Recalls that may apply to the 2003 Peterbilt 357
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Suspension are shown.
| None found. |
| 2003187 | 2003-08-07. Suspension. On certain vehicles, the locking tab that locks the outer spindle nut onto the spindle was not engaged or properly bent over. Failure to properly engage the locking feature into the nut may cause the nut to loosen which will eventually cause the wheel bearing to over heat and fail if undetected. If the loose nut is not detected, the outer end (tire, wheel and hub assembly) could become separated from the vehicle. Correction: Dealer will inspect the hubs to determine if the locking tabs are properly bent. |
|---|
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.