WenmarOpen by Wenmar Pro

Service bulletins for the 2021 Toyota Camry

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

202 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Driver assistance are shown. Show all

Bulletins, newest first
TSB0104212024-04-01. Service bulletin. SERVICE BRAKES, HYDRAULIC; ELECTRICAL SYSTEM; ENGINE AND ENGINE COOLING:COOLING SYSTEM; LANE DEPARTURE. TSB: Some 2018 ? 2024 model year Toyota vehicles equipped with an A25A-FKS, A25A-FXS, M20A-FKS, or M20A-FXS engine may exhibit one or more of the following conditions: ?Milky/discolored engine oil. ?An ?Oil Pressure Low? warning message on the Multi-information Display (MID). ?A MIL ON condition with Diagnostic Trouble Codes (DTCs) P05202A (Engine Oil Pressure Sensor/Switch ?A? Signal Stuck in Range) and/or P052477 (Engine Oil Pressure Too Low [Severe]) present. Moisture from blow-by gases condenses and accumulates in the engine oil during short trips in extreme cold weather. When the moisture in the oil freezes, the oil pressure may drop, and the aforementioned warning indicators may display. Follow the procedures in this bulletin to address these conditions.
T-SB-0115-22 Rev2023-04-17. Service bulletin. BACK OVER PREVENTION; FUEL SYSTEM, GASOLINE. TSB: Some 2019 ? 2022 model year Avalon, 2018 ? 2023 model year Camry, 2017 ? 2022 model year Highlander, and 2017 ? 2020 model year Sienna vehicles equipped with a 2GR-FKS engine may exhibit a knocking noise from the vacuum pump at idle.
T-TT-0593-20 Rev2022-02-14. Service bulletin. ELECTRICAL SYSTEM:ADAS:DRIVER MONITORING:SOFTWARE; ELECTRICAL SYSTEM. TT: Some customers may experience the inability to activate Remote Connect or Remote Connect becoming inoperative when attempting to send commands to the vehicle. To simplify the diagnosis of this system and prevent the unnecessary replacement of parts, please refer to the procedure below.
T-TT-0663-212021-10-25. Service bulletin. LANE DEPARTURE; VISIBILITY. TT: When used in conjunction with the Repair Manual, these Blind Spot Monitor, Forward Recognition Camera, and Front Millimeter Wave Radar tips leverage SSTs and readily available tools to support target placement in varying shop environments.
T-TT-0599-20 Rev2021-04-19. Service bulletin. ELECTRICAL SYSTEM; BACK OVER PREVENTION. TT: Vehicle control apps might not operate as expected at times due to preconditions (normal operating parameters) not being established, vehicle settings and/or network/cellular coverage concerns.
T-TT-0599-20 Rev2021-02-16. Service bulletin. BACK OVER PREVENTION:SOFTWARE. TT: Vehicle control apps might not operate as expected at times due to preconditions (normal operating parameters) not being established, vehicle settings and/or network/cellular coverage concerns.
T-TT-0627-202020-11-30. Service bulletin. BACK OVER PREVENTION:SOFTWARE. TT: During recent discharged battery cases on vehicles equipped with LG DCM, there was confusion if a DCM update was available. Technicians are relying on the Techstream Healthcheck to determine if an update is possible.
T-TT-0537-19_Rev2020-05-11. Service bulletin. VISIBILITY; LANE DEPARTURE. TT: The blind spot monitor (BSM) sensor angle inspection is used to confirm that the BSM sensor is within the specified angle before performing axis beam adjustment. When used in conjunction with the repair manual, these BSM tips leverage SSTs and readily available tools to support sensor angle confirmation in varying shop environments.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.