WenmarOpen by Wenmar Pro

Service bulletins for the 2024 Toyota Grand Highlander

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

140 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
T-SB-0104-21 Rev22026-03-07. Service bulletin. ENGINE. OBSOLETE NOTICE February 27, 2026: This bulletin is no longer applicable and is now obsolete.
T-SB-0060-252025-09-09. Service bulletin. ENGINE. Some customers of 2024 – 2025 model year Grand Highlander Hybrid vehicles may experience one or more of the following complaints when the low fuel level warning light illuminates: •The total amount of fuel dispensed during refueling is less than the customer expects when •the fuel nozzle automatically clicks off, leading to the customer not being able to put as •much fuel into the tank as they expect. •The low fuel level warning light illuminates earlier than the customer expects. •Reduced driving range compared to customers’ expectations, resulting in more frequent •refueling than customers anticipated. The combination meter software logic has been updated to help meet customer expectations.
T-SB-0021-252025-04-08. Service bulletin. ENGINE. Flash reprogramming allows the Electronic Control Unit (ECU) software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Global Techstream+ (GTS+) ECU flash reprogramming procedures and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard+ (CUW+). To ensure the correct ECU software is installed, ECUs will require a Security Signature before the ECU will initialize the flash reprogramming sequence. This bulletin also details the process for acquiring a Security Signature from TIS during the GTS+ ECU flash reprogramming process.
T-SB-0107-20 Rev22025-03-25. Service bulletin. ENGINE. OBSOLETE NOTICE February 11, 2025: This bulletin is now obsolete. Please see T-SB-0021-25.
T-SB-0021-252025-03-11. Service bulletin. ENGINE. Flash reprogramming allows the Electronic Control Unit (ECU) software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Global Techstream+ (GTS+) ECU flash reprogramming procedures and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard+ (CUW+). To ensure the correct ECU software is installed, ECUs will require a Security Signature before the ECU will initialize the flash reprogramming sequence. This bulletin also details the process for acquiring a Security Signature from TIS during the GTS+ ECU flash reprogramming process.
T-SB-0096-242024-11-08. Service bulletin. ENGINE. Some 2023 – 2024 model year Camry, Camry Hybrid, RAV4, and RAV4 Hybrid vehicles and 2024 model year Grand Highlander Hybrid vehicles equipped with an A25A-FKS or an A25A-FXS engine may exhibit an oil leak that originates between the oil pan sub-assembly and the stiffening crankcase assembly.
24TC052024-11-06. Service campaign. ELECTRICAL SYSTEM; ENGINE. The Engine Control Computer software has a programing error which can cause the exhaust variable valve timing (VVT) locking pin to temporarily get stuck. When this happens, an engine malfunction indicator lamp (MIL) can appear on the dashboard as well as diagnostic trouble code (DTC), P05CE00 to be set.
24TC052024-11-06. Other. ELECTRICAL SYSTEM; ENGINE. SPECIAL SERVICE CAMPAIGN 24TC05 Frequently Asked Questions
24TC052024-11-06. Service bulletin. ELECTRICAL SYSTEM; ENGINE. TECHNICAL INSTRUCTIONS FOR SPECIAL SERVICE CAMPAIGN 24TC05 MALFUNCTION INDICATOR LAMP (MIL) IS ON WITH DTC P05CE00 SOFTWARE UPDATE CERTAIN 2023 & 2024 HIGHLANDER VEHICLES CERTAIN 2024 GRAND HIGHLANDER VEHICLES
24TC052024-11-06. Service campaign. ELECTRICAL SYSTEM; ENGINE. The Engine Control Computer software has a programing error which can cause the exhaust variable valve timing (VVT) locking pin to temporarily get stuck. When this happens, an engine malfunction indicator lamp (MIL) can appear on the dashboard as well as diagnostic trouble code (DTC), P05CE00 to be set.
24TC052024-11-06. Service campaign. ELECTRICAL SYSTEM; ENGINE. The Engine Control Computer software has a programing error which can cause the exhaust variable valve timing (VVT) locking pin to temporarily get stuck. When this happens, an engine malfunction indicator lamp (MIL) can appear on the dashboard as well as diagnostic trouble code (DTC), P05CE00 to be set.
24TC052024-11-06. Other. ELECTRICAL SYSTEM; ENGINE. Frequently Asked Questions Original Publication Date: September 19, 2024
T-SB-0103-20 Rev12024-07-23. Service bulletin. ENGINE. This Service Bulletin provides updated non-electric water pump leak inspection and diagnostic tips for some 2008 – 2025 model year Toyota vehicles.
T-TT-0694-22 Rev22024-07-23. Service bulletin. ENGINE. After jump-starting, the vehicle may experience a no-start condition and multiple DTCs including U010087. Upon investigation, it is found that the engine ECU has been damaged and needs to be replaced. In several cases, it was found that the cause of the ECU damage was improper jump starting. Further investigation found that ECU damage may occur if the negative (ground) cable clamps are attached on or around the engine ECU or ECU mounting bracket.
T-SB-0103-20 Rev12024-07-23. Service bulletin. ENGINE. This Service Bulletin provides updated non-electric water pump leak inspection and diagnostic tips for some 2008 – 2025 model year Toyota vehicles.
T-TT-0694-22 Rev22024-07-23. Service bulletin. ENGINE. After jump-starting, the vehicle may experience a no-start condition and multiple DTCs including U010087. Upon investigation, it is found that the engine ECU has been damaged and needs to be replaced. In several cases, it was found that the cause of the ECU damage was improper jump starting. Further investigation found that ECU damage may occur if the negative (ground) cable clamps are attached on or around the engine ECU or ECU mounting bracket.
T-SB-0120-20 Rev22024-07-06. Service bulletin. ENGINE; ELECTRICAL SYSTEM. Some 2021 – 2024 model year Toyota vehicles may require the download and installation of vehicle specific software or configuration software when the Electronic Control Unit (ECU) is replaced. GTS+ software has been modified to indicate when configuration software is required. A new Configure column has been added to the GTS+ Health Check Results screen to show when configuration software is available for a specific ECU. REVISION NOTICE April 18, 2024 Rev2: •Applicability has been updated to include 2024 model year Tundra, Tundra Hybrid, Venza Hybrid, bZ4X, Corolla, Corolla Cross, Corolla Cross Hybrid, Corolla Hybrid, Crown, GR Corolla, Corolla Hatchback, Prius, Prius Prime, Sequoia Hybrid, Highlander, Grand Highlander, Grand Highlander Hybrid, Land Cruiser, Tacoma, Tacoma Hybrid, and Mirai vehicles and 2023 model year Corolla Hatchback and Prius Prime vehicles. •The Introduction section has been updated. •The Operation Procedure section has been removed. •The Standard ECU Configuration Procedure and ECU Configuration Value Writing Procedure sections have been added.
T-SB-0017-24 Rev12024-07-06. Service bulletin. ENGINE. Some 2024 model year Grand Highlander Hybrid vehicles may exhibit a hesitation when accelerating from 0 – 40 mph with steady throttle. The Engine Control Module (ECM) (SAE term: Powertrain Control Module/PCM) logic has been modified to address this condition. REVISION NOTICE April 15, 2024 Rev1: •The Required Tools & Equipment section has been updated.
T-SB-0017-242024-07-06. Service bulletin. ENGINE. Some 2024 model year Grand Highlander Hybrid vehicles may exhibit a hesitation when accelerating from 0 – 40 mph with steady throttle. The Engine Control Module (ECM) (SAE term: Powertrain Control Module/PCM) logic has been modified to address this condition.
T-SB-0120-20 Rev22024-07-06. Service bulletin. ENGINE; ELECTRICAL SYSTEM. Some 2021 – 2024 model year Toyota vehicles may require the download and installation of vehicle specific software or configuration software when the Electronic Control Unit (ECU) is replaced. GTS+ software has been modified to indicate when configuration software is required. A new Configure column has been added to the GTS+ Health Check Results screen to show when configuration software is available for a specific ECU. REVISION NOTICE April 18, 2024 Rev2: •Applicability has been updated to include 2024 model year Tundra, Tundra Hybrid, Venza Hybrid, bZ4X, Corolla, Corolla Cross, Corolla Cross Hybrid, Corolla Hybrid, Crown, GR Corolla, Corolla Hatchback, Prius, Prius Prime, Sequoia Hybrid, Highlander, Grand Highlander, Grand Highlander Hybrid, Land Cruiser, Tacoma, Tacoma Hybrid, and Mirai vehicles and 2023 model year Corolla Hatchback and Prius Prime vehicles. •The Introduction section has been updated. •The Operation Procedure section has been removed. •The Standard ECU Configuration Procedure and ECU Configuration Value Writing Procedure sections have been added.
T-SB-0017-24 Rev12024-07-06. Service bulletin. ENGINE. Some 2024 model year Grand Highlander Hybrid vehicles may exhibit a hesitation when accelerating from 0 – 40 mph with steady throttle. The Engine Control Module (ECM) (SAE term: Powertrain Control Module/PCM) logic has been modified to address this condition. REVISION NOTICE April 15, 2024 Rev1: •The Required Tools & Equipment section has been updated.
T-SB-0017-242024-07-06. Service bulletin. ENGINE. Some 2024 model year Grand Highlander Hybrid vehicles may exhibit a hesitation when accelerating from 0 – 40 mph with steady throttle. The Engine Control Module (ECM) (SAE term: Powertrain Control Module/PCM) logic has been modified to address this condition.
T-PANT-2024-004-2024-04-15. Service bulletin. ENGINE AND ENGINE COOLING; ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION. This is to advise of various price adjustments that will affect Toyota Genuine Motor Oil and Long Life Coolant, effective March 1, 2024. These products are ordered through the Toyota Complete Maintenance Care (TCMC) website.
TSB0104212024-04-01. Service bulletin. SERVICE BRAKES, HYDRAULIC; ELECTRICAL SYSTEM; ENGINE AND ENGINE COOLING:COOLING SYSTEM; LANE DEPARTURE. TSB: Some 2018 ? 2024 model year Toyota vehicles equipped with an A25A-FKS, A25A-FXS, M20A-FKS, or M20A-FXS engine may exhibit one or more of the following conditions: ?Milky/discolored engine oil. ?An ?Oil Pressure Low? warning message on the Multi-information Display (MID). ?A MIL ON condition with Diagnostic Trouble Codes (DTCs) P05202A (Engine Oil Pressure Sensor/Switch ?A? Signal Stuck in Range) and/or P052477 (Engine Oil Pressure Too Low [Severe]) present. Moisture from blow-by gases condenses and accumulates in the engine oil during short trips in extreme cold weather. When the moisture in the oil freezes, the oil pressure may drop, and the aforementioned warning indicators may display. Follow the procedures in this bulletin to address these conditions.
T-SB-0103-232024-03-04. Service bulletin. ENGINE AND ENGINE COOLING; ELECTRICAL SYSTEM. TSB: Some 2024 model year Grand Highlander vehicles equipped with a T24A-FTS engine may exhibit a MIL ON condition with Diagnostic Trouble Code (DTC) P05CE00 (Cold Start ?B? Camshaft Position Timing Performance Bank 1) present. The Engine Control Module (ECM) (SAE term: Powertrain Control Module/PCM) logic has been modified to reduce the possibility of this condition. Follow the Repair Procedure in this bulletin to address this condition.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.