Transport Canada recall 1999030
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 1999030 |
| Manufacturer's number | R-50 |
| Reported | 1999-03-02 |
| Component | Powertrain |
| Notification type | Compliance Mfr |
| Units potentially affected | 316 |
What is wrong
Duplicate recall, see original 1998174. Certain vehicles do not comply with the requirements of CMVSS 114 - Locking System. There is the possibility that the ignition key can be removed at times when the engine is turned off without placing the transmission shift lever in the "Park" position. If this were to occur, and the driver failed to move the shift lever to "Park" after removing the key and failed to engage the parking brake before exiting the vehicle, the vehicle could roll away. Correction: Shift lock control unit will be replaced.
| 1997 INFINITI Q45 | |
|---|---|
| 1998 INFINITI Q45 |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| ITB18-034 | 2018-12-03. Service bulletin. TRANSMISSION & ENGINE AUTOMATED DATA COLLECTION AND DIAGNOSTIC REPORTING SERVICE INFORMATION To support proper diagnosis and to promote Fixed-Right-First-Time ? Infiniti may review CONSULT-III plus (CIII plus) data relating to vehicle operation and function to help with vehicle diagnosis and diagnostic validation. IMPORTANT: For transmission/engine repair or replacement, retailers are required to connect C-III plus and perform ?Diagnosis (All Systems)?. Performing C-III plus ?Diagnosis (All Systems)? is also required prior to contacting any Infiniti call center (i.e. TECH-LINE, PCC, or WCC) for diagnostic support or claim preauthorization. NOTE: For additional information regarding Automated Vehicle Data Collection, refer to IWBI/18-019. To support Automated Vehicle Data Collection, your C-III plus must have the Diagnosis result reporting function-Setting turned ON. If Diagnosis result reporting function-Setting is OFF: - It may cause dealer consideration for Audit or the Anomalous Repair Control (ARC) program, where applicable. - It may result in a repair being non-warrantable. Refer to the Service Procedure on the next page to confirm your C-III plus ?Diagnosis result reporting function-Setting? is turned ON. |
|---|---|
| ITB99045 | 1999-10-19. Service bulletin. SOME VEHICLES WITH AUTOMATIC TRANSMISSIONS MAY EXPERIENCE A DOUBLE THUMP WHEN STOPPING. *TT |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.