NHTSA recall 07V248000
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | NHTSA (United States) |
|---|---|
| Campaign number | 07V248000 |
| Manufacturer's number | PB037 |
| Manufacturer | NISSAN NORTH AMERICA, INC. |
| Reported | 2007-06-07 |
| Owners notified | 2007-07-02 |
| Component | SUSPENSION:FRONT |
| Units potentially affected | 1438 |
What is wrong
DURING PRODUCTION, A SELECT NUMBER OF VEHICLES UNDERWENT AN OFFLINE INSPECTION AT THE ASSEMBLY PLANT WHERE A BOLT IN THE FRONT SUSPENSION ASSEMBLY WAS REMOVED. ON SOME OF THESE VEHICLES, IT IS POSSIBLE THAT THIS BOLT MAY NOT HAVE BEEN TIGHTENED TO SPECIFICATION WHEN IT WAS REINSTALLED.
What can happen
IF THE BOLT IS LOOSE, THE DRIVER WILL HEAR A RATTLING NOISE AND NOTICE VIBRATION. IF THE BOLT COMES OFF COMPLETELY, THE DRIVER CAN EXPERIENCE DIFFICULTY IN CONTROLLING THE DIRECTION OF THE VEHICLE WHICH COULD RESULT IN A CRASH.
The remedy
DEALERS WILL REPLACE THE ATTACHMENT BOLTS AND TIGHTEN THEM TO THE SPECIFIED VALUE. THIS RECALL BEGAN ON JULY 2, 2007. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
Notes
NISSAN RECALL NO. PB037.CUSTOMERS MAY ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO HTTP://WWW.SAFERCAR.GOV.
| 2007 NISSAN QUEST | Built 2006-01-20 to 2006-09-29. |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| NTB99-001F | 2022-01-08. Service bulletin. STRUT AND SHOCK ABSORBER REPLACEMENT GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
|---|---|
| NTB00033E | 2021-05-10. Service bulletin. SERVICE INFORMATION - This bulletin is to assist you in responding to customer questions about brake operation, and provides diagnostic and repair information for each item listed, if any should occur. - Most brake incidents fall into the following categories: a. Brake Noise: A squeak, squeal, clunk, or groan that occurs when the brakes are applied or released. b. Brake Judder: A vibration that can be felt in the vehicle, steering wheel or brake pedal when the brakes are applied. c. Pedal Feel: The effort needed to operate the brakes is too high or too low. SERVICE PROCEDURE 1. Verify the condition by road testing the vehicle with the customer. 2. Determine the specific brake incident based on the description in the Service Information above. 3. Follow the appropriate repair procedure(s), listed on the following pages, for your specific incident. See this bulletin for further details. |
| NTB99001A | 2021-05-10. Service bulletin. SERVICE INFORMATION This bulletin provides information to identify: - A leaking strut or a shock absorber that qualifies for replacement under warranty. - A strut or shock absorber that has slight oil seepage, a condition which is considered normal, does not affect strut/shock absorber operation or performance, and does not require replacement. - A strut or shock absorber that should be replaced due to rod resistance/noise issues. See this bulletin for further detail. |
| NTB99-001e | 2021-03-06. Service bulletin. STRUT AND SHOCK ABSORBER REPLACEMENT GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| DOR-H5Y5B-01 | 2020-01-13. Service bulletin. This SKU is a Suspension Ball Joint. The customer communication requested return of unsold inventory to inspect for the outer diameter of the ball joint housing being too small. The outer diameter being too small would prevent the part from being installed, and would therefore have no impact on the end user besides time to complete installation. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.