Transport Canada recall 2015179
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2015179 |
| Manufacturer's number | 15C02 |
| Reported | 2015-04-28 |
| Component | Lights And Instruments |
| Notification type | Compliance Mfr |
| Units potentially affected | 1066 |
What is wrong
Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard 108 - Lighting System and Retroreflective Devices. The parking lamps are designed to operate at a higher light intensity to provide the required Daytime Running Lights (DRL) function. When the headlamps are activated, the parking lamp light intensity does not reduce from DRL intensity to parking lamp intensity as intended. The higher light intensity may adversely affect the vision of oncoming drivers during low light and night time conditions, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will update vehicle software.
| 2015 LINCOLN MKZ |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 22R01-S1 | 2022-05-19. Service bulletin. Certain 2014 - 2015 Model Year, Fusion and MKZ and 2015 Model Year Mustang Vehicles Brake Stop Lamps Remain On - Under Safety Recall 22S02, in some of the affected vehicles, exposure to a high temperature, high humidity, and high salinity environment is causing the brake pedal “stop bumper” to disintegrate and fall off on some of the affected vehicles resulting in the brake stop lamps remaining on continuously, even when the brake pedal is not applied. If the brake pedal bumper is missing on automatic transmission vehicles, the engine can be started, and the transmission can shift out of park without depressing the brake pedal. For 22R01, owners will be instructed to request a repair under this regional program if their vehicle exhibits brake pedal concerns or if they are concerned about the brake pedals in their vehicles. |
|---|---|
| 22R01 | 2022-04-04. Service bulletin. Certain 2014-2015 Model Year, Fusion and MKZ and 2015 Model Year Mustang Vehicles - Brake Stop Lamps Remain On. Under Safety Recall 22S02, in some of the affected vehicles, exposure to a high temperature, high humidity, and high salinity environment is causing the brake pedal "stop bumper" to disintegrate and fall off on some of the affected vehicles resulting in the brake stop lamps remaining on continuously, even when the brake pedal is not applied. If the brake pedal bumper is missing on automatic transmission vehicles, the engine can be started, and the transmission can shift out of park without depressing the brake pedal. For 22R01, owners will be instructed to request a repair under this regional program if their vehicle exhibits brake pedal concerns or if they are concerned about the brake pedals in their vehicles. |
| SSM 48578 | 2020-03-03. Service bulletin. Some 2013-2016 MKZ vehicles equipped with adaptive headlamps may exhibit a Check Headlamp System fault message in the instrument panel cluster (IPC) after the right headlamp is replaced. Diagnostic trouble code (DTC) B1D65 may also be stored in the headlamp control module (HCM). To correct this condition install a new right headlamp (13008). Right headlamps built on or after 17-Oct-2019, or reworked headlamp assemblies identified with a green dot on the box and/or a green paint mark on the headlamp near the part number label, will no longer have this issue. For claiming, use Causal Part (13008) and applicable Labor Times in the Service Labor Time Standards (SLTS) Manual. |
| SSM 48263 | 2019-11-05. Service bulletin. Some 2013-2016 MKZs vehicles with Adaptive Headlamps may exhibit a Check Headlamp System fault message in the instrument panel cluster (IPC) after one or both headlamps were replaced. Diagnostic trouble codes (DTCs) B1D64 and/or B1D65 may also be stored in the headlamp control module (HCM). Confirm the headlamps illuminate normally, but do not attempt additional repairs at this time. Engineering is investigating, monitor OASIS for updates. The swivel function will remain inoperative until a corrective action becomes available. The headlamps will continue to function to fully meet all applicable lighting requirements. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.