Recalls that may apply to the 2004 Nissan Titan
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Seats And Restraints are shown.
| None found. |
| 2007105 | 2007-04-02. Seats And Restraints. On certain Crew Cab vehicles, there may not be sufficient webbing on the retractor spool for the rear center seatbelt to release from the automatic locking mode (ALR). To release the ALR function and return to emergency locking retractor mode (ELR), the seatbelt has to be spooled all the way in. Should the seatbelt not switch back to ELR, it would be rendered unusable. An unbelted seat occupant would receive increased injury during a vehicle crash. Correction: Dealers will replace the rear center seatbelt assembly. |
|---|---|
| 2006323 | 2006-11-23. Seats And Restraints. Certain King Cab vehicles. Wires in the harness routed through the rear doors and into the body may break due to over bending of the harness as the door is opened and closed. On the left side, the harness contains wires for the driver seatbelt pretensioner, and on the right side the harness contains wires for the front passenger seatbelt pretensioner and for the seatbelt tension sensor, which is part of the occupant classification system. Wires for the rear audio speakers are also contained in the harness on each side. If the wires for the seatbelt pretensioner and speaker break and make contact, there is a possibility that the pretensioner may deploy. If this happens when the seatbelt is retracted, it will not be possible to use the seatbelt. If one of the wires in the right side harness for the seatbelt tension sensor breaks, the passenger side front airbag will not deploy as designed in a frontal crash. Correction: Dealers will inspect and, if necessary, replace the wiring harness with an updated version. |
| 2004239 | 2004-07-09. Seats And Restraints. Certain Titan King Cab and Crew Cab trucks do not meet the requirements of United States Federal Motor Vehicle Safety Standard 201 (seat belt anchorage on rearmost pillar). While Canadian regulations differ in this area, in the interest of customer satisfaction Nissan Canada will conduct a voluntary service campaign to correct this condition on affected Canadian vehicles. Correction: The outboard rear seat belt assemblies will be replaced with new ones which have a different D-ring cover and D-ring. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.