WenmarOpen by Wenmar Pro

Service bulletins for the 2021 Nissan Rogue

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

234 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Instrument cluster are shown. Show all

Bulletins, newest first
NTB23-011A2023-05-06. Service bulletin. ELECTRICAL SYSTEM; FORWARD COLLISION AVOIDANCE; ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. "FORWARD DRIVING AIDS BLOCKED" MESSAGE ON INSTRUMENT PANEL WITH DTC C2582-97 STORED IN LASER/RADAR CONTROL UNIT This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB22-0262022-06-08. Service bulletin. ELECTRICAL SYSTEM:INSTRUMENT PANEL:FUEL GAUGE:FUEL LEVEL FLOAT/SENSOR/SENDING UNIT; ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM):SOFTWARE; FUEL SYSTEM, DIESEL; FUEL SYSTEM, GASOLINE. SERVICE INFORMATION FOR FUEL GAUGE INACCURATE WITH DTCS STORED IN ECM SERVICE INFORMATION If a fuel level sensor has been diagnosed as sending an incorrect level signal, and one or more of the following DTCs are stored in the ECM, do not replace the entire “Fuel Level Sensor Unit, Fuel Filter and Fuel Pump Assembly” (fuel pump assembly). The fuel level sensor can be replaced separately. • P0460 (FUEL LEV SEN SLOSH) • P0461 (FUEL LEVEL SENSOR) • P0462 (FUEL LEVL SEN/CIRC) • P0463 (FUEL LEVL SEN/CIRC) NOTE: Warranty claims referring to fuel level issues that result in the replacement of the entire fuel pump assembly will be charged back.
NTB22-0192022-05-20. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL; UNKNOWN OR OTHER. RATTLE NOISE FROM INSTRUMENT PANEL AREA AT IDLE AND/OR ON ACCELERATION IF YOU CONFIRM A rattle-type noise from the instrument panel area when at a stop, or when first accelerating from a stop. ACTION 1. Inspect the heater hose clamp orientation to ensure the clamps are not contacting each other. 2. If needed, add foam to the heater core pipes to insulate them from the heater core cover.
NTB21-0632021-08-06. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM; ELECTRICAL SYSTEM:INSTRUMENT PANEL:SPEEDOMETER/ODOMETER:SENSOR/SENDING UNIT. COMBINATION METERS CANNOT BE SWAPPED SERVICE INFORMATION Do not swap combination meter modules between vehicles for any reason in the APPLIED VEHICLES. Due to a new electrical architecture, the vehicle mileage is now stored in multiple control modules. When a mileage difference is detected between modules, the module with the lower value will be immediately overwritten, replacing it with the higher mileage. If a new combination meter module is installed, it will automatically be overwritten to the correct vehicle mileage.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.