Service bulletins for the 2010 Toyota Sienna
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
275 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Body and frame are shown. Show all
| T-SB-0094-21 | 2021-12-13. Service bulletin. STRUCTURE. TSB: Some 2005 ? 2022 model year Toyota vehicles that have undergone water intrusion may exhibit a condition in which a musty smell is present. Follow the procedures in this bulletin to remediate the odor and address this condition. The purpose of this service bulletin is to provide general guidelines and procedures for odor remediation. This service bulletin provides a guide on how to prepare the interior of the vehicle prior to an odor remediation being performed, as well as contact information for an approved vendor who will arrange the remediation, and instructions on how to prepare the interior of the vehicle for reassembly once the remediation has been completed. Refer to all model and model year specific Repair Manuals and the EPA (Environmental Protection Agency) website for the most up-to-date safety and precautionary guidelines. This service bulletin is to provide a general overview and direction for the odor remediation process. |
|---|---|
| T-SB-0004-21 Rev | 2021-06-21. Service bulletin. STRUCTURE:BODY:DOOR; VISIBILITY:GLASS, SIDE/REAR. TSB: Some 2010 ? 2020 model year Sienna vehicles may exhibit a condition where the front door glass run on either the right-hand or left-hand side comes loose from the door channel during window operation. Follow the Repair Procedure in this bulletin to address this condition. |
| T-TT-0415-16 | 2018-12-03. Service bulletin. STRUCTURE:BODY:DOOR:HINGE AND ATTACHMENTS. TT: Sienna Sliding door not moving/stuck due to cable binding and/or cable mis-routing at central hinge. This applies to sliding door cables without damage to the coating (Fraying/cracking/breaking) present. Please look and verify condition of the cable coating before proceeding. Refer to attached file for details of both cable conditions. |
| T-TT-0415-16 | 2018-11-26. Service bulletin. LATCHES/LOCKS/LINKAGES:DOORS:LATCH; STRUCTURE:BODY:DOOR. TT: Sienna Sliding door not moving/stuck due to cable binding and/or cable mis-routing at central hinge. This applies to sliding door cables without damage to the coating (Fraying/cracking/breaking) present. Please look and verify condition of the cable coating before proceeding. Refer to attached file for details of both cable conditions. |
| T-SB-0044-16 | 2018-07-02. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; STRUCTURE. TSB: On some vehicles, when Rapgard? is removed, the paint may have a stained appearance. These stains appear to be under the clear coat (repainting this area is not necessary). The stain patterns are usually under wrinkles in the Rapgard?. These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture, especially on horizontal surfaces, such as the hood, roof, and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. |
| T-SB-0044-16 | 2018-06-11. Service bulletin. STRUCTURE:BODY. TSB: On some vehicles, when Rapgard? is removed, the paint may have a stained appearance. These stains appear to be under the clear coat (repainting this area is not necessary). The stain patterns are usually under wrinkles in the Rapgard?. These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture, especially on horizontal surfaces, such as the hood, roof, and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. |
| WPB (POL 14-11)_ | 2018-04-23. Service bulletin. STRUCTURE. WPB: Toyota has received reports where some vehicles may exhibit cracked and/or sticky/melting dashboards as a result of heat or humidity. In Mid-December, 2014 Toyota announced the reimbursement Phase of this warranty enhancement program. Since prior to that announcement, Toyota has been diligently making parts preparations for the parts replacement phase of this Program. Due to the age, volume, and breadth of the covered vehicles subject to the Program and the size and complexity of dashboard manufacturing, Toyota will be launching the part replacement portion of this Program in several phases; please refer to the table below for part replacement model phasing. Although Toyota is increasing production levels, it is difficult to predict customer demand and where parts need to be shipped to support customer demand. It is important that dealerships explain to customers that there still may be a period of time the customer will need to wait before part replacement can be performed. Please be sure to take this into consideration when performing customer scheduling. |
| T-SB-0187-12 | 2018-04-23. Service bulletin. STRUCTURE:BODY. Toyota vehicles are equipped with either conventional or run-flat tires. Sometimes punctures may occur as a result of contact with road debris or other hazards. If a puncture occurs, it may be possible to repair the tire and return it to service. With a conventional tire it is not possible to drive for an extended amount of time with the tire at low pressures as damage to the tire may occur. With run-flat tires, due to reinforced sidewalls, it is possible to drive for up to 100 miles (160 km) at speeds less than 55 mph (90 km/h) with little or no damage to the tire. |
| T-TT-0415-16 Rev | 2018-04-02. Service bulletin. STRUCTURE:BODY:DOOR:HINGE AND ATTACHMENTS. TT: Sienna Sliding door not moving/stuck due to cable binding and/or cable mis-routing at central hinge. This applies to sliding door cables without damage to the coating (fraying/cracking/breaking) present. Please look and verify condition of the cable coating before proceeding. Refer to the following for details of both cable conditions. |
| T-SB-0141-10 Rev | 2018-04-02. Service bulletin. STRUCTURE:EMERGENCY:ESCAPE/EGRESS/EXIT; BACK OVER PREVENTION. If a creak, tick, or rattle noise is heard at the top or bottom of the windshield, or at the top of the rear glass, the source of the noise may be the two stoppers bonded to the top of the windshield/rear glass, or the windshield retainers bonded to the lower edge of the windshield. This bulletin provides the recommended repair procedure to eliminate these types of noises from the windshield/rear glass area. |
| T-SB-0044-16_Rev | 2018-04-02. Service bulletin. STRUCTURE:BODY. TSB: REVISION NOTICE March 07, 2017 Rev1: ? Applicability has been updated to include 2017 model year Toyota vehicles. On some vehicles, when Rapgard? is removed the paint may have a stained appearance. These stains appear to be under the clear coat (repainting this area is NOT necessary). The stain patterns are usually under wrinkles in the Rapgard?. These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture, especially on horizontal surfaces, such as the hood, roof, and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. |
| T-SB-0304-17 | 2017-11-14. Service bulletin. STRUCTURE:BODY:DOOR. TSB: Vehicle replacement certification labels (the vinyl label installed on the driver door or door post) and VIN plates (the metal plate riveted to dashboard) may be available from Toyota, provided the request meets one of the criteria listed in this Service Bulletin. |
| ESS_ Special Ser | 2017-08-15. Service bulletin. STRUCTURE; EQUIPMENT ADAPTIVE/MOBILITY. Dealer Package: Toyota has received reports indicating that some vehicles experienced symptoms of the condition in Special Service Campaign A7E after being inspected and/or repaired. |
| T-SB-0040-08 | 2017-08-14. Service bulletin. STRUCTURE:BODY. TSB: On some vehicles, when Rapgard is removed, the paint may have a stained appearance. These stains appear to be under the clear coat (repainting this area is not necessary). The stain patterns are usually under wrinkles in the Rapgard. These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture, especially on horizontal surfaces, such as the hood, roof, and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. |
| ZE6_WEP_Dealer L | 2017-08-14. Service bulletin. STRUCTURE; EQUIPMENT. DL: In our continuing efforts to ensure the best in customer satisfaction, Toyota is announcing a Warranty Enhancement Program (the "Program"). This Program extends the warranty coverage for repairs related to cracked and/or sticky/melting Dashboards (Instrument Panels) as a result of heat or humidity on 2003 - 2005 model year 4Runner, 2005 - 2010 model year Avalon, 2007 - 2011 model year Camry and Camry Hybrid, 2004 -2010 model year Sienna, and 2004 - 2008 model year Solara vehicles. In Mid-December, 2014 Toyota announced the reimbursement Phase of this Program. Since prior to that announcement, Toyota has been diligently making parts preparations for the parts replacement phase of this Program. Due to the age, volume, and breadth of the covered vehicles subject to the Program and the size and complexity of dashboard manufacturing, Toyota will be launching the part replacement portion of this Program is several phases; please refer to the table below for part replacement model phasing. |
| ZE6_WEP_Region L | 2017-08-14. Service bulletin. EQUIPMENT; STRUCTURE. RL: In our continuing efforts to ensure the best in customer satisfaction, Toyota is announcing a Warranty Enhancement Program (the "Program"). This Program extends the warranty coverage for repairs related to cracked and/or sticky/melting Dashboards (Instrument Panels) as a result of heat or humidity on 2003 - 2005 model year 4Runner, 2005 - 2010 model year Avalon, 2007 - 2011 model year Camry and Camry Hybrid, 2004 - 2010 model year Sienna, and 2004 - 2008 model year Solara vehicles. |
| T-SB-0040-08 | 2017-08-14. Service bulletin. STRUCTURE:BODY. TSB: On some vehicles, when Rapgard is removed, the paint may have a stained appearance. These stains appear to be under the clear coat (repainting this area is not necessary). The stain patterns are usually under wrinkles in the Rapgard. These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture, especially on horizontal surfaces, such as the hood, roof, and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. |
| WPB (POL 14-11)_ | 2017-03-31. Service bulletin. STRUCTURE; EQUIPMENT. "WPB: TOYOTA HAS RECEIVED REPORTS WHERE SOME VEHICLES MAY EXHIBIT CRACKED AND/OR STICKY/MELTING DASHBOARDS AS A RESULT OF HEAT OR HUMIDITY. IN MID-DECEMBER, 2014 TOYOTA ANNOUNCED THE REIMBURSEMENT PHASE OF THIS WARRANTY ENHANCEMENT PROGRAM. SINCE PRIOR TO THAT ANNOUNCEMENT, TOYOTA HAS BEEN DILIGENTLY MAKING PARTS PREPARATIONS FOR THE PARTS REPLACEMENT PHASE OF THIS PROGRAM. DUE TO THE AGE, VOLUME, AND BREADTH OF THE COVERED VEHICLES SUBJECT TO THE PROGRAM AND THE SIZE AND COMPLEXITY OF DASHBOARD MANUFACTURING, TOYOTA WILL BE LAUNCHING THE PART REPLACEMENT PORTION OF THIS PROGRAM IN SEVERAL PHASES; PLEASE REFER TO THE TABLE BELOW FOR PART REPLACEMENT MODEL PHASING. ALTHOUGH TOYOTA IS INCREASING PRODUCTION LEVELS, IT IS DIFFICULT TO PREDICT CUSTOMER DEMAND AND WHERE PARTS NEED TO BE SHIPPED TO SUPPORT CUSTOMER DEMAND. IT IS IMPORTANT THAT DEALERSHIPS EXPLAIN TO CUSTOMERS THAT THERE STILL MAY BE A PERIOD OF TIME THE CUSTOMER WILL NEED TO WAIT BEFORE PART REPLACEMENT CAN BE PERFORMED. PLEASE BE SURE TO TAKE THIS INTO CONSIDERATION WHEN PERFORMING CUSTOMER SCHEDULING." |
| T-TT-0246-13 | 2016-04-12. Service bulletin. STRUCTURE:EMERGENCY:ESCAPE/EGRESS/EXIT. SUMMARY TO BE PROVIDED ON A FUTURE DATE. |
| SB-0280-10 | 2011-04-18. Service bulletin. STRUCTURE:BODY:DOOR; STRUCTURE:BODY:HATCHBACK/LIFTGATE. TOYOTA: SOME VEHICLES MAY EXHIBIT A CONDITION WHERE ONE OR BOTH SLIDING DOORS DO NOT OPEN OR CLOSE SMOOTHLY. INSPECT THE SLIDING DOOR LOCK ASSEMBLIES AND REPLACE THE AFFECTED COMPONENTS AS NEEDED, ACCORDING TO THE LISTED INSTRUCTIONS. *PE |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.