WenmarOpen by Wenmar Pro

Transport Canada recall 2013434

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

Campaign
Published byTransport Canada (Canada)
Campaign number2013434
Manufacturer's numberN65
Reported2013-12-06
ComponentPowertrain
Notification typeSafety Mfr
Units potentially affected1424

What is wrong

On certain Dodge Charger, Chrysler 300 all-wheel drive vehicles and RAM 1500 four wheel drive vehicles equipped with 8 speed automatic transmissions, the transmission output shaft could fail. If this were to occur while the vehicle is being driven, it could result in a loss of motive power. If this were to occur while the vehicle is parked without the parking brake applied, it could result in unintended vehicle movement. Both situations could increase the risk of a crash causing injury and/or property damage. Correction: Dealers will replace the transmission in affected vehicles.

Vehicles this campaign lists
2013 CHRYSLER 300
2013 DODGE CHARGER
2013 RAM 1500

A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.

Bulletins for the same vehicles and component

Bulletins for the same vehicles and component
S2621000003 REV.A2026-03-18. Service bulletin. The vehicle will exhibit a service transmission/check engine warning indicator for the following transmission models: 845RE, 8HP45, 850RE, 8HP50, 8HP70, 8HP75, 8HP75-PHEV, 8HP75-LCV, 8HP90, 8HP95. Transmissions may exhibit the following diagnostic codes: P07E4, P1DB2, P0716, P1B14, P0733, P1D90, P1DB7, P1B13.
1012322024-11-07. Service bulletin. Plate - Planetary
18001142023-02-21. Service bulletin. Powertrain Diagnostic And System Enhancements
S1623000028 Rev.2023-02-13. Service bulletin. Outside Power Fold Rearview Mirror Noise Or Loose At Pivot. Mirror Contacts Door Window Glass In The Folded Position.
18012142023-01-17. Service bulletin. (PCM) with new software
18077142023-01-17. Service bulletin. Flash: 3.6L Diagnostic And System Improvements This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the Technician may find one of the following Diagnostic Trouble Code has been set: P0607 - ECU Internal Performance P2096 - Downstream Fuel Trim System 1 Lean. P2097 - Downstream Fuel Trim System 1 Rich. P2098 - Downstream Fuel Trim System 2 Lean. P2099 - Downstream Fuel Trim System 2 Rich. Scan tool improved accuracy on mode 6, cylinder imbalance.
18050142023-01-17. Service bulletin. Flash: Drone or Vibration Present During MDS Operation This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. New PCM software is being released to address a customer?s concern of a drone or vibration type condition while driving at highway speeds during MDS (Multiple Displacement System) operation.In addition, the following powertrain system improvements/enhancements are also included in this software release: Improved Electronic Voltage Regulator control to more precisely maintain system voltage. Enhanced Automatic Oil Change Indicator(EAOCI) system improvements to switch to a severe duty cycle algorithm anytime the PCM is replaced to ensure the customer receives a timely oil change required message. (Only applies to vehicles using a block heater in ambient temperatures greater than -20°F(-29°C)).
21012142023-01-17. Service bulletin. Transmission Shift Enhancements - Adaptation Drive Learn Procedure
90037042023-01-09. Service bulletin. Transmission Oil Pan, Heater (TMU), Tube or O-ring Applies to vehicles equipped with 8 speed transmissions only; if you have a leak that appears to be at the pan the use of proper leak detection is recommended. The fluid in the 8 speeds can be detected with a black light and there are aftermarket spray on leak detection materials to help ensure that the leak is properly diagnosed and not from another location such as cooler lines, heater tubes, or case porosity. Please note that the transmission pan gasket is available for many of the 8 speed applications FCA offers. Please review the available quick connect and transfer tube parts, as replacement of the TMU may not be required. If a TOC line connection is found to be the source, the quick connect may need replacement. If the leak source is coming from the connection of the TMU to the transmission, the transfer tube may need replacement. When parts are returned to the QEC the retaining clips (snap ring) for the quick disconnect fittings are missing. (This leaves a question as to whether the clips were missing from the assembly plant, or the technician removed them in order to make line removal easier.) Please return the clips with the transmission heater and note if they were not there to begin with. For any questions regarding transmission heater, contact FCA Redacted Content. If no response in 15 minutes, proceed with repair.
S17090000102023-01-09. Service bulletin. Customer complaints may include abnormal engine noise, rough idle, lack of power, misfire. Upon investigation, it may be found that there is excessive camshaft lobe wear/lifter wear (roller failure) on one or more cam lobes and that camshaft/lifter replacement is necessary.

A bulletin is the manufacturer's note to its dealers. It is not part of this recall.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.