Transport Canada recall 2011431
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2011431 |
| Manufacturer's number | R183 / R1114 |
| Reported | 2011-12-12 |
| Component | Engine |
| Notification type | Safety Mfr |
| Units potentially affected | 2900 |
What is wrong
On certain vehicles, a weld at the boost sensor bracket may fail, allowing the bracket to separate from the air inlet tube. If this occurred, the engine would enter fail-safe driving mode, resulting in reduced motive power in which the vehicle could still be driven for short distances. Continued operation could cause the engine to stall which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the air inlet tube assembly.
| 2011 NISSAN JUKE |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| NTB17-082E | 2022-03-12. Service bulletin. DTC P0456 CAUSED BY EVAP LEAK AT VENT CONTROL VALVE O-RING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
|---|---|
| NTB13-027C | 2022-03-12. Service bulletin. CAN COMMUNICATION – NETWORK DIAGNOSTIC FLOW CHART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| NTB14030D | 2021-05-10. Service bulletin. INTRODUCTION Nissan is conducting this Voluntary Service Campaign to replace the engine timing chain on certain specific 2011- 2013 Juke vehicles. This service will be performed at no charge for parts or labor. IDENTIFICATION NUMBER Nissan has assigned identification number P4213 to this campaign. This number must appear on all communications and documentation of any nature dealing with this campaign. See this bulletin for further detail. |
| NTB15055 | 2021-05-10. Service bulletin. SERVICE INFORMATION After ECM reprogramming, the Calibration Verification Number (CVN) needs to be automatically calculated prior to State emissions testing (also known as Inspection Maintainence, I/M, or SMOG testing depending upon location). Allowing the vehicle to idle for 22 minutes will allow for faster CVN calculation. It is recommended that customers utilize this method if the vehicle needs to be tested for emissions soon after ECM reprogramming. See this bulletin for further detail. |
| NTB14109 | 2021-05-10. Service bulletin. SERVICE INFORMATION Starting with 2010 Model Year, Nissan vehicles have been gradually incorporating a new type of DTC known as Permanent DTC or P-DTC. If a vehicle is equipped with P-DTCs, all emission related DTCs will also set a P-DTC if the MIL is turned ON. A listing of which DTCs that will also set a P-DTC is found in the DTC Index in the EC-Engine Control section of the Electronic Service Manual (ESM). If a DTC repair is performed and the DTC erased, a vehicle may fail an Emission Inspection and Maintenance test if the P-DTC is not also erased. See this bulletin for further detail. |
| P4213D | 2021-05-10. Service bulletin. We were temporarily using an alternate part (13094-31U00) as a substitute to fill VOR & CSC part backorders. |
| P4213C | 2021-05-10. Service bulletin. Due to the damage of the Slack Guide Bolt (13094-EN200) during the removal procedure and the unforeseen part demand for the campaign, the slack guide bolt has been on backorder the last two weeks. Nissan will use part 13094-31U00 (Slack Guide Bolt-Alternative) as a temporary alternative to fill all VOR and CSC part backorders, which will arrive by Friday, 5/23 via FedEx. |
| P4213B | 2021-05-10. Service bulletin. Nissan recently learned that a bolt that is removed (and reused) in the campaign procedure can be stripped if using a power tool, rendering it unusable. This has created a flow of dealer orders and a backorder situation for part 13094-EN200. |
| P4213OL | 2021-05-10. Service bulletin. Nissan is conducting this Voluntary Service Campaign to replace the engine timing chain on certain specific 2011 ? 2013 Juke vehicles. |
| P4213 | 2021-05-10. Service bulletin. Nissan is conducting this Voluntary Service Campaign to replace the engine timing chain on certain specific 2011 ? 2013 Juke vehicles. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.