR MESSAGE APPEARS, IF IDS SESSION STARTED WITH NEW ABS MODULE CONNECT. MODELS 2010-2013 F-150. *PE |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.