Recalls that may apply to the 2006 Toyota Highlander
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Other are shown.
| None found. |
| 2013296 | 2013-09-04. Other. On certain vehicles, a control board for the Intelligent Power Module (IPM), part of the hybrid system inverter assembly, could fail while the vehicle is underway. This could cause various warning lamps, including the malfunction indicator lamp, slip indicator lamp, brake system warning lamp, and master warning lamp, to illuminate on the instrument panel. If this occurred, in most cases, the vehicle would enter fail-safe driving mode, resulting in reduced motive power in which the vehicle could still be driven for short distances. In some instances, the fuse of the power supply circuit could blow, causing the hybrid system to stop functioning. The resultant loss of vehicle propulsion, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the Intelligent Power Module. |
|---|---|
| 2011081 | 2011-02-24. Other. On certain vehicles, if the forward retention clip used to secure the floor carpet cover, which is located in front of the center console, is not installed properly, the cover may lean toward the accelerator pedal and interfere with the operation of the accelerator pedal arm. If this occurs, the accelerator pedal could temporarily become stuck in a partially depressed position, rather than return to the idle position. This could result in a loss of throttle control and a crash causing property damage and/or personal injury. Correction: Dealers will replace the floor carpet cover with a newly designed version. Note: This campaign also covers vehicles which may have been previously included in recall 2006168 (Toyota 609). |
| 2006168 | 2006-07-11. Other. On certain vehicles, due to the improper installation of the retaining clips for the floor carpet cover located in front of the center console, there is a possibility that the clips may become loose. If both clips separate from the floor carpet cover, the cover may lean toward the accelerator pedal, causing interference with the accelerator pedal rod. In the worst case, the accelerator pedal may become stuck in a partially depressed position when returning to the idle position. Correction: Dealers will install new clips. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.