WenmarOpen by Wenmar Pro

Transport Canada recall 2001263

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

Campaign
Published byTransport Canada (Canada)
Campaign number2001263
Manufacturer's number01066
Reported2001-11-01
ComponentElectrical
Notification typeSafety Mfr
Units potentially affected63484

What is wrong

Certain vehicles: Light duty trucks. passenger vehicles and sport utility vehicles. Certain vehicles do not comply with the requirements of C.M.V.S.S. NO. 118, "POWER-OPERATED WINDOW, PARTITION & ROOF PANEL SYSTEMS." When the hazard flasher switch is used to turn the hazard flashers on or off, the retained accessory power (RAP) feature can be activated without a key in the ignition. Correction: There is no detrimental effect on vehicle safety so no corrective action is necessary.

Vehicles this campaign lists
1999 CADILLAC ESCALADE
1998 CHEVROLET BLAZER
1999 CHEVROLET BLAZER
1998 CHEVROLET S10
1999 CHEVROLET S10
1999 CHEVROLET SILVERADO
1998 GMC JIMMY
1999 GMC JIMMY
1999 GMC SIERRA
1998 GMC SONOMA
1999 GMC SONOMA
1999 GMC YUKON
1998 OLDSMOBILE BRAVADA
1999 OLDSMOBILE BRAVADA

A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.

Bulletins for the same vehicles and component

Bulletins for the same vehicles and component
PIT3665M2023-06-13. Service bulletin. This Preliminary Information communication advises the technician that the Hydro-Boost is not serviceable and will need to be replaced if the brake pedal moves or applies on its own at a full turn.
N202307080 012021-06-14. Service bulletin. Service Update Bulletin (Labor Codes Added). Certain vehicles may have a condition where the engine control module (ECM) software allows the Auto Stop to occur at a state of charge below 65%. Auto Stop is supposed to be inhibited at 65% to protect against excessive battery wear and discharge. Dealers are to reprogram the ECM.
PIP4723D2020-02-10. Service bulletin. This Preliminary Information communicates to the dealer the process for downloading or updating operating software for the Tire Pressure Monitor, Active Fuel Injector tester, multi media tester, PICO Scope, GR8 starting/charging tester and Vehicle Data Recorder tools, giving website address and step by step instructions to complete the update.
PIT5669A2019-06-03. Service bulletin. This Preliminary information communicates the need to contact SPAC until GM CCA has sufficient stock.
PIT56692019-06-03. Service bulletin. This Preliminary information communicates the need to contact SPAC until GM CCA has sufficient stock.
PIP4723C2019-04-08. Service bulletin. This Preliminary Information communicates to the dealer the process for downloading or updating operating software for the Tire Pressure Monitor, Active Fuel Injector tester, multi media tester, PICO Scope, GR8 starting/charging tester and Vehicle Data Recorder tools, giving website address and step by step instructions to complete the update.
PIP4723B2017-08-15. Service bulletin. This Preliminary Information communicates to the dealer the process for downloading or updating operating software for the Tire Pressure Monitor, Active Fuel Injector tester, multi media tester, PICO Scope, GR8 starting/charging tester and Vehicle Data Recorder tools, giving website address and step by step instructions to complete the update.
PIC59132017-08-15. Service bulletin. This Preliminary Information communication provides information to the technician about vehicles that have a Supplemental Inflatable Restraint lamp, Service Vehicle Soon lamp on and/or radio locked, possibly after module replacement. Technician will need to check for an incorrect or non-existent VIN number in modules that require them. Technician should ensure that all modules that are replaced are programmed per currently published Service Information. Technician should also check the Sensing and Diagnostic Module part number if it was replaced.
PIP4138N2017-08-15. Service bulletin. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp on, engine misfire, and/or engine noise. Technician may find Diagnostic Trouble Codes P0300-P0308. If published Service Information diagnostics does not isolate the cause of this concern technician should check for a worn camshaft lobe and/or lifter roller, a sticking valve, valve leakage, a broken valve spring, and a collapsed active fuel management lifter.
PIP50722017-08-15. Service bulletin. This Preliminary Information communication provides information to the technician about vehicles that have slip in forward ranges immediately after replacing the input housing. Technician will inspect the 3-4 clutches and the forward clutch oil feed passages for leakage between circuits. Technician should apply regulated compressed air to the 3-4 clutch feed hole and the forward clutch feed hole one at a time with the input housing. Technician will need to replace the input housing if there is an air leak 3-4 clutches.

A bulletin is the manufacturer's note to its dealers. It is not part of this recall.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.