WenmarOpen by Wenmar Pro

Service bulletins for the 2006 Volkswagen Passat

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

539 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Bulletins, newest first
5814032023-07-17. Service bulletin. STRUCTURE:BODY:DOOR. Corrosion on Rear Door in Trim Strip Area
5714092023-07-17. Service bulletin. STRUCTURE:BODY:DOOR. Corrosion on the Front Door in Trim Strip Area
5714062023-07-17. Service bulletin. STRUCTURE:BODY:DOOR. Corrosion on the Front Door in Trim Strip Area
TT5713022023-07-17. Service bulletin. ELECTRICAL SYSTEM:IGNITION:ANTI-THEFT:IMMOBILIZER/PROXIMITY:KEY/SENDER. If key blade is found to stick or bind when opening or closing, check position of roll pin that secures key blade to mechanism. If roll pin is sticking out on either side (as shown below), do not replace key. Instead, use appropriate sized punch and hammer to drive in the roll pin so that it is flush with edge of mechanism.
Warranty2023-07-17. Service bulletin. EQUIPMENT. Volkswagen Warranty Policies and Procedures ? April 2014
VWS13032023-07-17. Service bulletin. ENGINE; EQUIPMENT. In SAGA, the time units for the Volkswagen DoubleCheck labor operation were reduced in error from 50 time units to 30 time units during the system update posted on July 4th.
UpdateB2023-07-17. Service bulletin. COMMUNICATION:MANUFACTURER TELEMATICS. Quick Reference Update Guide
UpdateA2023-07-17. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Quick Reference Update Guide
Update2023-07-17. Service bulletin. COMMUNICATION:MANUFACTURER TELEMATICS. Quick Reference Update Guide
TT5512032023-07-10. Service bulletin. LATCHES/LOCKS/LINKAGES:ELECTRONIC LOCK/LATCH ACTUATOR; STRUCTURE:FRAME AND MEMBERS; ELECTRICAL SYSTEM:INTERIOR LAMPS/BULBS. When diagnosing a power rear lid that will power open but will not power close, check operation of luggage compartment lamp W3. Lamp should be on with rear lid open and off with rear lid closed.
TT5014012023-07-10. Service bulletin. WHEELS; TIRES. The use of tire dressing gives your tires that shiny finish that completes the image of a clean (new) vehicle. There are many different tire dressing products available. When choosing a product please pay close attention to its contents. Always use a water based product.
TT4609042023-07-10. Service bulletin. PARKING BRAKE:ELECTRICAL:SWITCH; ELECTRICAL SYSTEM; PARKING BRAKE:ELECTRICAL:CONTROL MODULE; PARKING BRAKE. If fault code 03200 or 16352 is present in the Electromechanical Parking Brake (EPB) module, it may be due to the switch and module not being synchronized.
TT4509032023-07-10. Service bulletin. AIR BAGS; STEERING; SERVICE BRAKES, HYDRAULIC:POWER ASSIST:ELECTRIC:CONTROL MODULE; ELECTRICAL SYSTEM; STEERING:RACK AND PINION:RACK. If, after replacement of the steering rack, fault code 01309 008 is set in the ABS/ESP module only, follow the test plan in GFF for Driver Steering Recommendation (DSR) or channel 3 activation. If the test plan fails to clear the fault, follow the direction below using Vehicle Self Diagnosis in Address Word 44 - Steering Assistance
TT4508022023-07-10. Service bulletin. SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:WHEEL SPEED SENSOR/TONE RING; UNKNOWN OR OTHER. Fault code 02543 000 ?Brake Vacuum Sensor no Display? may be encountered in the ABS module. This may be caused by the hydraulic brake boost function (HBV) in adaptation value 61 being turned off (value = 0). All Passat Wagons (including 4motion) and 3.6L equipped sedans with front drive should have this function turned on (value = 1). Change the adaptation value and verify the fault has cleared. Additionally, it may be necessary to lock the vehicle and allow the modules to go to sleep to clear the fault.
TT45061222023-07-10. Service bulletin. ELECTRICAL SYSTEM:INSTRUMENT PANEL:SPEEDOMETER/ODOMETER:SENSOR/SENDING UNIT; SERVICE BRAKES, AIR:ANTILOCK:CONTROL UNIT/MODULE. Use the following procedure to diagnose active wheel speed sensor complaints
TT201301a2023-07-10. Service bulletin. UNKNOWN OR OTHER; ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM); FUEL SYSTEM, OTHER. To clear static ECM fault P1250 ?Fuel Level Too Low?, add fuel to vehicle and complete a road test of at least 10 miles. Simply adding fuel without completing a road test may not allow fault to clear.
TT2013012023-07-10. Service bulletin. FUEL SYSTEM, OTHER; ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM); UNKNOWN OR OTHER. To clear static ECM fault P1250 ?Fuel Level Too Low?, add fuel to vehicle and complete a road test of at least 10 miles. Simply adding fuel without completing a road test may not allow fault to clear.
TT2009062023-07-10. Service bulletin. FUEL SYSTEM, GASOLINE; ENGINE AND ENGINE COOLING:ENGINE:DIESEL; FUEL SYSTEM, DIESEL; ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:TURBO/SUPERCHARGER. Use the diagram below to test the N75 Solenoid Valve in the event of a turbocharger fault code such as P0299 or P0234. This applies to Mechanical Injection Style Diesel Engines, Pumpe Duse Style Diesel Engines and the new Common Rail Style Diesel Engines.
TT2006145a2023-07-10. Service bulletin. SERVICE BRAKES, HYDRAULIC; FUEL SYSTEM, OTHER; ELECTRICAL SYSTEM:ALTERNATOR/GENERATOR/REGULATOR; STEERING. If replacing the high pressure fuel pump, also remove and inspect the cam follower from the timing cover/cylinder head to inspect it for wear. If wear is found, contact the Volkswagen Dealer Technician Helpline Powertrain Team for additional instructions.
TT20061012023-07-10. Service bulletin. SERVICE BRAKES, AIR:SUPPLY:PRESSURE GUAGE; SERVICE BRAKES, HYDRAULIC. If you have a complaint of DTCs for the low side fuel pressure being out of specification (e.g. P310B), check the fuel pressure with BOTH a mechanical gauge and by the display in Measured Value Block 103. The readings should be 1 bar higher in the MVB due to reading atmospheric pressure + fuel pressure. If the mechanical gauge reading is within specification BUT the MVB 103 reading is not 1 bar higher, check for a possible faulty G410 Low Fuel Pressure sensor.
TT0014032023-07-10. Service bulletin. EQUIPMENT; EQUIPMENT:ELECTRICAL:INFOTAINMENT:BLUETOOTH/WIFI; ELECTRICAL SYSTEM. When performing SVM updates, the scan tool should be hardwired to the vehicle and the Bluetooth physically turned off. A hard wired internet connection is also recommended.
TT001304A2023-07-10. Service bulletin. EQUIPMENT. If a needed service part is on back order, upgrade the daily order to a red order and check the ?Car Down? box to escalate the order. If parts assistance is needed, please call 800-767-6552 to speak with a VWGoA Parts Specialist.
TT0013042023-07-10. Service bulletin. EQUIPMENT. If a needed service part is on back order, upgrade the daily order to a red order and check the ?Car Down? box to escalate the order. If parts assistance is needed, please call 800-767-6552 to speak with a VWGoA Parts Specialist.
TT45061222023-07-05. Service bulletin. WHEELS; SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:WHEEL SPEED SENSOR/TONE RING; SERVICE BRAKES, HYDRAULIC. Use the following procedure to diagnose active wheel speed sensor complaints:
TT3214012023-07-05. Service bulletin. POWER TRAIN. Incorrect torque converter or flywheel/flexplate installation can result in transmission damage. When installing an engine, flywheel or transmission, please follow the installation procedures outlined in ELSA. For the flywheel/flexplate, please be certain the correct shim is installed between it and the crankshaft (reference VWIQ120). When installing a torque converter, press the torque converter hub through the seal as far as the first stop. Turn the torque converter while pushing toward the transmission using light force, until the cut outs in the torque converter hub lock into the pump wheel plate. The torque converter slides in. The torque converter is installed correctly if it is easy to turn by hand and if it fits evenly in the transmission bell housing. Additionally, it should spin freely when the transmission bell housing bolts are torqued to the engine block, prior to installation of the flywheel to converter bolts (reference VWIQ121).

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.