Transport Canada recall 1994138
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 1994138 |
| Manufacturer's number | 56407 |
| Reported | 1994-08-30 |
| Component | Electrical |
| Notification type | Safety TC |
| Units potentially affected | 7430 |
What is wrong
NOTE: VEHICLES EQUIPPED WITH V6 ENGINES.
WATER AND ROAD SALT CAN ENTER THE ALTERNATOR THROUGH A PRODUCTION PIN HOLE IN THE BUS BAR POSSIBLY CREATING AN ELECTRICAL SHORT CIRCUIT BETWEEN THE BUS BAR AND THE ALTERNATOR HEAT SHIELD. THIS CONDITION COULD CAUSE OVERHEATING AND RESULT IN AN ENGINE COMPARTMENT FIRE.
CORRECTION: VEHICLES WILL BE INSPECTED AND A MODIFIED HEAT SHIELD WILL BE INSTALLED IF THE VEHICLE WAS OPERATED IN AREAS OF HIGH ROAD SALT USE.
| 1992 MAZDA MX-3 | |
|---|---|
| 1993 MAZDA MX-3 | |
| 1994 MAZDA MX-3 |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 0900716 | 2022-06-06. Service bulletin. Speedometer replacement procedure |
|---|---|
| MT-002-22 | 2022-03-04. Service bulletin. Radio Unlocking Codes. |
| 09-009-19-3566 | 2019-02-19. Service bulletin. In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer's responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the "Speedometer Replacement Label". Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazda's vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMO's services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after-warranty assistance (AWA) or DSA that can be utilized to cover this service expense. |
| 09-035-17-3080 | 2017-10-04. Service bulletin. In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealer?s responsibility to comply with Federal, State, and local laws concerning odometerand related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the ?SpeedometerReplacement Label?.Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazda?s vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service.With the use of SPECMO?s services, a Mazda dealer can get the odometer setting updated to reflect the correct mileage at the time of replacement for both warranty and customer pay repairs, therefore resulting in a higher level of customer satisfaction. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this service expense. |
| 0102504 | 2004-09-29. Service bulletin. BATTERY TEST PROCEDURE REQUIREMENTS. *TT |
| 001/97G | 1997-08-14. Service bulletin. MAINTENANCE FREE BATTERY - DIAGNOSTIC AND CHARGING PROCEDURE. *TW |
| 003/97G | 1997-08-14. Service bulletin. WIPER MOTOR INOPERATIVE - CIRCUIT BREAKER ACTIVATION. *TW |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.