Recalls that may apply to the 2008 Subaru Legacy
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Electrical are shown.
| None found. |
| 2019191 | 2019-04-18. Electrical. Issue: A problem with certain replacement ignition switches may allow the key turn out of the “ON” position while driving. This could cause the engine to turn off suddenly. It could also cause the airbag system not to work properly in a crash. Note: This is a voluntary service campaign that is not being conducted under the requirements of the Motor Vehicle Safety Act. This problem only affects certain parts used for replacement of original parts. Safety Risk: A sudden loss of engine power could increase the risk of a crash. An airbag system that does not work properly in a crash could cause an increased risk of injuries. Corrective Actions: The company will notify owners by mail and instruct them to take their vehicle to a dealer to inspect the ignition switch, and replace it as necessary. |
|---|---|
| 2016492 | 2016-10-07. Electrical. On certain turbocharged vehicles, the relay which controls the secondary air injection pump may have been manufactured incorrectly. As a result, the relay may allow the pump to operate continuously. If this condition were to occur, the pump may overheat and melt, causing burning smell or smoke and possibly resulting in a fire. This could increase the risk of injury and/or damage to property. Correction: Dealers will install a revised relay. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.