Service bulletins for the 2011 Volkswagen Jetta
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
1332 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Engine are shown. Show all
| 24CV - Circular | 2017-12-14. Service bulletin. ENGINE AND ENGINE COOLING. Inlet Air Box Housing Snow Flap Replacement & Oxygen Sensor Inspection/Replacement. The snow flap in the inlet air box housing may remain partially to fully open. Should this occur, excess warm air could enter the air intake through the snow flap inlet. The oxygen sensor will be checked during this service and, if measured degradation tolerances are met, the sensor will be replaced. Updated measuring value range for Heated Oxygen Sensor -G39- replacement in work procedure. |
|---|---|
| 24CV - Circular | 2017-12-14. Service bulletin. ENGINE AND ENGINE COOLING. Inlet Air Box Housing Snow Flap Replacement & Oxygen Sensor Inspection/Replacement. The snow flap in the inlet air box housing may remain partially to fully open. Should this occur, excess warm air could enter the air intake through the snow flap inlet. The oxygen sensor will be checked during this service and, if measured degradation tolerances are met, the sensor will be replaced. Updated work procedure and claiming instructions. Included new ODIS test plans, and 2009 MY work and claiming instructions. |
| 24CV - Dealer Co | 2017-12-14. Service bulletin. ENGINE AND ENGINE COOLING. Inlet Air Box Housing Snow Flap Replacement & Oxygen Sensor Inspection/Replacement. The snow flap in the inlet air box housing may remain partially to fully open. Should this occur, excess warm air could enter the air intake through the snow flap inlet. The oxygen sensor will be checked during this service and, if measured degradation tolerances are met, the sensor will be replaced. |
| TT 261704 | 2017-12-14. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM. Tips to address specific DTCs that can result from an exhaust leak. |
| VSS 17-08 | 2017-12-14. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. VSS 17-08 - TDI Monitoring Program - Campaigns 23Q3/23U4/23U3 2.0L Emissions Modification - Gen I, Gen II and Gen III. |
| V261301 2031583 | 2017-12-14. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM. Technical Bulletin (Exhaust Pressure Control issues): This document informs that water and road salt can corrode the exhaust flap shaft causing it to stick in open / closed position. The production solution to this issue was Improved parts introduced into production. This document discusses the "Fault Codes" necessary to diagnosis, and potential remedy of the issue. The fault codes for checking warranty coverage for servicing the vehicle are also available. |
| TT 20-09-06 | 2017-12-05. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:TURBO/SUPERCHARGER; FUEL SYSTEM, DIESEL. Tech Tips (TDI Engine - N75 Solenoid Valve Diagnosis): This document informs with graphical aid the testing of the N75 Solenoid Valve in the event of a turbocharger fault code such as P0299 or P0234. This applies to Mechanical Injection Style Diesel Engines, Pumpe Duse Style Diesel Engines and the new Common Rail Style Diesel Engines. |
| V171403 2017813 | 2017-12-05. Service bulletin. ENGINE. Technical Bulletin (Oil Consumption Measurement): Customer states oil consumption is higher than the Volkswagen oil consumption standard of up to 0.5 quarts per 600 miles, or 0.5 liters per 1000 km. In order to provide effective lubrication and cooling of internal engine components, all internal combustion engines consume a certain amount of engine oil. Oil consumption varies from engine to engine and may change significantly over the life of the engine. Typically, engines with specified break-in periods consume more oil during the break-in period, and the oil consumption will stabilize after the break-in period. Refer to the Owners Manual for specific break-in procedures. Under normal conditions, the rate of oil consumption depends on the quality and viscosity of the oil, the RPM at which the engine is operated, the ambient temperature and road conditions. Further factors include the amount of oil dilution from water condensation or fuel residue and the oxidation level of the oil. This document discusses the "Fault Codes" necessary to diagnosis, and potential remedy of the issue. The fault codes for checking warranty coverage for servicing the vehicle are also available. |
| V211404 2025464 | 2017-12-05. Service bulletin. ENGINE. Technical Bulletin (Frozen Charge Air Cooler ? Engine Will Not Start): Engine will not start after standing in cold weather below 0°C (32°F), MIL may be illuminated with various induction and/or boost system faults stored in ECM. Moisture from the intake air condenses and collects in the charge air cooler. At cold temperatures this moisture can freeze causing blockage of the intake air system. This document discusses the "Fault Codes" necessary to diagnosis, and potential remedy of the issue. The fault codes for checking warranty coverage for servicing the vehicle are also available. |
| V011411 2034898 | 2017-12-05. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM. Technical Bulletin (Exhaust Gas Recirculation Flow, Could be accompanied with Soot Accumulation): High soot loads prior to regeneration can cause possible restrictions in the EGR filter. The production solution for this issue is New software implemented in current production. This document discusses the "Fault Codes" necessary to diagnosis, and potential remedy of the issue. The fault codes for checking warranty coverage for servicing the vehicle are also available. |
| V011406 2034012 | 2017-12-05. Service bulletin. ENGINE. Technical Bulletin (Manifold Absolute Pressure Range / Performance Stored in ECM Fault Memory): Monitoring strategy for the manifold absolute pressure sensor is too sensitive, causing P0106 to incorrectly set in the engine control module. The product solution for this issue was improved software. |
| V011408 2014815 | 2017-12-05. Service bulletin. ENGINE. Technical Bulletin The use of contaminated gasoline, seasonal fuel changes (summer/winter fuel) or gasoline with a low content of deposit control additives may result in one or more of the following conditions: -Excessive accumulation of deposits on intake valves, intake manifold, fuel injectors and combustion chambers. -Engine runs rough after cold start. -Excessive engine cranking time. -Stumbles while driving. -Rough engine idle. -Loss of engine performance. -Poor fuel economy. This document informs of the procedure for the vehicle if it is diagnoised with poor quality gas |
| V151402 2032150 | 2017-12-05. Service bulletin. ENGINE. Technical Bulletin (Proper Removal of Engine Cover to Avoid Breakage): Pulling on the engine cover in some areas can cause damage. This document informs on the procedure to remove the engine cover. |
| V231402 2036656 | 2017-12-05. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:OTHER FUEL TYPES:TURBO/SUPERCHARGER. Technical Bulletin (No Start, or Rough Running issues): When diagnosing a MIL ON, no-start or rough running concern on a common rail diesel vehicle, and no root cause is found after following all GFF diagnostic procedures, it may be necessary to check for metallic particles in the High Pressure Fuel Pump. If such an inspection is necessary, the guidelines in this document must be observed when removing the N290 Fuel Metering Valve |
| V231403 2036656 | 2017-12-05. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:OTHER FUEL TYPES:TURBO/SUPERCHARGER. Technical Bulletin (No Start, or Rough Running due to Fuel Rail issues): When diagnosing the condition above on a common rail diesel vehicle, if no root cause is found after checking all other components and all GFF diagnostic procedures have been performed, it may be necessary to check for metallic particles in the High Pressure Fuel Pump using the service section of this document. If such an inspection is necessary, the following guidelines must be observed when removing the N290 Fuel Metering Valve. |
| V011521 2034898 | 2017-11-08. Service bulletin. ENGINE; ELECTRICAL SYSTEM; FUEL SYSTEM, GASOLINE. Technical Bulletin (Exhaust Gas Recirculation Flow Insufficient Stored in ECM Fault Memory): High soot loads prior to regeneration can cause possible restrictions in the EGR filter. This document contains the procedure to update the programming on the diagnostic hardware. This document contains the fault codes necessary to check the warranty coverage for servicing this issue. The document also contains the procedure for servicing the possible causes of restrictions in the EGR filter. |
| V201503 2031426 | 2017-11-08. Service bulletin. ELECTRICAL SYSTEM; ENGINE; FUEL SYSTEM, GASOLINE. Technical Bulletin: High Pressure Fuel Pump Diagnosis. Completing the GFF high pressure pump function test is essential to diagnose proper pump operation and to avoid unnecessary replacements. This document contains the procedure to update the programming on the diagnostic hardware. This document contains the fault codes necessary to check the warranty coverage for servicing this issue. |
| V241505 2038161 | 2017-11-08. Service bulletin. ENGINE AND ENGINE COOLING. Technical Bulletin (Intake manifold runner position sensor issues): This document informs what repairs are needed to fix the issue. This document contains the fault codes necessary to check the warranty coverage for servicing this issue. |
| V261507 2031583 | 2017-11-08. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM; EQUIPMENT. Technical Bulletin (Exhaust Pressure Control Valve / Exhaust Gas Recirculation Flow issues): This document contains the fault codes needed to diagnose, and service the issue. The document contains the fault codes necessary to check warranty coverage for servicing the issue |
| V871506 2019947 | 2017-11-08. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER; ENGINE AND ENGINE COOLING. Technical Bulletin (Air Conditioning, Cleaning of the Refrigerant Circuit (U.S.Only)): In cases where an air conditioning system component (such as a compressor or other system component) has failed and debris from the compressor or component is circulated throughout the refrigerant circuit, the refrigerant circuit must be cleaned of any and all debris or damage to the replacement components will result. This document contains information on how to diagnose, and service this issue. |
| V871508 2005566 | 2017-11-08. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING. Technical Bulletin (HVAC, Unpleasant Odor): Unpleasant odor is coming from Heating and Ventilation system. Odor mainly occurs after vehicle has been sitting (unused) at least 5 hours and within 20 to 60 seconds after vehicle is first started. This document contains information on how to diagnose, and service this issue. |
| TT 21-10-02 | 2017-11-08. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:TURBO/SUPERCHARGER; POWER TRAIN. Tech Tips: The document discusses the conditions of when turbo can to be fixed or replaced |
| TT 19-13-02 | 2017-11-08. Service bulletin. ENGINE AND ENGINE COOLING. Tech Tips (Coolant Leak or Repeat Coolant Leak from the Water Pump Area): The document informs to inspect for issues, and why issues may happen. It also notes how to fix the issue, and other issues that could happen while repairing the issue |
| TT 19-12-01 | 2017-11-08. Service bulletin. ENGINE. Tech Tips (Radiator Identification Sensor): On TSI (2.0l CCTA, CBFA) equipped vehicles with fault code P2568 Direct Ozone Reduction Catalyst Temperature Sensor, this fault refers to - G611- as Radiator Identification Sensor. If the radiator requires replacement on any above listed vehicle, the -G611- will be packaged separately within the radiator packaging. The new sensor will need to be bonded to the radiator. |
| V211504 2026771 | 2017-11-08. Service bulletin. ELECTRICAL SYSTEM; ENGINE; FUEL SYSTEM, DIESEL. Technical Bulletin:Engine Lacks Performance, and Engine Warning Light ON issues. The document contains fault codes for trouble shooting issues, and procedures for those issues |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.