Transport Canada recall 2014397
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2014397 |
| Manufacturer's number | SR14-009 |
| Reported | 2014-09-15 |
| Component | Engine |
| Notification type | Safety Mfr |
| Units potentially affected | 49227 |
What is wrong
On certain vehicles, the drive belt material may cause abnormal pulley wear. If the vehicle is driven under this condition, the drive belt may become damaged from the worn pulley and detach, affecting electrical charging system and cooling system function and would illuminate the engine warning lamp(s) on the instrument panel. This could result in battery depletion and an overheated engine, resulting in a loss of motive power. Vehicles equipped with a hydraulic power steering system could also experience loss of power steering assist. These issues could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the drive belt, and the pulley will be replaced if it is found worn beyond a certain level.
| 2008 MITSUBISHI LANCER | |
|---|---|
| 2009 MITSUBISHI LANCER | |
| 2010 MITSUBISHI LANCER | |
| 2011 MITSUBISHI LANCER | |
| 2008 MITSUBISHI LANCER EVOLUTION | |
| 2009 MITSUBISHI LANCER EVOLUTION | |
| 2010 MITSUBISHI LANCER EVOLUTION | |
| 2011 MITSUBISHI LANCER EVOLUTION | |
| 2008 MITSUBISHI LANCER RALLIART | Listed as a series or trim of this model. |
| 2009 MITSUBISHI LANCER RALLIART | Listed as a series or trim of this model. |
| 2010 MITSUBISHI LANCER RALLIART | Listed as a series or trim of this model. |
| 2011 MITSUBISHI LANCER RALLIART | Listed as a series or trim of this model. |
| 2009 MITSUBISHI LANCER SPORTBACK | |
| 2010 MITSUBISHI LANCER SPORTBACK | |
| 2011 MITSUBISHI LANCER SPORTBACK | |
| 2008 MITSUBISHI OUTLANDER | |
| 2009 MITSUBISHI OUTLANDER | |
| 2010 MITSUBISHI OUTLANDER | |
| 2011 MITSUBISHI OUTLANDER | |
| 2011 MITSUBISHI RVR |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| TSB-24-11-002 | 2024-07-05. Service bulletin. Service Manual Revision - This Technical Service Bulletin provides additions to the description of special tools used for removal of the drive belt within the Engine Mechanical (3.0L Engine) section of the applicable Service Manuals. |
|---|---|
| TSB-11-66-001REV | 2023-04-07. Service bulletin. This Technical Service Bulletin contains technical information and troubleshooting for the accessory Remote Engine Start system for affected vehicles. |
| TIN-23-66-001 | 2023-04-07. Service bulletin. This is a Technical Information Notice informing dealers and parts managers about possible causes after a customer complains that the engine will not start while using the remote start system. |
| TSB-23-11-001 | 2023-02-07. Service bulletin. This TSB provides revisions to the Removal and Installation procedures for the rocker cover due to changes in the quantity of mounting bolts for vehicles equipped with 4B1 series engine. (Service Manual Revision) |
| TIN-21-13-001 | 2021-05-08. Service bulletin. This Technical Information Notice provides additional instructions to dealers when replacing the Valve Cover Gasket due to a customer concern of oil leaking. |
| TIN-20-SR-003 | 2020-09-14. Service bulletin. This Technical Information Notice was sent to dealers informing that a recall campaign was released on July 22, 2020 (SR-20-003) for the Crossmember Corrosion. |
| ATIN-20-SR-003-B | 2020-07-20. Service bulletin. This Advanced Technical Information Notice was sent to dealers informing them of the upcoming recall being released for the inside and outside surfaces of the front cross members used on certain vehicles, if exposed long term to snow melt water and anti-freezing agents, may corrode due to insufficient performance of the rust protection. |
| TSB-13-13-009 | 2020-04-24. Service bulletin. In cold weather, false MIL illumination may occur on some affected vehicles during turbocharger operation below 3,000 rpm engine speed, due to improper intake air volume judgement parameter. DTCs P1235 (2008-2010 vehicles) or P0068 (2011-2014 vehicles) - Boost/Air Flow Sensor Plausibility may be stored in the ECM. This TSB provides field fix procedures to reprogram the ECM with new software to address false MIL illumination with boost/air flow plausibility monitor DTCs P1235 (2008-2010 models) or P0068 (2011-2014 models) stored in memory. |
| TSB-13-11-004 | 2020-04-04. Service bulletin. The timing chain upper guide was eliminated from certain vehicles beginning October 1, 2009 with 4B11 (Non-turbo or Turbo-charged) and 4B12 engines. This TSB provides updated service manual information. |
| TSB-13-13-005 | 2020-03-18. Service bulletin. Some affected vehicles may display an illuminated Malfunction Indicator Lamp or be hard to start after being parked during sub−freezing weather. Nearby residual EGR gas freezes the Electronic Throttle Valve (ETV) at cold ambient temperatures (approximately 23 F / -5 C). The frozen throttle valve causes MIL illumination for P2100 detection. This TSB provides field fix information on hard-to-start engine conditions or DTC P2100 detection (P2100: Disconnection on throttle valve control servo circuit). New ECM software modifies the EGR intake air activation temperature to avoid freezing the ETV and false P2100 detection. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.