Service bulletins for the 2011 Toyota FJ Cruiser
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
206 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
| T-SB-0057-18 | 2018-08-20. Service bulletin. EQUIPMENT. TSB: SUPERSESSION NOTICE The information contained in this bulletin supersedes Service Bulletin No. T-SB-0043-14. ? Applicability has been updated to include 2017 ? 2018 model year Toyota vehicles. Service Bulletin No. T-SB-0043-14 is obsolete and any printed versions should be discarded. The Immobilizer and Smart Key Reset is a feature that allows the registration of new keys when all master keys are lost. Once the system is reset, all previously registered keys will be erased. Follow the procedures in this bulletin to reset a vehicle Immobilizer or Smart Key system. NOTE New security provisions are required to obtain a reset passcode. It is critical to review the instructions for this new process BEFORE attempting to get a passcode in the new system. |
|---|---|
| T-SB-0026-15_Rev | 2018-07-16. Service bulletin. POWER TRAIN. TSB: REVISION NOTICE June 8, 2018 Rev2: ? Applicability has been updated to exclude 2016 ? 2017 model year Tacoma vehicles. ? The Repair Procedure section has been updated. May 15, 2017 Rev1: ? Applicability has been updated to include 2016 ? 2017 model year Tacoma and 4Runner vehicles. ? The Introduction section has been updated. Any previous printed versions of this bulletin should be discarded. Some 2004 ? 2017 model year 4Runner vehicles, 2007 ? 2014 model year FJ Cruiser vehicles, and 2005 ? 2015 model year Tacoma vehicles equipped with part-time 4WD may exhibit a cyclical groaning or grinding noise coming from the front differential in 2WD that goes away when operated in 4WD. This noise can be addressed by replacing the needle bearing on the left side of the front differential. Refer to the Repair Procedure for needle bearing roller replacement instructions. |
| T-SB-0047-16 | 2018-07-02. Service bulletin. EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY. TSB: The breather plug should be replaced during any differential/transfer case repairs to prevent possible repeat failures. The subsequent use of the original breather plug after a repair has been found to contribute to the failure of the differential/transfer case components. Replace the breather plug when replacing differential/transfer case components. |
| T-SB-0044-16 | 2018-07-02. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; STRUCTURE. TSB: On some vehicles, when Rapgard? is removed, the paint may have a stained appearance. These stains appear to be under the clear coat (repainting this area is not necessary). The stain patterns are usually under wrinkles in the Rapgard?. These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture, especially on horizontal surfaces, such as the hood, roof, and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. |
| T-SB-0047-16 | 2018-06-11. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. TSB: The breather plug should be replaced during any differential/transfer case repairs to prevent possible repeat failures. The subsequent use of the original breather plug after a repair has been found to contribute to the failure of the differential/transfer case components. Replace the breather plug when replacing differential/transfer case components. |
| T-SB-0044-16 | 2018-06-11. Service bulletin. STRUCTURE:BODY. TSB: On some vehicles, when Rapgard? is removed, the paint may have a stained appearance. These stains appear to be under the clear coat (repainting this area is not necessary). The stain patterns are usually under wrinkles in the Rapgard?. These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture, especially on horizontal surfaces, such as the hood, roof, and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. |
| T-TT-0355-15 | 2018-04-23. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. TechTip: Condition: Customers may experience connectivity issues when the following conditions are met: The customer?s iPhone is operating on iOS9 firmware The customer?s iPhone is connected to the vehicle via Bluetooth. If the vehicle is equipped with a Fujitsu-Ten brand head unit, the customer may complain of one or more of the following: When playing media via Bluetooth audio and pressing the ?Pause? button on the phone, media playback pauses for one second before resuming playback. Yelp searches return an error when search criteria includes a special character, e.g. !,$,#. If the vehicle is equipped with a Pioneer brand head unit, the customer may complain of one or more of the following: The customer?s iPhone does not support the album image feature. When playing media via Bluetooth audio, one or more of a number of play/pause issues occur. |
| T-TT-0086-11 | 2018-04-23. Service bulletin. POWER TRAIN. TechTip: Condition - The vehicle may be difficult to start or have an abnormally low or rough idle after the battery has been disconnected or power to the Engine ECM has been interrupted. |
| TTT-0268-13 Rev3 | 2018-04-23. Service bulletin. ELECTRICAL SYSTEM. TT: Some customers may encounter Bluetooth connectivity concerns such as: ? Difficulty pairing the phone. ? Intermittent Bluetooth failure to connect when first turning on the vehicle. ? Various Bluetooth Audio functions are no longer functioning with the customer?s phone, such as the ability to change the track using the steering wheel controls. These concerns can be caused by changes made on the customer?s phone. Make sure to inquire with the customer if the connectivity concerns occurred after receiving an operating system update on their phone or if they have restored their phone data/settings recently. |
| T-TT-0362-15 | 2018-04-23. Service bulletin. ENGINE; ELECTRICAL SYSTEM:12V/24V/48V BATTERY. TT: The vehicle may be difficult to start or have an abnormally low or rough idle after the battery has been disconnected or power to the Engine ECM has been interrupted. |
| T-TT-0360-15 | 2018-04-23. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.. TT: Customers may experience connectivity issues when the following conditions are met: The customer's iPhone is operating on iOS9 firmware. The customer's iPhone is connected to the vehicle via Bluetooth. The customer may complain of the following issues: When receiving two incoming calls simultaneously, both calls are ended automatically. iTunes Radio app does not play via Bluetooth audio. Podcast and Audiobook media playback is inoperative via Bluetooth audio. |
| TSB-0012-13 Rev2 | 2018-04-23. Service bulletin. ENGINE; ELECTRICAL SYSTEM:SOFTWARE. TSB: Flash reprogramming allows the ECU software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard (CUW). Flash calibration updates can only be applied to the vehicle/ECU combination for which they are intended. ECUs have internal security that will not allow them to be programmed with another ECU?s information. |
| T-SB-0334-08 Rev | 2018-04-23. Service bulletin. SEATS. TSB: Some 2007-2014 model year FJ Cruiser vehicles may exhibit a condition where the driver's seat bottom cushion height set position gradually lowers, requiring the seat to be adjusted back to the desired position. Replace the seat frame assembly to address this condition. |
| T-SB-0187-12 | 2018-04-23. Service bulletin. STRUCTURE:BODY. Toyota vehicles are equipped with either conventional or run-flat tires. Sometimes punctures may occur as a result of contact with road debris or other hazards. If a puncture occurs, it may be possible to repair the tire and return it to service. With a conventional tire it is not possible to drive for an extended amount of time with the tire at low pressures as damage to the tire may occur. With run-flat tires, due to reinforced sidewalls, it is possible to drive for up to 100 miles (160 km) at speeds less than 55 mph (90 km/h) with little or no damage to the tire. |
| T-TT-0005-10 Rev | 2018-04-23. Service bulletin. ENGINE. Starting with the 2010 MY, Toyota began a gradual transition to the use of synthetic 0w-20 viscosity engine oil. |
| T-TT-0005-10 Rev | 2018-04-23. Service bulletin. ENGINE. Starting with the 2010 MY, Toyota began a gradual transition to the use of synthetic 0w-20 viscosity engine oil. |
| T-TT-0213-13 | 2018-04-23. Service bulletin. AIR BAGS. Toyota vehicles are equipped with SRS, including various airbags and in some models, seat belt pre-tensioners, to help reduce the risk of injury in a collision. If a customer expresses any concerns that the SRS airbags or pretensioner devices did not perform as expected, please follow the steps in the recommendations section below. |
| T-SB-0064-10 Rev | 2018-04-23. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This bulletin is now obsolete. Please see T-SB-0012-13. |
| T-SB-0012-13 | 2018-04-23. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Flash reprogramming allows the ECU software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the TIS and the CUW. |
| T-SB-0064-10 Rev | 2018-04-23. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Flash reprogramming allows the ECU software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard (CUW). Flash calibration updates can only be applied to the vehicle/ECU combination for which they are intended. ECUs have internal security that will not allow them to be programmed with another ECU?s information. |
| SST Requirements | 2018-04-23. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. SSTs are key elements to provide your customers with swift and accurate repairs resulting in superior customer satisfaction. |
| T-SB-0391-08 Rev | 2018-04-23. Service bulletin. POWER TRAIN. This bulletin contains general vehicle pulling diagnosis and repair procedures along with specific information to help correct pulling complaints. |
| T-TT-0005-10 | 2018-04-23. Service bulletin. ENGINE. Starting with 2010 Model Year, Toyota began a gradual transition to the use of synthetic 0W-20 viscosity engine oil. There a re man benefits of this oil. |
| T-SB-0229-12_Rev | 2018-04-23. Service bulletin. ELECTRICAL SYSTEM. TSB: REVISION NOTICE November 22, 2017 Rev1: ? Applicability has been updated to include 2014 ? 2018 model year vehicles. Any previous printed versions of this bulletin should be discarded. In the event that a Toyota vehicle becomes submerged in water, many components may be physically damaged. Electrical and electronic components, including wiring harnesses, are particularly susceptible to corrosion and subsequent malfunction. Although any flooding can be damaging, salt water flooding elevates the potential for abnormal conditions and may increase risks due to its highly corrosive and conductive nature. Salt residue also continues to corrode and remain conductive even after a vehicle dries. This bulletin is intended to assist with safe handling and inspection of flood damaged vehicles and to provide basic guidance on likely needed repairs. |
| T-SB-0012-13 Rev | 2018-04-02. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. TSB: OBSOLETE NOTICE: September 14, 2016: This bulletin is now obsolete. Please see T-SB-0134-16. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.