WenmarOpen by Wenmar Pro

Recalls that may apply to the 2004 Toyota Highlander

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

By component

United States: NHTSA, as of 2026-10-19
11V5390002011-11-09. ENGINE AND ENGINE COOLING. TOYOTA IS RECALLING CERTAIN MODEL YEAR 2004 AVALON VEHICLES; 2004 AND 2005 CAMRY, CAMRY SOLARA, HIGHLANDER, AND SIENNA VEHICLES, 2006 HIGHLANDER HYBRID; 2004 AND 2005 LEXUS ES330 AND RX330; AND 2006 LEXUS RX400H VEHICLES MANUFACTURED FROM JUNE 1, 2004 THROUGH MARCH 31, 2005, EQUIPPED WITH THE 1MZ-FE OR 3MZ-FE ENGINE. THE AMOUNT OF ADHESIVE AGENT APPLIED BETWEEN THE OUTER RING AND THE TORSIONAL RUBBER DAMPER (INNER RING) IN THE CRANKSHAFT PULLEY MAY BE INADEQUATE. IF THE ADHESIVE IS INSUFFICIENT, THERE IS A POSSIBILITY THAT THE OUTER RING MAY BECOME MISALIGNED AND IT MAY NOT PROPERLY ROTATE WITH THE INNER RING, CAUSING NOISE AND/OR ILLUMINATION OF THE BATTERY DISCHARGE INDICATOR LIGHT. Built 2004-06-01 to 2005-03-31.
11V1120002011-02-24. VEHICLE SPEED CONTROL:ACCELERATOR PEDAL. TOYOTA IS RECALLING CERTAIN MODEL YEAR 2004-2006 HIGHLANDER, HIGHLANDER HYBRID, AND MODEL YEAR 2004-2007 LEXUS RX330, RX350, AND RX400H VEHICLES. IF THE FORWARD RETENTION CLIP USED TO SECURE THE FLOOR CARPET COVER, WHICH IS LOCATED IN FRONT OF THE CENTER CONSOLE, IS NOT INSTALLED PROPERLY THE COVER MAY LEAN TOWARD THE ACCELERATOR PEDAL AND INTERFERE WITH THE ACCELERATOR PEDAL ARM. Built 2003-08-22 to 2006-07-26.
10V4990002010-10-21. SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:MASTER CYLINDER. TOYOTA IS RECALLING CERTAIN MODEL YEAR 2005-2006 AVALON, MODEL YEAR 2004-2006 HIGHLANDER, MODEL YEAR 2004-2006 LEXUS RX, AND MODEL YEAR 2006 LEXUS GS AND IS VEHICLES. BRAKE FLUID CONTAINING POLYMERS IS USED THAT ACTS AS LUBRICANTS FOR CERTAIN BRAKE SYSTEM COMPONENTS. IF REPLACEMENT BRAKE FLUID IS USED THAT DOES NOT CONTAIN SUCH POLYMERS, OR THAT CONTAINS ONLY SMALL AMOUNTS, A PART OF THE RUBBER SEAL LOCATED AT THE REAR OF THE BRAKE MASTER CYLINDER MAY BECOME DRY, AND THE SEAL MAY CURL DURING MOVEMENT OF THE PISTON. IF THIS OCCURS, A SMALL AMOUNT OF BRAKE FLUID COULD SLOWLY LEAK FROM THE SEAL INTO THE BRAKE BOOSTER.
06V2530002006-07-13. VEHICLE SPEED CONTROL:ACCELERATOR PEDAL. ON CERTAIN SPORT UTILITY AND HYBRID VEHICLES, THE TWO RETAINING CLIPS FOR THE DRIVER'S SIDE FORWARD CENTER CONSOLE CAN BECOME LOOSE. IF BOTH CLIPS SEPARATE FROM THE FLOOR CARPET COVER, THE COVER MAY LEAN TOWARD THE ACCELERATOR PEDAL, CAUSING INTERFERENCE WITH THE ACCELERATOR PEDAL ROD. Built 2003-08-22 to 2005-05-24.
04V1810002004-04-15. LATCHES/LOCKS/LINKAGES:DOORS:LATCH. CERTAIN SPORT UTILITY VEHICLES HAVE A CHILD PROTECTION LOCK (CPL) SYSTEM ON BOTH OF THE REAR SIDE DOORS. WHEN AN OPERATOR OF THE VEHICLE CLOSES THE DOOR VERY HARD WITH THE CPL LEVER SET TO THE LOCK POSITION, THERE IS A POSSIBILITY THAT THE LEVER MAY CONTACT THE BODY PANEL, CAUSING THE CPL LEVER TO MOVE INTO THE UNLOCK POSITION. Built 2000-11-17 to 2004-01-29.
Canada: Transport Canada, as of 2026-10-19
20113972011-11-09. Steering. On certain vehicles equipped with a 1MZ-FE or 3MZ-FE V6 engine, the crankshaft pulley may fail. The outer ring may become misaligned, or it may not properly rotate, causing noise and/or illumination of the discharge warning light. In addition, the power steering belt may become detached from the crankshaft pulley, which could result in a sudden increase in steering effort. A loss of steering power assist could result in a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the crankshaft pulley.
20110812011-02-24. Other. On certain vehicles, if the forward retention clip used to secure the floor carpet cover, which is located in front of the center console, is not installed properly, the cover may lean toward the accelerator pedal and interfere with the operation of the accelerator pedal arm. If this occurs, the accelerator pedal could temporarily become stuck in a partially depressed position, rather than return to the idle position. This could result in a loss of throttle control and a crash causing property damage and/or personal injury. Correction: Dealers will replace the floor carpet cover with a newly designed version. Note: This campaign also covers vehicles which may have been previously included in recall 2006168 (Toyota 609).
20103612010-10-21. Brakes. Certain vehicles use brake fluids containing polymers that act as lubricants for certain brake system components. If during vehicle maintenance, brake fluid is used that does not contain such polymers or only small amounts, part of the internal rubber seal located at the end of the brake master cylinder piston may become dry and may curl during movement of the piston. If this occurs, a small amount of the brake fluid could slowly leak from the brake master cylinder into the brake booster, resulting in illumination of the brake warning lamp. If the brake warning light has illuminated and the vehicle continues to be operated without refilling the master cylinder brake fluid reservoir, the driver will begin to notice a spongy or soft brake pedal feel and braking performance may gradually decline. This will increase the stopping distance, increasing the likelihood of a crash. Correction: Dealers will replace the brake master cylinder seal with a newly designed one.
20061682006-07-11. Other. On certain vehicles, due to the improper installation of the retaining clips for the floor carpet cover located in front of the center console, there is a possibility that the clips may become loose. If both clips separate from the floor carpet cover, the cover may lean toward the accelerator pedal, causing interference with the accelerator pedal rod. In the worst case, the accelerator pedal may become stuck in a partially depressed position when returning to the idle position. Correction: Dealers will install new clips.
20041272004-04-07. Other. On certain vehicles, if the rear side doors are closed very hard with the Child Protection Lock (CPL) lever in the lock position, there is a possibility that the lock lever may contact the body panel due to insufficient clearance, causing the CPL lever to move into the unlock position. This condition could allow the doors to be opened with the inside door handles while the operator believes that the child protection lock was activated. Correction: Dealer will shorten the CPL levers.

A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.