Recalls that may apply to the 1990 Saab 9000
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 90V001000 | 1990-11-02. ELECTRICAL SYSTEM:IGNITION:SWITCH. ABRASION ON THE PRINTED CIRCUIT CARD IN THE COMBINATION NEUTRAL SAFETY/BACKUP LAMP SWITCH OPERATED BY THE AUTOMATIC TRANSMISSION GEAR SELECTOR MAY CAUSE RESIDUE TO COLLECT IN ELECTRICAL AREA ON THE CIRCUIT CARD. Built 1985-09-01 to 1989-12-01. |
|---|
| 1991085 | 1991-06-05. Engine. VEHICLES EQUIPPED WITH A 2.3 LITRE ENGINE MAY HAVE A HOLE IN THE PLATE OF THE DRIVE BELT TENSIONER WHICH MAY NOT HAVE THE SPECIFIED DIMENSION. THIS MAY CAUSE THE SHAFT TO COME LOOSE AND PREVENT DRIVE BELT OPERATION WHICH COULD AFFECT POWER STEERING ASSIST, COOLANT CIRCULATION AND ALTERNATOR OUTPUT. CORRECTION: DRIVE BELT TENSIONER WILL BE INSPECTED AND REPAIRED IF NECESSARY. |
|---|---|
| 1990042 | 1990-03-06. Electrical. NOTE: VEHICLES WITH AUTOMATIC TRANSMISSION RESIDUE ON THE CIRCUIT CARD MAY CAUSE AN ELECTRICAL SHORT IN THE BACK-UP LAMP CIRCUIT AND EVENTUAL OVERHEATING OF THE COMBINATION SAFETY/BACK-UP LAMP SWITCH ASSEMBLY. IF THIS SHOULD OCCUR, SMOKE OR POSSIBLY A FIRE MIGHT DEVELOP FROM THE CENTER CONSOLE AREA IN THE PASSENGER COMPARTMENT. CORRECTION: AN ELECTRICAL CIRCUIT, INCLUDING A RELAY, WILL BE ADDED TO THE BACK-UP LAMP CIRCUIT. THIS WILL REDUCE THE MAXIMUM ELECTRIC CURRENT THAT CAN FLOW THROUGH THE COMBINATION SWITCH IN THE GEAR SELECTOR. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.