WenmarOpen by Wenmar Pro

Service bulletins for the 2020 Toyota RAV4

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

347 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Electrical system are shown. Show all

Bulletins, newest first
T-TT-0588-192020-02-24. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM. TT: Some 2020 model year vehicles may display abnormal Safety Connect operation during PDS due to DCM activation issues. This condition is characterized by no DTCs present and after the initial SOS light flashing sequence after ignition on, neither the red nor green light stays on in the overhead console. To determine if a vehicle is experiencing this condition, connect a Techstream and navigate to: Telematics-Data List - ?Telematics Activation Status?. If this value is displayed as ?Shipping?, continue to the recommendations below, and do not create a TAS case.
T-SB-0006-19_Rev2020-02-18. Service bulletin. ELECTRICAL SYSTEM. TSB: REVISION NOTICE January 15, 2020 Rev2: ? The entire bulletin has been updated. February 11, 2019 Rev1: ? The Introduction and Every Two Months sections have been updated. Any previous printed versions of this bulletin should be discarded. Hybrid vehicles are equipped with two types of batteries: ? Hybrid Vehicle (HV) battery ? Auxiliary (12V) battery If the hybrid vehicle is put into storage, the State-Of-Charge (SOC) of its HV battery and auxiliary battery will gradually decrease. To prevent the auxiliary battery from becoming discharged during storage, proper maintenance is necessary. Perform the following maintenance service for the HV battery and auxiliary battery. NOTE ? BEFORE disconnecting the auxiliary battery, confirm the shift lever is in the ?P? position and apply the parking brake completely. The shift lever CANNOT be shifted from the ?P? position with the auxiliary battery disconnected. ? If the negative (?) terminal of the auxiliary battery is reconnected, even if the vehicle is powered ON (Ready ON), the hybrid system may NOT start. In this case, depress the brake pedal and press the Power button to start the hybrid system (the Ready light is ON). If the hybrid system still does NOT start (the Ready light is OFF), refer to the Repair Manual.
T-TT-0593-20_Rev2020-02-18. Service bulletin. ELECTRICAL SYSTEM. TT: Some customers may experience the inability to activate Remote Connect or Remote Connect becoming inoperative when attempting to send commands to the vehicle. To simplify the diagnosis of this system and prevent the unnecessary replacement of parts, please refer to the procedure below.
T-TT-0588-192020-01-27. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; ELECTRICAL SYSTEM. TT: Some 2020 model year vehicles may display abnormal Safety Connect operation during PDS due to DCM activation issues. This condition is characterized by no DTCs present and after the initial SOS light flashing sequence after ignition on, neither the red nor green light stays on in the overhead console. To determine if a vehicle is experiencing this condition, connect a Techstream and navigate to: Telematics-Data List - ?Telematics Activation Status?. If this value is displayed as ?Shipping?, continue to the recommendations below, and do not create a TAS case.
T-TT-0572-19_Rev2019-12-16. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT. TT: Some 2020 model year Camry, Camry HV and Corolla Hatchback vehicles equipped with a DCM may exhibit a B15A8** DTC in history during PDS. This DTC can be triggered during the manufacturing and /or shipping process and does not indicate a problem with the vehicle. To simplify the diagnosis of this DTC, refer to the procedure below to prevent unnecessary parts replacement.
T-TT-0442-17_Rev2019-12-16. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM). TT: Safety Connect is a vehicle option which requires a subscription fee for the system to be active after the initial trial period. Once the subscription has expired the DCM (Telematics Transceiver) will be in an inactive state. In some instances, a DCM may need to be replaced even though the customer is not using the service. If registration of the replacement DCM part is attempted using the Techstream utility after the account has become inactive, the registration will fail, and messages such as ?ATX webserver is Down? or ?ATX error? will be displayed.
T-TT-0573-192019-10-15. Service bulletin. ELECTRICAL SYSTEM. TT: Some customers may experience a call failure when attempting to call a conference call number that has been saved in their phonebook (ex: ?8005550122,,,1.,2;;;2#?). This issue is caused by changes to the Bluetooth in the iOS 13 update and may be resolved in a future iOS update.
T-TT-0553-192019-09-03. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT. TT: The new DCA-8000 Diagnostic Charger may cause your facility?s Ground Fault Circuit Interrupter (GFCI) breaker to trip. A GFCI breaker can be tripped for various reasons, one of the reasons may be related to the DCA-8000. We are investigating this issue to determine the root cause. Other reasons the GFCI breaker may trip ? Circuit demand is too high for GFCI rating ? Worn out GFCI internal contacts ? Improper installation or wiring of GFCI breaker
T-SB-0134-16-Rev2019-09-03. Service bulletin. POWER TRAIN; ELECTRICAL SYSTEM; ENGINE. TSB: REVISION NOTICE July 01, 2019 Rev2: ? Applicability has been updated to 2019 ? 2020 model year Toyota vehicles. ? The Techstream Preparation and Process Overview sections have been updated. October 30, 2017 Rev1: ? Applicability has been updated to include 2018 model year vehicles. Any previous printed versions of this bulletin should be discarded. SUPERSESSION NOTICE The information contained in this bulletin supersedes SB No. T-SB-0012-13. Service Bulletin No. T-SB-0012-13 is obsolete and any printed versions should be discarded. Be sure to review the entire content of this bulletin before proceeding. Flash reprogramming allows the Electronic Control Unit (ECU) software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard (CUW). Flash calibration updates can only be applied to the vehicle/ECU combination for which they are intended. ECUs have internal security that will not allow them to be programmed with another ECU?s information. NOTE ECU is a Toyota term used to describe integrated computerized devices responsible for managing the operation of a system or subsystem. For the purposes of this bulletin, the term ?ECU? is used as a generic label for the following SAE J1930 standard references: ? Powertrain Control Module (PCM) ? Engine Control Module (ECM) ? Transmission Control Module (TCM) ? Any other Toyota specific control unit
T-TT-0549-192019-07-15. Service bulletin. ELECTRICAL SYSTEM. TT: The new 12V Battery Warranty Testers (DSS-5000 & DCA-8000) require certain information to generate a test result and warranty code. Below is an explanation of what information is required when testing a 12V battery on the new Warranty Battery Testers.
T-SB-0064-18_Rev2019-07-15. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM. TSB: REVISION NOTICE June 17, 2019 Rev1: ? Applicability has been updated to include 2019 ? 2020 model year Corolla Hatchback, RAV4, and RAV4 Hybrid and 2020 model year Corolla and Corolla Hybrid vehicles. ? The Required Tools & Equipment section has been updated. Any previous printed versions of this bulletin should be discarded. The Immobilizer and Smart Key Reset is a feature that allows the registration of new keys when all master keys are lost. Once the system is reset, all previously registered keys will be erased and can never be reused. Another feature, Add/Remove Key, is also available. Once a key is removed, it can never be reused. Follow the procedures in this bulletin to reset a vehicle Immobilizer or Smart Key system and to add and/or remove a key. NOTICE When performing a Smart Code Reset, ALL registered keys are erased and CANNOT be used again on ANY vehicle. For Undesignated Key Permanent Erasure utility, ONLY the keys that are NOT present will be removed. ANY keys that are NOT present can never be reused.
T-SB-0007-192019-02-19. Service bulletin. ELECTRICAL SYSTEM. TSB: A battery in a stored vehicle is subject to conditions that can reduce its performance and life. These conditions include storage period, temperature, parasitic drain, and battery load. Because of these factors, battery inspection and maintenance are required in order to ensure proper operation and optimal battery life. As a matter of policy, Toyota does not provide battery warranty coverage for discharged and/or failed batteries due to lack of maintenance. It is the dealer?s responsibility to maintain the specified State-Of-Charge (SOC) of the vehicle?s battery while in stock and ensure proper SOC at delivery. To eliminate customer service concerns due to an undercharged battery during the first few weeks of ownership, ALL dealers should check battery SOC and recharge, if necessary, within 48 hours of delivery to customers.
T-SB-0006-192019-02-19. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY. TSB: Hybrid vehicles are equipped with two types of batteries: ? Hybrid Vehicle (HV) battery ? Auxiliary (12V) battery If the hybrid vehicle is put into storage, the State-Of-Charge (SOC) of its HV battery and auxiliary battery will gradually decrease. To prevent the auxiliary battery from becoming discharged during storage, proper maintenance is necessary. Perform the following maintenance service for the HV battery and auxiliary battery. NOTE ? BEFORE disconnecting the auxiliary battery, confirm the shift lever is in the ?P? position and apply the parking brake completely. The shift lever CANNOT be shifted from the ?P? position with the auxiliary battery disconnected. ? If the negative (?) terminal of the auxiliary battery is reconnected, even if the Power button is in the Start mode, the hybrid system may NOT start. In this case, push the Power button and select the Start mode again to start the hybrid system (the Ready light is ON). If the hybrid system still does NOT start (the Ready light is OFF), refer to the Repair Manual.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.