Recalls that may apply to the 2000 Peterbilt 320
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Brakes are shown.
| None found. |
| 2001105 | 2001-05-16. Brakes. Certain vehicles equipped with Peterbilt's SmartGage system containing a Reduced Function Interface Module (RFIM). This module receives data from various components/systems on the vehicle then sends the information to a microprocessor. A manufacturing defect in the RFIM's can allow water to penetrate into the pressure block portion of the module, causing an electrical short in the pressure transducer connector. his results in an erroneous air pressure reading on the gauge in the dash. Correction: The RFIM date code will be inspected and all RFIM's built prior to September 9, 2000 will be replaced. |
|---|---|
| 2000058 | 2000-03-08. Brakes. On certain Dual steer vehicles, there is a likelihood of interference between the cab floor and the brake pedal on the right hand side. If interference exists, the brake pedal may not operate as intended and may result in loss of control of the vehicle. The left hand side (normal) driving position is not affected by this defect. Correction: Brake pedal/pad assembly will be replaced on affected vehicles. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.