WenmarOpen by Wenmar Pro

Service bulletins for the 2011 Volkswagen Golf

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

1236 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Bulletins, newest first
TT5710042023-07-10. Service bulletin. ELECTRICAL SYSTEM:BODY CONTROL MODULE:SOFTWARE; LATCHES/LOCKS/LINKAGES:ELECTRONIC LOCK/LATCH ACTUATOR; ELECTRICAL SYSTEM:WIRING:SWITCHES/KNOBS/BUTTONS; ELECTRICAL SYSTEM. If no communication can be established to the Vehicle electrical system control module J519 (address word 09) in Guided Fault Finding or Vehicle Self Diagnosis, it may be necessary to cycle door locks. It is recommended to cycle both the remote locks and the driver?s door lock switch when attempting to communicate to the module with the scan tool. Ensure all vehicle doors are unlocked before communication is retried.
TT5014012023-07-10. Service bulletin. WHEELS; TIRES. The use of tire dressing gives your tires that shiny finish that completes the image of a clean (new) vehicle. There are many different tire dressing products available. When choosing a product please pay close attention to its contents. Always use a water based product.
TT4509042023-07-10. Service bulletin. BACK OVER PREVENTION; STEERING:RACK AND PINION:RACK; ELECTRICAL SYSTEM:ADAS:PARKING ASSIST:SENSORS; POWER TRAIN; STEERING; ELECTRICAL SYSTEM; STEERING:STEERING CONTROL MODULE. Some Golf, GTI, Jetta, and Passat vehicles equipped with electromechanical power steering have the G85 steering angle sensor located in the steering rack. These vehicles do not have a G85 in the steering column. To determine G85 location, check the J500 Power steering control module part number in the GFF printout. Do not use the part number on the steering rack for this check.
TT45061222023-07-10. Service bulletin. ELECTRICAL SYSTEM:INSTRUMENT PANEL:SPEEDOMETER/ODOMETER:SENSOR/SENDING UNIT; SERVICE BRAKES, AIR:ANTILOCK:CONTROL UNIT/MODULE. Use the following procedure to diagnose active wheel speed sensor complaints
TT2013022023-07-10. Service bulletin. FUEL SYSTEM, OTHER:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS; EQUIPMENT; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Be aware that fuel lines are color coded on vehicles with return fuel pressure lines. The black line is for fuel pressure supply and the blue line is for fuel pressure return. To verify correct line installation, remove the metal cover exposing the fuel pump flange assembly (generally under the rear seat). Refer to the ELSA Repair Manual for specific location. Check for raised arrows on the flange housing. The black line (Fuel Pressure Supply) attaches to the connection with the arrow pointing away from it. The blue line (fuel return) attaches to the connection with arrow pointing to it.
TT201301a2023-07-10. Service bulletin. UNKNOWN OR OTHER; ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM); FUEL SYSTEM, OTHER. To clear static ECM fault P1250 ?Fuel Level Too Low?, add fuel to vehicle and complete a road test of at least 10 miles. Simply adding fuel without completing a road test may not allow fault to clear.
TT2013012023-07-10. Service bulletin. FUEL SYSTEM, OTHER; ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM); UNKNOWN OR OTHER. To clear static ECM fault P1250 ?Fuel Level Too Low?, add fuel to vehicle and complete a road test of at least 10 miles. Simply adding fuel without completing a road test may not allow fault to clear.
TT2009062023-07-10. Service bulletin. FUEL SYSTEM, GASOLINE; ENGINE AND ENGINE COOLING:ENGINE:DIESEL; FUEL SYSTEM, DIESEL; ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:TURBO/SUPERCHARGER. Use the diagram below to test the N75 Solenoid Valve in the event of a turbocharger fault code such as P0299 or P0234. This applies to Mechanical Injection Style Diesel Engines, Pumpe Duse Style Diesel Engines and the new Common Rail Style Diesel Engines.
TT1913022023-07-10. Service bulletin. ENGINE AND ENGINE COOLING. Inspect the water pump for signs of contact with engine oil. Engine oil may cause the water pump gasket to swell, which may lead to a coolant leak. If water pump replacement is necessary, ensure that any engine oil is thoroughly cleaned off, prior to water pump installation. Please note that when replacing the water pump or opening the cooling system, there is a special bleed procedure that has to be performed. Vacuum bleed the cooling system for 10 minutes. Start the engine and let idle until the thermostat opens and the cooling fan runs, before driving vehicle or raising engine RPM.
TT1913012023-07-10. Service bulletin. ENGINE AND ENGINE COOLING. After a cold start, the engine coolant temperature gauge will slowly rise to approximately 190° F. When the F265 mapped thermostat opens, the gauge may drop by approximately 60° F before again rising to 190° F. No repairs should be attempted for this normal concern. F265 is pictured below.
TT131301a2023-07-10. Service bulletin. POWER TRAIN; ENGINE AND ENGINE COOLING. When servicing the timing chain sprocket or removing the vibration damper, be aware that one bolt holds both the vibration damper (harmonic balancer) and the crankshaft timing chain sprocket to the crankshaft. Once the damper is removed, the crankshaft should not be rotated unless special tool spacer T10368 has been installed. The crankshaft timing chain sprocket and spur gear drive on the crankshaft have a coupling that must be seated correctly during assembly. Failure to install special tool spacer T10368 before rotating engine will cause the engine to skip time and bend valves.
TT1313012023-07-10. Service bulletin. ENGINE AND ENGINE COOLING; POWER TRAIN. CBFA 2.0T TSI Engine
TT011401a2023-07-10. Service bulletin. POWER TRAIN; ENGINE AND ENGINE COOLING. Install a vacuum gauge on the dipstick tube and check crankcase vacuum at idle. Compare to a known good vehicle. If the vacuum reading is lower than the comparison vehicle, visually inspect for oil leaks between the engine and the transmission. Smoke test the crankcase by connecting the EVAP smoke machine to the dipstick tube and inspect for leaks at the rear main seal (this will limit pressure to 2 PSI). DO NOT apply shop air to the dipstick tube or the crankcase. If a rear main seal leak is identified, replace the seal. Once replaced, recheck crankcase vacuum at idle. If low, check for additional oil leaks and verify crankcase breather operation (repairing as necessary). Erase the faults and road test 10 miles to recheck operation.
TT0114012023-07-10. Service bulletin. POWER TRAIN; ENGINE AND ENGINE COOLING. Install a vacuum gauge on the dipstick tube and check crankcase vacuum at idle. Compare to a known good vehicle. If the vacuum reading is lower than the comparison vehicle, visually inspect for oil leaks between the engine and the transmission. Smoke test the crankcase by connecting the EVAP smoke machine to the dipstick tube and inspect for leaks at the rear main seal (this will limit pressure to 2 PSI). DO NOT apply shop air to the dipstick tube or the crankcase. If a rear main seal leak is identified, replace the seal.
TT0014032023-07-10. Service bulletin. EQUIPMENT; EQUIPMENT:ELECTRICAL:INFOTAINMENT:BLUETOOTH/WIFI; ELECTRICAL SYSTEM. When performing SVM updates, the scan tool should be hardwired to the vehicle and the Bluetooth physically turned off. A hard wired internet connection is also recommended.
TT0014022023-07-10. Service bulletin. FUEL SYSTEM, GASOLINE:FUEL INJECTION SYSTEM; FUEL SYSTEM, GASOLINE:DELIVERY. When replacing or adapting fuel injectors, if there is no Guided Functions Test Plan, utilize the following
TT001304A2023-07-10. Service bulletin. EQUIPMENT. If a needed service part is on back order, upgrade the daily order to a red order and check the ?Car Down? box to escalate the order. If parts assistance is needed, please call 800-767-6552 to speak with a VWGoA Parts Specialist.
TT0013042023-07-10. Service bulletin. EQUIPMENT. If a needed service part is on back order, upgrade the daily order to a red order and check the ?Car Down? box to escalate the order. If parts assistance is needed, please call 800-767-6552 to speak with a VWGoA Parts Specialist.
V3718022033975112023-07-10. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. Automatic Transmission Fluid Requirements
V2719012011894_22023-07-10. Service bulletin. ELECTRICAL SYSTEM. Battery Testing and Charging using Midtronics VAS6161 and or GRX3000 Vas Charger
V1719012012855632023-07-10. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Volkswagen Engine Oil Standards, updated to include model year 2024.
V1718062017813182023-07-10. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Engine Oil Consumption Measurement Instruction and Work sheet.
V0118122014603192023-07-10. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Software Version Management (SVM) instruction.
V0116152014815172023-07-10. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:GASOLINE; ENGINE AND ENGINE COOLING. Gasoline quality information in regards to gasoline engine performance.
V0017132033846192023-07-10. Service bulletin. FUEL SYSTEM, GASOLINE. Gasoline fuel additive

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.