Transport Canada recall 2004045
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2004045 |
| Manufacturer's number | 04005 |
| Reported | 2004-02-04 |
| Component | Electrical |
| Notification type | Safety Mfr |
| Units potentially affected | 28986 |
What is wrong
On certain vehicles, water may seep into the windshield wiper module. If this were to happen, it could result in windshield wipers that will not turn on, cease operation while driving, fail to turn off, turn on by themselves, and/or continuous windshield washer pump operation. Improper operation of the windshield wiper system in a severe weather situation could reduce the driver's visibility, resulting in a possible vehicle crash without prior warning. Correction: Dealer will install a Gore-Tex patch over the windshield wiper module vent-hole. The wiper motor, circuit board, and electrical connector will be inspected for signs of water intrusion and/or corrosion and replaced as required.
| 2002 CHEVROLET TRAILBLAZER | |
|---|---|
| 2003 CHEVROLET TRAILBLAZER | |
| 2002 CHEVROLET TRAILBLAZER EXT | Listed as a series or trim of this model. |
| 2003 CHEVROLET TRAILBLAZER EXT | Listed as a series or trim of this model. |
| 2002 GMC ENVOY | |
| 2003 GMC ENVOY | |
| 2002 GMC ENVOY XL | Listed as a series or trim of this model. |
| 2003 GMC ENVOY XL | Listed as a series or trim of this model. |
| 2002 ISUZU ASCENDER | |
| 2003 ISUZU ASCENDER | |
| 2002 OLDSMOBILE BRAVADA | |
| 2003 OLDSMOBILE BRAVADA |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| PIP4723J | 2024-10-25. Service bulletin. This Preliminary Information communicates to the dealer the process for downloading or updating operating software for the Tire Pressure Monitor, Active Fuel Injector tester, multi media tester, PICO Scope, GR8 starting/charging tester and Vehicle Data Recorder tools, giving website address and step by step instructions to complete the update. |
|---|---|
| General Communication | 2024-08-26. Service campaign. Vehicle Wide Programming (VWP) is a new process to update software on GM Vehicles. It provides the ability via a single selection within Techline Connect to first identify which modules need updating and then proceed to updating affected modules (with some exceptions). The updating of modules is completed in parallel instead of the technician needing to update one module at a time. This allows a more streamlined approach for dealers and customers. |
| 24-NA-098 | 2024-06-25. Service bulletin. This service bulletin provides information for dealers/technicians on Service Programming System (SPS) Error Codes E4398, E4399, E4401, E4403, M4404, M4413, M6954, M6955, E4414, E4423, E4491, E4492, or E6961 and resolution information. |
| 10-08-45-001H | 2024-04-05. Service bulletin. This bulletin provides information for electrical ground repairs using new General Motors replacement fasteners with conductive finish. |
| 07-08-49-020R | 2023-10-18. Service bulletin. This informational bulletin provides information for the IPC odometer programming method quick reference guide. |
| 22-NA-205 | 2022-11-02. Service bulletin. This service bulletin provides information on Module Harvesting. |
| 21NA124 | 2021-07-06. Service bulletin. This service bulletin provides diagnostic tips/steps on testing for possible EVAP leaks in the system to correct a customer concern of an MIL Illuminated with DTCs P0442 and/or P0455 Set. |
| 15-NA-079 | 2021-04-20. Service bulletin. OnStar® Voice Fallback Number Update Some customers may have received a letter from OnStar® stating that "We recently tried to provide a software update to the OnStar® hardware in your vehicle. However, your system could not be updated remotely. As a result, some of your OnStar® system functions may not be working as expected." The customer is further instructed in this letter to "Please contact your dealer – or any dealer near you – as soon as possible to schedule an appointment for this no-cost software update. Your dealer will reprogram your OnStar® module with an update. This is for vehicles that have previously received the Canada upgrade as described in Service Bulletin #15-08-44-001F." |
| 07-08-49-020J | 2021-04-20. Service bulletin. IPC Odometer Programming Method Quick Reference Guide Season Odometer Programming Methods in Use Today 1. IPC reprogramming and setup using the service programming system (SPS). 2. Odometer setup at the electronic service center (ESC) when using an exchange IPC/DIC. 3. Tech 2® – The Tech 2 is used to set up a replacement BCM, which includes loading the odometer value that is displayed and stored in the IPC. A replacement IPC will display the previously stored vehicle odometer value, communicated from the BCM, after cycling the ignition or driving the vehicle. *The odometer programming is integrated as part of the BCM programming procedure. It is not a stand-alone event. |
| 070849020M | 2021-04-16. Service bulletin. IPC Odometer Programming Method Quick Reference Guide |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.