WenmarOpen by Wenmar Pro

Recalls that may apply to the 1997 Oldsmobile Bravada

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

By component

United States: NHTSA, as of 2026-10-19
03V1170002003-03-31. SEAT BELTS:FRONT:BUCKLE ASSEMBLY. CERTAIN SPORT UTILITY VEHICLES WERE BUILT WITH A DRIVER'S SEAT BELT BUCKLE ASSEMBLY THAT CONTAINS AN ENERGY-ABSORBING LOOP. SUSTAINED LOADS OF SUFFICIENT MAGNITUDE AND DURATION ON THE BELT IN SEVERE CRASHES COULD FULLY DEPLOY THE BUCKLE ENERGY-ABSORBING LOOP, INTRODUCING A TOTAL OF 10 ADDITIONAL INCHES OF WEBBING INTO THE SEAT BELT SYSTEM. THE FREE FALLING LATCH PLATE USED IN THIS SYSTEM MAY ALLOW WEBBING TO DYNAMICALLY DISTRIBUTE BETWEEN THE LAP AND SHOULDER BELT AS THE DRIVER'S POSITION CHANGES DURING A MULTIPLE ROLLOVER EVENT. Built 1996-03-01 to 1997-06-30.
01V2000002001-06-28. SUSPENSION:FRONT:CONTROL ARM:UPPER BALL JOINT. ON CERTAIN SPORT UTILITY VEHICLES ORIGINALLY SOLD IN OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, WEST VIRGINIA, AND WISCONSIN, AND IN THE DISTRICT OF COLUMBIA. FAILURE OF AN UPPER CONTROL ARM BALL JOINT ASSEMBLY COULD OCCUR DUE TO CORROSION. Built 1996-10-01 to 1996-10-31.
Canada: Transport Canada, as of 2026-10-19
20030872003-03-28. Seats And Restraints. On certain vehicles, sustained loads of sufficient magnitude and duration on the seat belt in severe crashes could fully deploy the buckle energy-absorbing loop, introducing a total of 10 additional inches of webbing into the seat belt system. The free falling latch plate used in this system may allow webbing to dynamically distribute between the lap and shoulder belt as the driver's position changes during a multiple rollover event. If the energy-absorbing loop fully deploys in a severe multiple rollover event, it is possible that a belted driver may experience partial or even complete ejection from the vehicle. Correction: Dealer will replace the driver's safety belt buckle assembly.

A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.