NHTSA recall 16V114000
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | NHTSA (United States) |
|---|---|
| Campaign number | 16V114000 |
| Manufacturer's number | S09 |
| Manufacturer | Chrysler (FCA US LLC) |
| Reported | 2016-02-26 |
| Owners notified | 2016-05-27 |
| Component | AIR BAGS:SENSOR:OCCUPANT CLASSIFICATION; SEATS |
| Units potentially affected | 71 |
| Report | Quarterly report 6, for 2017 quarter 3 |
|---|---|
| Filed with NHTSA | 2017-10-20 |
| Vehicles in the campaign | 71 |
| Reported remedied | 49 (69%) |
| Reported unreachable | 5 |
| Reported removed | 0 |
These are the manufacturer's totals for the whole campaign at the end of 2017 quarter 3, as filed with NHTSA. They do not say whether one vehicle has been remedied: check the VIN with the official lookups. The reports are from data as of 2026-10-19.
What is wrong
Chrysler (FCA US LLC) is recalling certain model year 2015 Chrysler 200 vehicles manufactured April 7, 2014, to August 3, 2015. During service work, the affected vehicles may have had either the Occupant Classification Module (OCM) or the Seat Cushion Foam (SCF) of the front passenger seat replaced instead of the both pieces together, which make up a complete calibrated set.
What can happen
If both pieces were not replaced together, the occupant detection and classification system may not be properly calibrated and the passenger air bag may improperly deploy in the event of a crash, increasing the risk of injury.
The remedy
Chrysler will notify owners, and dealers will install a new OCM-SCF seat service kit, free of charge. The recall began on May 27, 2016. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is S09.
Notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
| 2015 CHRYSLER 200 | Built 2014-04-07 to 2015-08-03. |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 0806216 | 2022-12-19. Service bulletin. Front Seat Bottom Cushion Hard Or Lumpy Spot |
|---|---|
| 9004509 | 2022-12-19. Service bulletin. Oil Filter If a Mopar Oil Filter is not available, use a filter that meets or exceeds USCAR36 specification and is compatible with semi and full synthetic oils. Recommended Brands: Wix, Purolator, and NapaGold For concerns of V8 oil filter leaks on 22MY and up vehicles: 1. Clean the area and use oil dye to know the exact location of the leak with black/UV light. 2. Removal torque (force needed to loosen the filter) 3. If the source of the leak cannot be identified, please contact FCA Redacted Content to FasTrak parts back for analysis. If no response in 15 minutes, proceed with repair and email pictures of the following: A) Oil filter from the bottom to know if it has a "Factory Installed" filter. B) Leak. C) Damage in filter (if any) D) Gasket. E) Block or Oil Filter Adapter(OFA) or Engine Oil Cooler(EOC) sealing surface. |
| 9003579 | 2022-10-24. Service bulletin. Occupant Restraint Controller (ORC) For PF, KL or UF Vehicles ONLY: Prior to replacing ORC part numbers, please contact FCA engineering if ANY of the following Diagnostic trouble codes are Stored or Active in the ORC module: DTC: B223D-00 - OCM DTC Present DTC: B0050-13 - Driver Seatbelt Sensor-Circuit Open DTC: B0052-13 - Passenger Seatbelt Sensor-Circuit Open DTC: B00B5-13 - Driver Seat Track Position Restraints Sensor-Circuit Open DTC: B00C5-13 - Passenger Seat Track Position Restraints Sensor-Circuit Open DTC: B0028-13 - Right Side Seat Deployment Squib 1-Circuit Open DTC: B0020-13 - Left Side Seat Deployment Squib 1-Circuit Open Execute DealerCONNECT / TechCONNECT Diagnostic Procedures to assess potential defects to devices connected to the ORC Module depending on the active or stored Diagnostic Trouble Code. If no defects are detected, verify wiring connectivity between the ORC Module and the component associated with the Diagnostic Trouble Code. Investigate connector pins and wire harness terminals for bent,corroded,or spread conditions. If no response within 15 minutes, proceed with repair. FCA Engineering Contacts: Jay Nagle (ORC Module, Driver/passenger seat track position sensor, OCM for PF, KL or UF Vehicles ONLY) @ cell (248) 576-5657 |
| 1000120 | 2022-10-17. Service bulletin. Airbag Warning Lamp (AWL) Illuminated B0028-13 and B0020-13 This bulletin involves inspecting and installing a jumper harness in the front seats if needed. Customers may experience a AWL illumination. Upon further investigation, the technician may find one or more of the following Diagnostic Trouble Codes (DTCs) set in memory:B0028-13 - Right Side Seat Deployment Squib 1 - Circuit Open. B0020-13 - Left Side Seat Deployment Squib 1 - Circuit Open. |
| 55111275A | 2022-09-26. Service bulletin. Sun Sensor Multi zone Auto Climate Control systems. Left and right outlet temperatures do not match when system is in "sync" . Occupants will experience being cold ( winter time), on either passenger or driver side, even though the temperature setting is the same. Root cause: Suspect sun senors ( PN 55111274AA and 55111275AA). THERE WILL BE NO DTC FOR THE SUN SENSOR active or stored. The issue is diagnosed by using an INCANDESCENT (not LED) shop lamp. Shine the shop lamp on the left side of the sensor, then on the right side of the sensor, while monitoring sensor output with STARSCAN. The reading should change from 0 (or near zero) to about 20 to 40. The important thing is that the left and right readings are the same, and that they change when the lamp is shone on it. |
| 0808214 | 2022-09-26. Service bulletin. Flash: Electronic Shift Module (ESM) Enhancement This bulletin involves updating the software in the Electronic Shift Module. The customer may experience an intermittent inability to shift into any gear range. This condition should only last a few seconds. If this condition happens when driving in any forward gear, the transmission will default to drive. If the vehicle is in reverse, the transmission will default to neutral. If the transmission is in park or neutral the transmission will not change gear selection. On further inspection one or all of the following DTCs may be found: U1467 Implausible Driver Shift Request Signal Received On CAN and D-PT CAN. U0103-00 Lost Communication With Electric Gear Shift Module. U11E3-00 TCM Lost Communication With ESM On DPT CAN. |
| P37070114 | 2022-09-26. Service bulletin. New safety recall advanced communication. |
| 0806216 | 2022-09-26. Service bulletin. Bottom seat may be uncomfortable or, feel a hard/lumpy spot in the cushion. |
| P37070114 | 2021-05-03. Service bulletin. New safety recall advanced communication. |
| 08-062-16 | 2021-05-03. Service bulletin. Bottom seat may be uncomfortable or, feel a hard/lumpy spot in the cushion. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.