WenmarOpen by Wenmar Pro

Service bulletins for the 2020 Toyota LAND CRUISER

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

93 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Bulletins, newest first
T-TT-0520-19_Rev2020-02-18. Service bulletin. EQUIPMENT. TT: In certain cases of leaking air conditioning systems, the root cause of the leak is inadvertently overlooked, causing a repeat repair. To improve customer satisfaction and repair A/C system leaks in one dealer visit, Toyota has developed a set of guidelines for evaluating A/C system components.
T-SB-0009-19_Rev2020-02-18. Service bulletin. EQUIPMENT. TSB: REVISION NOTICE January 22, 2020 Rev1: ? The Battery subsection has been updated. Any previous printed versions of this bulletin should be discarded. Long-term or off-site storage requires special care to keep vehicles factory fresh and ready for delivery. The following guidelines should be performed to minimize vehicle component/part degradation due to extended vehicle storage conditions. Long-term storage can affect a vehicle?s systems and components. Any problems that are found should be corrected immediately.
T-SB-0008-202020-02-18. Service bulletin. EQUIPMENT. TSB: Vehicles may display evidence of a fluid leak or fluid seep from powertrain components. This bulletin explains how to determine the differences between a fluid leak versus a fluid seep. Cases that are determined to be a ?leak? should be repaired accordingly and will be covered under warranty if applicable. Cases that are determined to be a ?seep? should be documented on the repair order and inspected at the next service interval. Follow the Repair Information in this bulletin to determine if the concern in question is a fluid leak or fluid seep and review the Repair Procedure section to address the condition. NOTE This bulletin applies to ALL powertrain fluids excluding fuel and coolant.
T-SB-0007-19_Rev2020-02-18. Service bulletin. EQUIPMENT. TSB: REVISION NOTICE January 24, 2020 Rev1: ? The entire bulletin has been updated. Any previous printed versions of this bulletin should be discarded. A battery in a stored vehicle is subject to conditions that can reduce its performance and service life. These conditions include storage period, temperature, parasitic drain, and battery load. Because of these factors, battery inspection and maintenance are required in order to ensure proper operation and optimal battery life. As a matter of policy, Toyota does not provide battery warranty coverage for discharged and/or failed batteries due to lack of maintenance. It is the dealer?s responsibility to maintain the specified State-Of-Charge (SOC) of the vehicle?s battery while in stock and ensure proper SOC at delivery. To eliminate customer service concerns due to an undercharged battery during the first few weeks of ownership, ALL dealers should check battery SOC and recharge, if necessary, no more than 48 hours before to customer delivery.
T-TT-0470-17_Rev2020-01-27. Service bulletin. SEAT BELTS; BACK OVER PREVENTION. TT: All grades of 2018-2020 model year Mirai, Sienna, CH-R, and 2020 model year Land Cruiser, Prius, and Prius Prime vehicles are not compatible with Toyota Remote Connect app features. The Toyota Remote Connect mobile app lets you lock and unlock doors, start the engine, find your vehicle in a parking lot, and monitor guest drivers.
T-TT-0442-17_Rev2019-12-16. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM). TT: Safety Connect is a vehicle option which requires a subscription fee for the system to be active after the initial trial period. Once the subscription has expired the DCM (Telematics Transceiver) will be in an inactive state. In some instances, a DCM may need to be replaced even though the customer is not using the service. If registration of the replacement DCM part is attempted using the Techstream utility after the account has become inactive, the registration will fail, and messages such as ?ATX webserver is Down? or ?ATX error? will be displayed.
T-SB-0111-192019-09-16. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. TSB: Pre-Delivery Service (PDS) is a critical step in satisfying our new car customers. Customer feedback indicates the following areas deserve special attention when performing PDS: * Careful inspection for paint chips/scratches and body dents/dings. * Proper operation of electrical accessories. * Interior cleanliness. * Proper function of mechanical systems. Customer retention and proper maintenance of vehicles are and have always been a major focus for Toyota. To help remind customers that regular service is essential to the proper maintenance of the vehicle, dealers are required to install a service reminder sticker prior to delivery. By doing this, customers will be reminded to return to your dealership for service. Your current service reminder sticker may be used. (See PDS Check Sheet item 9 of "Final Inspection and Cleaning.") A new PDS Check Sheet has been developed for the 2020 model year Land Cruiser. Some check points have been added, expanded, or clarified. Bulletins are available for items in bold type.
T-SB-0103-192019-09-16. Service bulletin. EQUIPMENT. TSB: To avoid damage to the roof rack cross bars during transportation, the 2020 model year Land Cruiser roof rack cross bars have been placed inside the vehicle at the assembly plant. Install the roof rack cross bars during Pre-Delivery Service (PDS) using the following procedure.
T-SB-0158-18-Rev2019-09-03. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. TSB: REVISION NOTICE July 03, 2019 Rev1: ? Applicability has been updated to include 2020 model year Supra vehicles. ? The Hook and Loop Style section has been added. Any previous printed versions of this bulletin should be discarded. 2020 model year Toyota vehicles are equipped with driver side floor mat retainers to secure the floor mat in the correct position. In addition, some models may also utilize retainers for passenger side and rear seat floor mats. During Pre-Delivery Service (PDS), follow the appropriate Installation Procedure to attach the driver side, and if applicable, the passenger side and rear seat floor mats to the vehicle carpet using the floor mat retainers. If installation instructions are included in the floor mat kit, place the instructions in the vehicle?s glove box for customer reference. CAUTION ? ALWAYS verify the floor mat is designed specifically for the model and model year it is being installed in. ? ONLY use floor mats that can be secured using the retainers. ALL OEM Toyota floor mats are specifically designed to fit correctly and be secured using the retainers. ? Make sure the floor mat is properly placed on the vehicle carpet and secured with the retainers. If the driver side floor mat is NOT properly placed and secured, it could slip and interfere with the movement of the pedals during driving and may cause an accident. ? Verify the operation of the accelerator, brake, and clutch (if equipped) pedals and clearance to the mat. ? NEVER install more than one floor mat at a time in the driver?s seating position. ? If applicable, ANY secondary set of floor mats (based upon customer preference, such as the all-weather floor mats or other floor mats) MUST be placed in the trunk with ALL the packaging material intact. Do NOT install the secondary mat on top of the primary floor mat already installed in the driver?s seating position.
T-SB-0134-16-Rev2019-09-03. Service bulletin. POWER TRAIN; ELECTRICAL SYSTEM; ENGINE. TSB: REVISION NOTICE July 01, 2019 Rev2: ? Applicability has been updated to 2019 ? 2020 model year Toyota vehicles. ? The Techstream Preparation and Process Overview sections have been updated. October 30, 2017 Rev1: ? Applicability has been updated to include 2018 model year vehicles. Any previous printed versions of this bulletin should be discarded. SUPERSESSION NOTICE The information contained in this bulletin supersedes SB No. T-SB-0012-13. Service Bulletin No. T-SB-0012-13 is obsolete and any printed versions should be discarded. Be sure to review the entire content of this bulletin before proceeding. Flash reprogramming allows the Electronic Control Unit (ECU) software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard (CUW). Flash calibration updates can only be applied to the vehicle/ECU combination for which they are intended. ECUs have internal security that will not allow them to be programmed with another ECU?s information. NOTE ECU is a Toyota term used to describe integrated computerized devices responsible for managing the operation of a system or subsystem. For the purposes of this bulletin, the term ?ECU? is used as a generic label for the following SAE J1930 standard references: ? Powertrain Control Module (PCM) ? Engine Control Module (ECM) ? Transmission Control Module (TCM) ? Any other Toyota specific control unit
T-TT-0549-192019-07-15. Service bulletin. ELECTRICAL SYSTEM. TT: The new 12V Battery Warranty Testers (DSS-5000 & DCA-8000) require certain information to generate a test result and warranty code. Below is an explanation of what information is required when testing a 12V battery on the new Warranty Battery Testers.
T-SB-0073-192019-07-15. Service bulletin. STRUCTURE; EQUIPMENT. TSB: TMNA Accessory Sales and Marketing has developed a Toyota paint protection film (PPF) decal (treated with a specially developed light adhesive) for 2019 ? 2020 model year Toyota vehicles. The decal comes in two sizes (2.8 in. x 8 in. and 4 in. x 8 in.) for small and large hoods and will be applied to the top of PPF for all series at TLS accessory installation facilities. The decal is intended to stay affixed to the film until delivery detail/wash. Just before customer delivery, follow the procedure in this Service Bulletin to remove the decal and any residue left by the adhesive.
T-TT-0537-192019-05-13. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; VISIBILITY; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; LANE DEPARTURE. TT: The blind spot monitor (BSM) sensor angle inspection is used to confirm that the BSM sensor is within the specified angle before performing axis beam adjustment. When used in conjunction with the repair manual, these BSM tips leverage SSTs and readily available tools to support sensor angle confirmation in varying shop environments.
T-TT-0468-17-Rev2019-03-25. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER. TT: HVAC drain tube is found to be blocked/clogged.
TSB-0009-192019-02-19. Service bulletin. EQUIPMENT. TSB: Long-term or off-site storage requires special care to keep vehicles factory fresh and ready for delivery. The following guidelines should be performed to minimize vehicle component/part degradation due to extended vehicle storage conditions. Long-term storage can affect a vehicle?s systems and components. Any problems that are found should be corrected immediately.
T-SB-0007-192019-02-19. Service bulletin. ELECTRICAL SYSTEM. TSB: A battery in a stored vehicle is subject to conditions that can reduce its performance and life. These conditions include storage period, temperature, parasitic drain, and battery load. Because of these factors, battery inspection and maintenance are required in order to ensure proper operation and optimal battery life. As a matter of policy, Toyota does not provide battery warranty coverage for discharged and/or failed batteries due to lack of maintenance. It is the dealer?s responsibility to maintain the specified State-Of-Charge (SOC) of the vehicle?s battery while in stock and ensure proper SOC at delivery. To eliminate customer service concerns due to an undercharged battery during the first few weeks of ownership, ALL dealers should check battery SOC and recharge, if necessary, within 48 hours of delivery to customers.
T-SB-0002-192019-02-19. Service bulletin. TIRES. TSB: During the manufacturing process, tires are mounted on the vehicle as matched sets to help reduce conditions such as pulling or drifting. If the wheels are replaced or refinished before vehicle delivery, it is important that the tires remain on the vehicle in the same location and in the same direction of rotation. Refer to the Tire Positioning Procedure in this bulletin to ensure that the original tires stay in the same location on the vehicle.
T-SB-0158-182019-02-19. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. TSB: 2020 model year Toyota vehicles are equipped with driver side floor mat retainers to secure the floor mat in the correct position. In addition, some models may also utilize retainers for passenger side and rear seat floor mats. During Pre-Delivery Service (PDS), follow the appropriate Installation Procedure to attach the driver side, and if applicable, the passenger side and rear seat floor mats to the vehicle carpet using the floor mat retainers. If installation instructions are included in the floor mat kit, place the instructions in the vehicle?s glove box for customer reference.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.