Recalls that may apply to the 2015 Toyota Sienna
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about STRUCTURE are shown.
| 16V858000 | 2016-11-29. STRUCTURE:BODY:DOOR. Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain model year 2011-2016 Toyota Sienna minivans manufactured January 4, 2010, to August 12, 2016. If the power sliding door is unable to be opened when commanded, such as if the door is frozen shut, the door may subsequently open unexpectedly, possibly while the vehicle is moving. Built 2010-01-04 to 2016-08-12. |
|---|---|
| 15V240000 | 2015-04-22. STRUCTURE:BODY:ROOF AND PILLARS. Gulf States Toyota, Inc. (GST) is recalling certain model year 2015 Toyota Sienna vehicles manufactured January 23, 2015, to April 13, 2015, and equipped with non-Toyota-brand overhead entertainment accessories installed by GST. During reassembly of the interior after the overhead entertainment system installation, a trim panel securing clip may have been reused instead of being replaced. Built 2015-01-23 to 2015-04-10. |
| 15V236000 | 2015-04-21. STRUCTURE:BODY:ROOF AND PILLARS. Southeast Toyota Distributors, LLC (SET) is recalling certain model year 2015 Sienna vehicles manufactured September 1, 2014, to April 13, 2015 and equipped with overhead entertainment accessories installed by SET. During reassembly of the interior after the overhead entertainment system installation, a trim panel securing clip may have been reused instead of being replaced. Built 2014-09-01 to 2015-04-13. |
| 2016586 | 2016-11-22. Structure. On certain vehicles equipped with power sliding doors, under certain conditions which impede the opening of the door (such as if the door becomes frozen with ice), the sliding door motor could stall when the door is operated. If the motor stalls, high current in the door motor circuit could be generated, operating the circuit protection for the door motor. If this occurs with the sliding door latch mechanism in an unlatched position, the door could open while driving, increasing the risk of injury to a vehicle occupant. Correction: Dealers will replace the existing junction block and the rear sliding door wire harnesses with newly designed ones. The dealer will also install two sub wire harnesses to connect the junction block to the two rear door wire harnesses. |
|---|---|
| 2014536 | 2014-11-26. Structure. On certain vehicles, in the event of a collision that warrants a deployment of the curtain shield airbag (CSA), the force transmitted to the headliner as the airbag inflates may cause the left and/or right side second row overhead assist grip to detach from its mounting brackets if the temperature in the roof rail area is high from outside ambient temperature. If an assist grip were to completely detach, it could contact an occupant, which would increase the risk of injury in the event of a crash. Correction: Dealers will modify the headliner near the second row overhead assist grips. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.