Transport Canada recall 2014415
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2014415 |
| Reported | 2014-09-23 |
| Component | Powertrain |
| Notification type | Safety Mfr |
| Units potentially affected | 511 |
What is wrong
On certain hybrid vehicles, a defect in engine control module programming could cause a gradual throttle increase without driver input, which could cause vehicle speed to increase. This could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will update vehicle software. Note: Applying the brake would allow the vehicle to be slowed or stopped.
| 2014 INFINITI Q50 | |
|---|---|
| 2014 INFINITI Q70 | |
| 2015 INFINITI Q70 |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| ITB13-008D | 2023-04-04. Service bulletin. CLICKING NOISE FROM FRONT OR REAR AXLE DURING TAKE-OFF/ACCELERATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
|---|---|
| ITB13-008C | 2022-10-07. Service bulletin. CLICKING NOISE FROM FRONT OR REAR AXLE DURING TAKE-OFF/ACCELERATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| ITB13-008B | 2021-07-10. Service bulletin. CLICKING NOISE FROM FRONT OR REAR AXLE DURING TAKE-OFF/ACCELERATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| ITB15027 | 2021-05-10. Service bulletin. SERVICE INFORMATION If the glove box is removed for any reason (for example, installing an accessory kick plate, replacing an in-cabin microfilter, etc.), verify the trunk release power cancel switch operates normally after installing the glove box. See this bulletin for further detail. |
| ITB11011A | 2021-05-10. Service bulletin. SERVICE INFORMATION For QX60 Hybrid Vehicles, go to page 4. Q50, Q70, and M35 Hybrid Vehicles The internal combustion (IC) engine in the Q50, Q70, and M35 Hybrid vehicles is started using a high voltage motor that is integrated into the transmission. The high voltage motor gets its power from the high voltage Lithium-Ion (Li-ion) battery that is mounted between the trunk room and the rear seat. The Li-ion battery cannot be recharged using an external battery charger; therefore it is very important that the battery state of charge (SOC) is properly maintained during extended storage periods. Action must to be taken in order to prevent excessive discharge of the high voltage Li-ion battery during an extended storage period. If the reserve capacity of the Li-ion battery is not sufficient, the hybrid system cannot be started. Perform the Battery Discharge Prevention During Extended Storage procedure in this bulletin once a month (every 30 days). NOTE: A discharged high voltage Li-ion battery is not a warrantable issue. See this bulletin for further detail. |
| ITB14028A | 2021-05-10. Service bulletin. SERVICE INFORMATION The information in this bulletin is provided to help ensure correct diagnosis and repair of fluid leaks. All fluid leaks, when properly diagnosed, should be repaired (whether under warranty or customer pay) to ensure proper vehicle operation. However, certain normal operating conditions can be misdiagnosed as a leak requiring repair. Unnecessary repair or replacement of parts in connection with incorrectly diagnosed "leaks" can negatively impact customer satisfaction, be time consuming and costly, and if not performed correctly can lead to future repairs. See this bulletin for further detail. |
| ITB14051A | 2021-05-10. Service bulletin. IF YOU CONFIRM All of the following: The FCW (Forward Collision Warning) malfunction is ON or reported to have been ON, and DTC C1A27 (ECD POWER SUPPLY CIRCUIT) is stored (Past or Current), and the brake fluid level is normal. NOTE: C1A27 is an ICC (Intelligent Cruise Control) DTC. ACTION Reprogram the ABS control unit (ABS) per the Service Procedure in this bulletin. - Part of the Service Procedure, step 20 on page 8, is a confirmation that reprogramming is needed to resolve the incident shown in Figure A and B on page 1. See this bulletin for further detail. |
| ITB15007 | 2021-05-10. Service bulletin. IF YOU CONFIRM A power window auto-up does not work for one or more power windows. ACTION Replace the left front (driver) door finisher with the new one listed in the Parts Information. While replacing the door finisher, also replace the main power window switch. See this bulletin for further detail. |
| ITB14055 | 2021-05-10. Service bulletin. SERVICE INFORMATION If a customer describes lack of power or poor acceleration, perform the following checks before attempting any repair: * Check for stored DTCs. * Check if the driver is resting their left foot on the brake pedal while accelerating. Advise the customer not to rest their foot on the brake while accelerating. * Use CONSULT-III plus in Engine Data Monitor to check operation of the brake lamp circuit signal. Monitor the brake switch during the incident; it should be "OFF". Please see this bulletn for further details. |
| ITB14029 | 2021-05-10. Service bulletin. IF YOU CONFIRM Using chassis ear, a rattle noise coming from the rear propeller shaft center bearing under the following conditions - Light to moderate acceleration, and between 2,000 and 2,800 rpm. ACTION Replace the rear propeller shaft with the new one (new style) listed in the Parts Information of this bulletin. See this bulletin for further detail. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.