Recalls that may apply to the 2016 Toyota Tundra
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 21V920000 | 2021-11-23. STEERING:HYDRAULIC POWER ASSIST SYSTEM; STEERING:RACK AND PINION. Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2008-2022 Sequoia and 2007-2021 Tundra vehicles. The power steering gear assembly may have been manufactured incorrectly, which can result in an oil leak. |
|---|---|
| 17V416000 | 2017-06-29. AIR BAGS:KNEE BOLSTER. Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2016 Tundra vehicles. The affected vehicles have a passenger knee air bag module that was attached to the instrument panel mounting brackets with incorrect bolts. Built 2016-05-27 to 2016-05-27. |
| 17V311000 | 2017-05-11. WHEELS:LUGS/NUTS/BOLTS/STUDS. Southeast Toyota Distributors, LLC (SET) is recalling certain model year 2013-2017 Toyota Tundra and Sequoia vehicles accessorized with Southeast Toyota accessory 20-inch Rockstar wheels installed by Southeast Toyota or a Southeast Toyota dealer. The Rockstar wheels were installed with lugnuts that may crack and detach. Built 2012-10-08 to 2017-04-20. |
| 17V051000 | 2017-01-24. STRUCTURE:BODY:BUMPERS. Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2016-2017 Tundra vehicles equipped with a resin rear step bumper and resin reinforcement brackets (vehicles with chrome step bumpers are not affected). In the event of an impact to the corner of the bumper, the resin bracket may be damaged but not be noticed. Built 2015-07-29 to 2016-12-22. |
| 16V420000 | 2016-06-09. EQUIPMENT:OTHER:LABELS. Southeast Toyota Distributors, LLC (SET) is recalling certain model year 2016 Toyota Camry and Highlander, 2015-2016 Toyota Tundra, Scion FR-S, and tC vehicles. The Load Carrying Capacity Modification Label may not reflect the correct added weight of the installed accessories. As a result, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 110, "Tire Selection and Rims for Passenger Cars." Built 2014-05-06 to 2016-05-13. |
| 2021723 | 2021-11-24. Electrical. Issue: This recall is for certain block heater kits installed on certain vehicles or sold as accessories at Toyota or Lexus dealerships. On certain vehicles, the engine block heater cable may not have enough heat protection and could be damaged by high temperatures. If this happens, the cable could short circuit while plugged in, and cause the wiring to overheat or melt. Note: This recall only affects the following block heater/cord part numbers: C014003034 PK5A408J09 PU14000904 C014003151 PK5A408J13 PU14000905 C014000885 PK5A489J11 PU14000907 C014000888 PK5A489J22 PU14000909 C014000907 PK5A410H00 PU14000911 C014100904 PU14000900 PU14000913 C014100907 PU14000901 PU14003571 C014100911 PU14000902 PK5A489J14 PK5A408J05 PU14000903 Safety Risk: Engine block heater wiring that overheats or melts could create the risk of a fire. Corrective Actions: Toyota recommends that you should stop using the engine block heater immediately. Toyota will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. For some vehicles, the corrective actions for this recall are under development. For others, a new engine block heater cannot be installed, and the owner will receive a refund of the purchase price of the engine block heater. |
|---|---|
| 2017363 | 2017-07-20. Electrical. On certain vehicles, the electrical power cords of some dealer installed block heaters may have been improperly manufactured, causing the wires to contact each other, resulting in a short circuit. A short circuit could lead to a fire which would increase the risk of injury and/or damage to property. Correction: For vehicles where the subject block heater was approved for installation, the dealer will replace the block heater assembly with a new one of an improved design. For vehicles where the subject block heater was not approved for installation, dealers will remove the block heater assembly. In the interim, until the remedy can be performed, dealers will cut the plug end from the block heater cord to disable the block heater's operation. |
| 2017036 | 2017-01-24. Structure. On certain vehicles equipped with the plastic rear step bumper, the resin reinforcement brackets that secure the step corners of the bumper could become damaged after a rear impact. If a person were to use the rear bumper steps with damaged resin reinforcement brackets, part of the bumper could break off which could cause the person to fall, increasing the risk of injury. Correction: Dealers will replace the resin reinforcement brackets with steel reinforcement brackets. In addition, the rear bumper tread covers will also be replaced. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.