WenmarOpen by Wenmar Pro

Transport Canada recall 2010235

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

Campaign
Published byTransport Canada (Canada)
Campaign number2010235
Manufacturer's numberP120
Reported2010-07-16
ComponentAirbag
Notification typeService Campaign Mfr
Units potentially affected779

What is wrong

On certain vehicles, the passenger-side curtain airbag may have been incorrectly positioned during vehicle assembly. As a result, in certain types of crashes where side curtain airbag deployment is expected, a portion of the bag may be restricted from fully deploying. The side curtain airbag will still deploy in a timely manner, meeting or exceeding applicable safety standards. Correction: Dealers will replace the side curtain airbag. This action is a Customer Satisfaction Campaign and is not being conducted as per the requirements of the Motor Vehicle Safety Act.

Vehicles this campaign lists
2009 NISSAN CUBE
2010 NISSAN CUBE

A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.

Bulletins for the same vehicles and component

Bulletins for the same vehicles and component
NTB10-073B2026-05-30. Service campaign. VOLUNTARY SERVICE CAMPAIGN 2009-2010 CUBE; PASSENGER SIDE CURTAIN AIR BAG CAMPAIGN ID # P0335 is no longer active. · Repair orders opened after this bulletin’s published date are no longer eligible for reimbursement under Campaign ID # P0335. · Discard all previous versions of NTB10-073.
NTB19-071D2024-10-22. Service bulletin. DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. IF YOU CONFIRM DTC B00A0-00 (OCCUPANT DETECTION SENSOR UNIT) is stored, AND OCS zero point reset cannot be performed, (continued on the next page)
NTB19-071C2023-04-10. Service bulletin. DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB19-071B2022-06-03. Service bulletin. DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB00042D2021-05-10. Service bulletin. SERVICE INFORMATION Changes or modifications to the front seat assembly trim materials may affect the proper operation of the Front Seat-Mounted Side-Impact Supplemental Air Bags and Passenger Occupant Classification Sensor and could result in serious personal injury or death. Nissan STRONGLY RECOMMENDS AGAINST making any change to seat trim materials from the factory equipped condition. This specifically applies to replacing the seat trim with non-factory materials; adding leather/cloth seat covers, seat pads, or seat storage pouches, etc. around or over the seat back and the passenger seat cushion. See this bulletin for further detail.
NTB08055C2021-05-10. Service bulletin. SERVICE INFORMATION Information necessary to service the Supplemental Restraint System (SRS) safely is included in the "RESTRAINTS" section of the Electronic Service Manual (ESM) for each vehicle. IMPORTANT: Turn the ignition switch OFF, disconnect both battery terminals, and wait at least 3 minutes before performing any service on the SRS. See this bulletin for further detail.
NTB130552021-05-10. Service bulletin. IF YOU CONFIRM One or more of the following conditions: Front passenger air bag status light is ON (illuminated) with the front passenger seat empty. Front passenger air bag status light is ON (illuminated) with an adult sitting in the front passenger seat. Seat belt warning light is ON (illuminated) with the front passenger seat empty (driver seat belt is buckled). Supplemental air bag warning light is flashing but no Air Bag DTCs are stored. ACTION 1. Visually check the front passenger seat and seat rails for any structural damage. 2. Visually check the front passenger seat for any items in the seat pockets, or any items on, under, or hanging from the seat (front, back, and sides). 3. Replace the OCS control unit. 4. Perform Zero Point Rest and check for DTCs. See this bulletin for further detail.
NTB19-071A2021-04-13. Service bulletin. DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB19-0712019-10-09. Service bulletin. DTC B00A0-00 STORED IF YOU CONFIRM DTC B00A0-00 (OCCUPANT DETECTION SENSOR UNIT) is stored And OCS zero point reset cannot be performed (continued on the next page) And The following screen displays: ACTION 1. Check the Occupant Classification System (OCS) control unit using the ODS Analysis tool software. • Refer to SERVICE PROCEDURE on page 5. HINT: “OCS” may also be referred to as “ODS”. 2. Perform “75-zero RESET”.
NTB18-053a2019-10-08. Service bulletin. TAKATA INFLATOR FIELD QUALITY PARTS COLLECTION INITIATIVE 2009-2010 CUBE Field Quality Parts Collection Initiative ID # P8309 and P8310 are No Longer Active. • Repair orders opened after September 6, 2019 are no longer eligible for reimbursement under Initiative ID # P8309 and P8310. • Please discard previous versions of NTB18-053.

A bulletin is the manufacturer's note to its dealers. It is not part of this recall.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.