Service bulletins for the 2008 Toyota Highlander
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
302 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Backup camera are shown. Show all
| TTT063620 | 2022-06-21. Service bulletin. BACK OVER PREVENTION; SERVICE BRAKES, HYDRAULIC. TT: Some Toyota vehicles installed with Toyota Complete Maintenance Care (TCMC) brake pads may exhibit a groan or squeak noise in various driving conditions |
|---|---|
| T-TT-0636-20 Rev | 2021-04-19. Service bulletin. BACK OVER PREVENTION; SERVICE BRAKES. TT: Some Toyota vehicles installed with Toyota Complete Maintenance Care (TCMC) brake pads may exhibit a groan or squeak noise in various driving conditions. |
| T-TT-0636-20 | 2021-02-16. Service bulletin. BACK OVER PREVENTION; SERVICE BRAKES. TT: Some Toyota vehicles installed with Toyota Complete Maintenance Care (TCMC) brake pads may exhibit a groan or squeak noise in various driving conditions. |
| T-TT-0010-10 Rev | 2018-04-02. Service bulletin. BACK OVER PREVENTION; ENGINE. Tech Tip: Low battery voltage can contribute to a MIL "ON" condition for P0335 (Crankshaft Position Sensor Circuit) and/or P0340 (Camshaft Position Sensor Circuit) due to inconsistent rotational speed of the engine's crankshaft. |
| T-SB-0141-10 Rev | 2018-04-02. Service bulletin. STRUCTURE:EMERGENCY:ESCAPE/EGRESS/EXIT; BACK OVER PREVENTION. If a creak, tick, or rattle noise is heard at the top or bottom of the windshield, or at the top of the rear glass, the source of the noise may be the two stoppers bonded to the top of the windshield/rear glass, or the windshield retainers bonded to the lower edge of the windshield. This bulletin provides the recommended repair procedure to eliminate these types of noises from the windshield/rear glass area. |
| T-SB-0097-13 | 2018-04-02. Service bulletin. POWER TRAIN; BACK OVER PREVENTION. Some 2008 ? 2013 model year Highlander vehicles equipped with the 5-speed automatic transaxle may exhibit a whine noise from the final drive gear assembly. This noise is noticeable above 35 mph. Please refer to the repair procedure to address this condition. |
| T-SB-0001-10 Rev | 2018-04-02. Service bulletin. BACK OVER PREVENTION. Some vehicles may exhibit a MIL ?ON? Diagnostic Trouble Code (DTC) P0138 and/or P0158 (Oxygen Sensor Circuit High Voltage Bank 1 or 2). In some instances a P2195 or P2197 (A/F Sensor Signal Stuck Lean) DTC may also be present. This condition may be caused by incorrect Air Fuel Ratio Sensor response. Additionally, a P0606 (ECM/PCM Processor) DTC may be present due to incorrect Oxygen Sensor operation. The following repair procedures should be used to properly diagnose and repair this condition. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.