Service bulletins for the 2010 Toyota Camry
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
500 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
| ZE6_Toyota POL14 | 2018-04-02. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. Warranty Policy Bulletin POL14-11: Rev Toyota has received reports where some vehicles may exhibit cracked and/or sticky/melting dashboards as a result of heat or humidity. |
|---|---|
| T-SB-0158-14 | 2018-04-02. Service bulletin. ENGINE AND ENGINE COOLING. TSB: Some 2006-2011 model year vehicles equipped with 2AZ-FE or 2AZ-FXE engines may exhibit engine oil consumption. The piston assembly has been changed to minimize oil consumption. Use the Inspection Procedure in this bulletin to confirm this condition. |
| T-TT-0118-11 Rev | 2018-04-02. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY. Technicians should confirm the following key points to minimize the potential for future MIL "ON" concerns after HV battery replacement. |
| T-TT-0234-13 | 2018-04-02. Service bulletin. EQUIPMENT. Since MY 2011, several different update or upgrade USB SSTs have been issued for Toyota audio and navigation systems. Refer to the chart below for a comprehensive list of all current and previously issued USB SSTs and their applicability. |
| T-SB-0284-09 Rev | 2018-04-02. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; STRUCTURE. This bulletin is now obsolete. Please see T-SB-0055-13 . |
| T-PG006-00 Obsol | 2018-04-02. Service bulletin. EQUIPMENT:OTHER:LABELS. This bulletin is now obsolete. Please see T-SB-0054-13. |
| T-SB-0055-13 | 2018-04-02. Service bulletin. STRUCTURE; EQUIPMENT ADAPTIVE/MOBILITY. The purpose of this bulletin is to provide a procedure to repair the sun visor mount after improper installation/removal or if the sun visors are operated forcefully resulting in the sheet metal at the mounting area being damaged. If this has occurred, the sun visor base located on the headliner may become loose. To address this, a newly designed mounting bracket has been developed to address this condition. Use the following repair procedures to install the new mounting brackets. |
| T-SB-0054-13 | 2018-04-02. Service bulletin. EQUIPMENT. California (CA), Federal (FED), and 50 State Certified emission control underhood labels (emission labels) may be obtained through your dealership?s Parts Department utilizing standard replacement parts ordering procedures. Follow the guidelines outlined in this bulletin to ensure proper label application. |
| T-SB-0141-10 Rev | 2018-04-02. Service bulletin. STRUCTURE:EMERGENCY:ESCAPE/EGRESS/EXIT; BACK OVER PREVENTION. If a creak, tick, or rattle noise is heard at the top or bottom of the windshield, or at the top of the rear glass, the source of the noise may be the two stoppers bonded to the top of the windshield/rear glass, or the windshield retainers bonded to the lower edge of the windshield. This bulletin provides the recommended repair procedure to eliminate these types of noises from the windshield/rear glass area. |
| Class Action Set | 2018-04-02. Service bulletin. VEHICLE SPEED CONTROL. As communicated in mid-June 2013, the Federal Court in Orange County, California continued the Fairness Hearing regarding the proposed settlement of the consolidated Economic Loss Class Actions related to claims of unintended acceleration until July 19, 2013. |
| T-TT-0246-13 | 2018-04-02. Service bulletin. VISIBILITY. Tips for writing a DPR (Dealer Product Report) on manufacturing issues for windows and windshields. |
| T-SB-0086-13 | 2018-04-02. Service bulletin. ELECTRONIC STABILITY CONTROL (ESC). Some 2009 ? 2011 model year North American production (NAP) vehicles equipped with BOSCH® made ABS/VSC systems may exhibit a repeated ABS and TRAC Warning Light ?ON? with Diagnostic Trouble Code (DTC) C1231 present. The ABS ECU logic has been modified to address this condition. |
| T-SB-0083-13 | 2018-04-02. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; EQUIPMENT:APPLIANCE:AIR CONDITIONER. The procedure in this bulletin is a general guideline on how to properly diagnose the air conditioning system after a component failure. Refer to the applicable Repair Manual for vehicle specific repair procedures and parts. |
| T-SB-0001-10 Rev | 2018-04-02. Service bulletin. BACK OVER PREVENTION. Some vehicles may exhibit a MIL ?ON? Diagnostic Trouble Code (DTC) P0138 and/or P0158 (Oxygen Sensor Circuit High Voltage Bank 1 or 2). In some instances a P2195 or P2197 (A/F Sensor Signal Stuck Lean) DTC may also be present. This condition may be caused by incorrect Air Fuel Ratio Sensor response. Additionally, a P0606 (ECM/PCM Processor) DTC may be present due to incorrect Oxygen Sensor operation. The following repair procedures should be used to properly diagnose and repair this condition. |
| T-TT-0250-13 Rev | 2018-04-02. Service bulletin. EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.. To receive satellite radio functions after the initial trial period has expired, the customer must enter into a contract with XM Satellite Radio Inc. After entering into a contract, registration of an 8-digit XM Radio ID is required. This 8-digit XM Radio ID is found by turning to channel ?0? of the satellite radio. |
| T-TT-0051-10 Rev | 2018-04-02. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER. If a customer states there is an unpleasant odor in the vehicle from the HVAC system, there are various factors that may be involved. |
| T-TT-0051-10 | 2018-04-02. Service bulletin. ENGINE AND ENGINE COOLING:COOLING SYSTEM; EQUIPMENT:APPLIANCE:AIR CONDITIONER. If a customer states there is an unpleasant odor in the vehicle from the HVAC system, there are various factors that may be involved. |
| T-TT-0269-13 | 2018-04-02. Service bulletin. VISIBILITY:GLASS, SIDE/REAR. The appearance of spots in tempered glass (when viewed at certain angles) is the result of the heat treating and quick quenching process during manufacturing. |
| T-TT-0268-13 | 2018-04-02. Service bulletin. EQUIPMENT:ELECTRICAL; ELECTRICAL SYSTEM. These concerns can be caused by changes made on the customer?s phone. Make sure to inquire with the customer if the connectivity concerns occurred after receiving an operating system update on their phone or they have restored their phone data/settings recently. |
| T-TT-0262-13 | 2018-04-02. Service bulletin. ENGINE. Due to the improved performance and durability of 0w-20 synthetic oil, Toyota has extended the oil change intervals to 10,000 miles for most vehicles that require this oil. With this change, the following should be noted |
| T-SB-0041-13 Rev | 2018-04-02. Service bulletin. ENGINE. Immediately following a cold soak startup, some 2009 ? 2013 model year vehicles equipped with 1AR-FE or 2AR-FE engines may exhibit a brief knock/rattle noise from the engine compartment for approximately one second. Follow the repair procedure below to address this condition. |
| T-SB-0071-11 Rev | 2018-04-02. Service bulletin. POWER TRAIN. The purpose of this service bulletin is to provide precautions to follow when installing an automatic transmission/transaxle assembly to avoid MIL ?ON,? shifting issues, and/or transmission damage. Use the information in this bulletin when installing an automatic transmission/transaxle assembly |
| T-SB-0122-11 Rev | 2018-04-02. Service bulletin. AIR BAGS; SEATS; EQUIPMENT. Beginning in 1998, Toyota introduced side airbags as optional equipment. Toyota does NOT recommend replacement of original seat covers with non-Toyota leather or other seat cover materials on vehicles due to the following: Seat covers NOT recommended by Toyota may affect side airbag performance, in general or in part, during an accident. Modifications that negatively affect side airbag performance can result in severe occupant injuries. Seat covers are an integral part of this safety system. Replacing fabric seat covers with non-Toyota leather or other seat cover materials may compromise the effectiveness of this safety system. The design of the seat is complex, integrating safety and strength with comfort and luxury. Toyota strongly discourages modifying original equipment seats that have optional side airbags. Additionally, Toyota strongly advises against the installation or use of aftermarket seat covers, which could impair the performance of the side airbags in the event of an accident. |
| T-TT-0124-11 | 2018-04-02. Service bulletin. TIRES. Please refer to the following recommendations for the best practices for vehicle tire rotations. |
| TS-BO030-01 Obso | 2018-04-02. Service bulletin. VISIBILITY/WIPER. This bulletin is now obsolete. Please see T-SB-0185-13. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.