Transport Canada recall 2001092
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2001092 |
| Manufacturer's number | 01001 |
| Reported | 2001-04-12 |
| Component | Electrical |
| Notification type | Safety Mfr |
| Units potentially affected | 22 |
What is wrong
On certain Yukon Denali and Yukon XL Denali vehicles, the positive battery cable assembly that could come in contact with the steering shaft universal joint. This could eventually cause a wear through of the cable assembly convoluted conduit and cable insulation and result in intermittent electrical shorting. This could result in overheating and igniting of the cable insulation and conduit and a possible underhood fire. Correction: Dealers will inspect the positive battery cable for proper routing and reroute if necessary. Cable will also be inspected for wear of the conduit and cable insulation, and replaced if necessary.
| 2001 GMC YUKON | |
|---|---|
| 2001 GMC YUKON XL |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| PIP4723J | 2024-10-25. Service bulletin. This Preliminary Information communicates to the dealer the process for downloading or updating operating software for the Tire Pressure Monitor, Active Fuel Injector tester, multi media tester, PICO Scope, GR8 starting/charging tester and Vehicle Data Recorder tools, giving website address and step by step instructions to complete the update. |
|---|---|
| General Communication | 2024-08-26. Service campaign. Vehicle Wide Programming (VWP) is a new process to update software on GM Vehicles. It provides the ability via a single selection within Techline Connect to first identify which modules need updating and then proceed to updating affected modules (with some exceptions). The updating of modules is completed in parallel instead of the technician needing to update one module at a time. This allows a more streamlined approach for dealers and customers. |
| 24-NA-098 | 2024-06-25. Service bulletin. This service bulletin provides information for dealers/technicians on Service Programming System (SPS) Error Codes E4398, E4399, E4401, E4403, M4404, M4413, M6954, M6955, E4414, E4423, E4491, E4492, or E6961 and resolution information. |
| PIT3665M | 2023-06-13. Service bulletin. This Preliminary Information communication advises the technician that the Hydro-Boost is not serviceable and will need to be replaced if the brake pedal moves or applies on its own at a full turn. |
| 22-NA-205 | 2022-11-02. Service bulletin. This service bulletin provides information on Module Harvesting. |
| 21NA124 | 2021-07-06. Service bulletin. This service bulletin provides diagnostic tips/steps on testing for possible EVAP leaks in the system to correct a customer concern of an MIL Illuminated with DTCs P0442 and/or P0455 Set. |
| N202307080 01 | 2021-06-14. Service bulletin. Service Update Bulletin (Labor Codes Added). Certain vehicles may have a condition where the engine control module (ECM) software allows the Auto Stop to occur at a state of charge below 65%. Auto Stop is supposed to be inhibited at 65% to protect against excessive battery wear and discharge. Dealers are to reprogram the ECM. |
| 15-NA-079 | 2021-04-20. Service bulletin. OnStar® Voice Fallback Number Update Some customers may have received a letter from OnStar® stating that "We recently tried to provide a software update to the OnStar® hardware in your vehicle. However, your system could not be updated remotely. As a result, some of your OnStar® system functions may not be working as expected." The customer is further instructed in this letter to "Please contact your dealer – or any dealer near you – as soon as possible to schedule an appointment for this no-cost software update. Your dealer will reprogram your OnStar® module with an update. This is for vehicles that have previously received the Canada upgrade as described in Service Bulletin #15-08-44-001F." |
| PIT4093B | 2020-04-13. Service bulletin. This Preliminary information communicates information to dealership on how to clear a B1001 DTC after replacing the BCM or SDM. |
| PIP4723D | 2020-02-10. Service bulletin. This Preliminary Information communicates to the dealer the process for downloading or updating operating software for the Tire Pressure Monitor, Active Fuel Injector tester, multi media tester, PICO Scope, GR8 starting/charging tester and Vehicle Data Recorder tools, giving website address and step by step instructions to complete the update. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.