Service bulletins for the 2020 Toyota 4Runner
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
158 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Transmission and driveline are shown. Show all
| T-TT-0705-22 Rev | 2022-10-17. Service bulletin. POWER TRAIN. TT: If you see this condition, please create a TAS case and contact TAS for instruction prior to diagnosing or repairing of the vehicle. If it is a weekend or holiday, continue with diagnosis and repair. Please save all parts and/or details and contact TAS on the next available workday. |
|---|---|
| T-SB-0079-21 | 2021-10-25. Service bulletin. POWER TRAIN. TSB: Some 2019 ? 2020 model year 4Runner vehicles may exhibit a grease leak from the edge of the inboard joint boot of a front drive shaft where the clamp is located. This condition may appear in vehicles with less than 25,000 miles with no apparent damage to the boot. Follow the Repair Procedure in this bulletin to address this condition. |
| T-SB-0134-16-Rev | 2019-09-03. Service bulletin. POWER TRAIN; ELECTRICAL SYSTEM; ENGINE. TSB: REVISION NOTICE July 01, 2019 Rev2: ? Applicability has been updated to 2019 ? 2020 model year Toyota vehicles. ? The Techstream Preparation and Process Overview sections have been updated. October 30, 2017 Rev1: ? Applicability has been updated to include 2018 model year vehicles. Any previous printed versions of this bulletin should be discarded. SUPERSESSION NOTICE The information contained in this bulletin supersedes SB No. T-SB-0012-13. Service Bulletin No. T-SB-0012-13 is obsolete and any printed versions should be discarded. Be sure to review the entire content of this bulletin before proceeding. Flash reprogramming allows the Electronic Control Unit (ECU) software to be updated without replacing the ECU. Flash calibration updates for specific vehicle models/ECUs are released as field-fix procedures described in individual Service Bulletins. This bulletin details the Techstream ECU flash reprogramming process and outlines use of the Technical Information System (TIS) and the Calibration Update Wizard (CUW). Flash calibration updates can only be applied to the vehicle/ECU combination for which they are intended. ECUs have internal security that will not allow them to be programmed with another ECU?s information. NOTE ECU is a Toyota term used to describe integrated computerized devices responsible for managing the operation of a system or subsystem. For the purposes of this bulletin, the term ?ECU? is used as a generic label for the following SAE J1930 standard references: ? Powertrain Control Module (PCM) ? Engine Control Module (ECM) ? Transmission Control Module (TCM) ? Any other Toyota specific control unit |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.