WenmarOpen by Wenmar Pro

Service bulletins for the 2016 Subaru Crosstrek

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

358 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Equipment and accessories are shown. Show all

Bulletins, newest first
15-201-162017-10-27. Service bulletin. STRUCTURE; EQUIPMENT. This Service Information bulletin announces a design change to the retractable portion of the tonneau cover made to address customer concerns of the cover retracting on its own while driving on rough roads. The shape and length (an additional 1mm) of the stoppers on both ends of the brace which secure the cover when in use have been changed as shown in the illustration below.
15-190-15R2017-09-14. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. This bulletin contains illustrations of exchange components and their manufacturer as well as a description of the proper exchange procedure. The exchange program policy can also be found in Sections 8.4.9 and 11.2.10 of your Claims Policies and Procedures Manual found in subarunet.
07-118-17R2017-09-14. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT:ELECTRICAL. Models with SRVD Only. This bulletin provides revised diagnostic and repair procedures to address DTC B2327 for the Subaru Rear Vehicle Detection (SRVD), Blind-Spot Detection (BSD) and Rear Cross Traffic Alert (RCTA) system on the applicable models listed above. Under very specific (rare) conditions, the radar function of the SRVD system may experience a communication error and cause the SRVD warning lamp to illuminate. In addition, under certain highway driving conditions, an improper signal calculation by the system may cause a Cancel Code B2328 to set which will also cause the SRVD warning lamp to illuminate.
15-198-16R2017-08-14. Service bulletin. EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM); EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.; ELECTRICAL SYSTEM:SOFTWARE. This bulletin announces reprogramming file availability and the software installation procedure to address a group of operational concerns received from the field listed below involving "Gen 2" F10 Navigation and Display Audio units with 7" display. The procedure will involve downloading the applicable software update files from Subarunet then loading them onto a flash drive for audio unit installation. It is important to read through and understand this information completely before proceeding.
15-196-16R2017-08-14. Service bulletin. EQUIPMENT:ELECTRICAL; ELECTRICAL SYSTEM. TSB: Only those models equipped with Starlink Telematics. Data Communication Module (DCM) Procedures for Provisioning Failure, Inspection / Repair. VERY IMPORTANT: This procedure applies to vehicles with VINs shared with your retailer as leads through the STARLINK Notifications Dashboard found on Subarunet (see example below) which indicate a possible concern with the activation status of the SUBARU STARLINK Safety and Security Services feature.
15-205-16R2017-08-14. Service bulletin. EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM); ELECTRICAL SYSTEM:SOFTWARE. This bulletin announces new reprogramming file availability and the software installation procedure to address additional operational concerns received from the field and listed below involving "Gen 2" F10 Navigation and Display Audio units with 7" display. The procedure will involve downloading the applicable software update files from Subarunet then loading them onto a flash drive for audio unit installation. It is important to read through and understand this information completely before proceeding. These latest software updates contain new logic to address the following concerns: * Mirrorlink 1.1 updates * Enable Mute function for Navigation guidance * Incomplete display of intersection names in combination meter * Increased accuracy of the XM Traffic information displayed * Intermittent delay (approximately 1 minute) in display of map information after initial start-up of Navigation function (2015MY Legacy and Outback only).
10-83-152017-03-06. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER. THIS SERVICE INFORMATION BULLETIN PROVIDES PRECAUTIONS TO USE WHEN REMOVING THE HVAC CONTROL PANEL TO PREVENT DAMAGING THE BLOWER FAN SPEED SWITCH. WHEN REMOVING THE CONTROL PANEL, IF THE FAN SPEED SWITCH WIRING HARNESS IS PULLED TAUGHT OR BECOMES STRESSED, THE SWITCH MAY BE DAMAGED. IF THE CONNECTOR (LOWER) PORTION OF THE SWITCH BECOMES SEPARATED FROM THE SWITCH BODY EVEN SLIGHTLY (SEE FIG. 1 ON PAGE 2), THE HVAC CONTROL PANEL ASSEMBLY MUST BE REPLACED. THE SWITCH ITSELF IS NOT SERVICEABLE. NOTE: FOR 2012MY IMPREZA, SEE TSB 10-78-12, DATED 4/18/2012.
08-39-152017-03-03. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. THIS SERVICE INFORMATION BULLETIN PROVIDES A PROCEDURE FOR RESETTING THE LIFETIME FUEL CONSUMPTION FUNCTION OF THE MFD. WHENEVER REPLACING THE MFD AND / OR COMBINATION METER, THE LIFETIME FUEL CONSUMPTION FUNCTION OF THE MFD MUST BE RESET FOR ACCURATE INFORMATION TO DISPLAY GOING FORWARD. IF NOT RESET, ERRONEOUS VALUES (EITHER EXTREMELY HIGH IN THE CASE OF A MFD REPLACEMENT OR EXTREMELY LOW FOR A COMBINATION METER REPLACEMENT) FOR LIFETIME FUEL CONSUMPTION WILL BE DISPLAYED. THERE IS NO WAY TO TRANSFER THE OLD / EXISTING LIFETIME FUEL CONSUMPTION RESULTS TO THE NEW MFD OR COMBINATION METER ALLOWING IT TO CONTINUE UNINTERRUPTED. AS A RESULT, AFTER REPLACEMENT OF THE MFD AND / OR COMBINATION METER, ALL CALCULATIONS WILL START FRESH FOLLOWING PERFORMANCE OF THE FOLLOWING PROCEDURES.
02-162-15R2017-02-27. Service bulletin. EQUIPMENT. "THIS SERVICE INFORMATION BULLETIN ANNOUNCES A DESIGN CHANGE TO THE OIL PRESSURE SWITCH ASSEMBLY. NICKEL PLATING HAS BEEN APPLIED TO THE INTERNAL SWITCH CONTACTS TO ENHANCE THEIR DURABILITY AND REDUCE THE POSSIBILITY OF POOR CONTACT WHICH COULD AFFECT OPERATION OR CAUSE IMPROPER ILLUMINATION OF THE OIL PRESSURE WARNING LAMP. A SMALL PILOT PORTION WAS ADDED TO THE THREADED AREA ON P.N. 25240KA051 AS SHOWN IN THE ILLUSTRATION BELOW. REVISED PRODUCTION CHANGE INFORMATION."
SOA3211002016-05-23. Service bulletin. EQUIPMENT. SUMMARY TO BE PROVIDED ON A FUTURE DATE.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.