Recalls that may apply to the 2008 Volkswagen Jetta
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 19V679000 | 2019-09-25. UNKNOWN OR OTHER. Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2017 Volkswagen Passat, 2018 Tiguan LWB, 2007-2009 Jetta Sedan, 2011-2013, 2015 and 2019 Jetta, 2013 Jetta Hybrid, 2008-2009 Jetta Sportwagen, 2015 Golf Sportwagen, 2013 Golf, 2008-2010 and 2012-2013 Beetle and Beetle Convertible, 2008-2010 Beetle, and Beetle Convertible vehicles. Modifications made while the vehicles were in an internal evaluation period may cause the affected vehicles to not comply with all of the applicable regulatory requirements. Built 2006-12-21 to 2008-11-25. |
|---|---|
| 10V621000 | 2010-12-10. FUEL SYSTEM, GASOLINE:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS. VOLKSWAGEN IS RECALLING CERTAIN MODEL YEAR 2006-2010 JETTA, NEW BEETLE, NEW BEETLE CONVERTIBLE, MODEL YEAR 2009 JETTA SPORTWAGEN AND MODEL YEAR 2007-2009 RABBIT VEHICLES EQUIPPED WITH 2.5L ENGINES. THE JETTA, JETTA SPORTWAGEN, AND RABBIT VEHICLES MAY HAVE A SMALL PLASTIC TAB LOCATED ON THE WINDSHIELD WASHER FLUID RESERVOIR THAT MAY CHAFE AGAINST AN UNDERHOOD FUEL SUPPLY LINE. THE NEW BEETLE AND THE NEW BEETLE CONVERTIBLE VEHICLES MAY HAVE A FASTENING CLAMP ON A HYDRAULIC HOSE OF THE POWER STEERING SYSTEM THAT MAY BE LOCATED IN AN IMPROPER POSITION WHICH COULD CAUSE CHAFING AGAINST AN UNDERHOOD FUEL SUPPLY LINE. Built 2006-03-01 to 2009-06-30. |
| 09V164000 | 2009-05-19. POWER TRAIN:DRIVELINE:DRIVESHAFT. VOLKSWAGEN IS RECALLING 25,594 MY 2006-2009 JETTA 5TH GENERATION EQUIPPED WITH 2.01 ENGINE. THE FASTENING SCREW CONTACT SURFACES ON THE DRIVESHAFT COVER PLATE MAY NOT HAVE BEEN MANUFACTURED TO FACTORY SPECIFICATIONS. SOME SCREWS MAY NOT HAVE BEEN TORQUED PROPERLY DURING ASSEMBLY AND COULD LOOSEN OVER TIME, CAUSING A KNOCKING SOUND WHEN THE VEHICLE IS IN MOTION. THE DRIVESHAFT SCREWS COULD LOOSEN TO THE POINT WHERE THE DRIVESHAFT DETACHES FROM THE GEARBOX. Built 2005-06-15 to 2008-11-29. |
| 07V442000 | 2007-09-24. EXTERIOR LIGHTING:HEADLIGHTS. CERTAIN VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." SOME VEHICLES MAY NOT HAVE HAD A REQUIRED CAP INSTALLED WHICH DISABLES THE HEADLIGHT HORIZONTAL AIM AND SOME VEHICLES MAY CONTAIN A CAP THAT DISABLES THE VERTICAL AIMING SCREW. Built 2004-10-18 to 2007-09-21. |
| 2020353 | 2020-08-04. Label. Issue: On certain vehicles, the warning label for the engine block heater cable is written in English only. As a result, a French user may not receive important safety information about how to use the engine block heater. A label that is not provided in both official languages could create confusion. Safety Risk: User confusion could increase the risk of injury when trying to use the block heater. Corrective Actions: The company will mail each owner a new label for the block heater cable. If you would like help installing the label, you can contact a dealer for assistance. |
|---|---|
| 2019469 | 2019-09-25. Other. Issue: A small number of vehicles built before the start of series production ("pre-series vehicles" ) may have been sold to retail customers. Volkswagen has determined that these vehicles may not meet all Canadian regulations. Safety Risk: A vehicle that does not meet Canadian regulations could be unsafe to operate. Corrective Actions: Volkswagen will notify owners by mail and offer to buy back the affected vehicles. |
| 2010444 | 2010-12-10. Fuel System. On certain Golf, Golf wagon, Jetta and Rabbit equipped with a 2.5L Engine, a small plastic tab located on the windshield washer fluid reservoir may chafe against an underhood fuel supply line. If chafing occurs fuel leakage could develop which, in the presence of an ignition source, could result in a fire causing property damage and/or personal injury. Correction: Dealers will inspect the affected vehicles and, if necessary, replace the fuel line. In addition, as a preventive measure, the plastic tab from the windshield washer fluid reservoir will be removed. |
| 2009141 | 2009-05-14. Structure. On certain vehicles, driveshaft cover plate screws may not have been torqued properly during vehicle assembly. Should they loosen, a knocking sound may be heard while the vehicle is in motion. In the worst case, the driveshaft screws could loosen to the point where the driveshaft detaches from the gearbox. If the vehicle is moving when this happens, the detached driveshaft could cause damage to the gearbox housing. A damaged gearbox housing could leak gearbox oil onto the street and create a risk of vehicle crash for both the driver and other motorists. This could result in property damage, personal injury or death. Correction: Dealers will inspect and, if necessary, replace the driveshaft screws. |
| 2007306 | 2007-09-18. Lights And Instruments. Certain vehicles fail to comply with the requirements of CMVSS 108 - Lamps, Reflective Devices and Associated Equipment. 1). The required cap designed to disable the headlamp horizontal aim may not have been installed during vehicle assembly. 2). A cap may have been inadvertently installed to disable the vertical aiming screw. 3). An adjustment mechanism allows aiming of the low beam relative to the high beam. Correction: Dealers will affect repairs. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.