WenmarOpen by Wenmar Pro

Service bulletins for the 2021 Nissan Rogue

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

234 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Electrical system are shown. Show all

Bulletins, newest first
NTB21-0402021-06-12. Service bulletin. ELECTRICAL SYSTEM. 2021 ROGUE; DTCS B2740-87, B2744-87, AND/OR B274D-87 STORED IF YOU CONFIRM Any of the following DTCs are stored: • B2740-87 (TCU) • B2744-87 (BCM) • B274D-87 (Combination Meter) ACTION Reprogram the Sonar Control Unit, if applicable.
NTB21-0372021-06-11. Service bulletin. ELECTRICAL SYSTEM. 2021 ROGUE AND SENTRA; DTCS B2E4B-06, B2E60-06, B2E61-06 STORED IN THE TCU IF YOU CONFIRM The customer experiences an issue with the NissanConnect® Service remote commands, And Any of the following DTCs are present in the Telematics Control Unit (TCU): • B2E4B-06 • B2E60-06 • B2E61-06 NOTE: These DTCs are caused by an issue with a cloud-server that is related to the TCU. The DTC diagnosis was mistakenly added to the ESM and should be ignored. ACTION 1. Do NOT replace the TCU. Replacing the TCU will not resolve the concern. 2. Send an email to NTB21-037@Nissan-Usa.com.
NTB21-0342021-05-08. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT. 2019-2021 ALTIMA AND 2021 ROGUE; AC INOPERATIVE WITH DTC B20C8-14 STORED IF YOU CONFIRM The AC compressor is not engaging when the AC is in the ON position as indicated by the yellow illumination on the AC button, And DTC B20C8-14 ECV (ELECTRICAL CONTROL VALVE) is stored in the IPDM. SERVICE PROCEDURE 1. Clear the DTC, and follow the DTC CONFIRMATION PROCEDURE in the ESM. • If DTC B20C8-14 is past, AC compressor operation is inhibited until the DTC is cleared. • If DTC B20C8-14 returns after being cleared (either Current or Past status), follow the ESM diagnosis procedure. • For models with Automatic Air Conditioning, go to section: VENTILATION, HEATER & AIR CONDITIONER > HEATER & AIR CONDITIONING CONTROL SYSTEM > AUTOMATIC AIR CONDITIONING > DTC/CIRCUIT DIAGNOSIS > B20C8-14 ECV (ELECTRICAL CONTROL VALVE). • For models with Manual Air Conditioning, go to section: VENTILATION, HEATER & AIR CONDITIONER > HEATER & AIR CONDITIONING CONTROL SYSTEM > MANUAL AIR CONDITIONING > DTC/CIRCUIT DIAGNOSIS > B20C8-14 ECV (ELECTRICAL CONTROL VALVE).
NTB20-029D2021-05-08. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT. TELEMATICS (IVC) SERVICE INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Discard all previous versions of this bulletin.
NTB15-049W2021-04-09. Service bulletin. ELECTRICAL SYSTEM. TELEMATICS SERVICE INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB20-075a2021-03-06. Service bulletin. ELECTRICAL SYSTEM. SOFTWARE UPDATE POP-UP NOTIFICATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Discard all previous versions of this bulletin.
NTB20-029c2021-03-06. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT; ELECTRICAL SYSTEM. 2021 MAXIMA AND ROGUE, 2020-2021 TITAN AND TITAN XD; TELEMATICS (IVC) SERVICE INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Discard all previous versions of this bulletin.
NTB19-042b2021-03-06. Service bulletin. ELECTRICAL SYSTEM; VISIBILITY:WINDSHIELD; FORWARD COLLISION AVOIDANCE. AEB WARNING LIGHT BLINKING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB20-079a2021-02-06. Service bulletin. ELECTRICAL SYSTEM. 2021 ROGUE; AV CONTROL UNIT REPLACEMENT PROCESS This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB20-073a2021-02-06. Service bulletin. ELECTRICAL SYSTEM. 2021 ROGUE AND 2020 SENTRA; INTELLIGENT KEY UNIT SERVICE INFORMATION This bulletin has been amended. See AMENDMENT HISTORY, below. Please discard previous versions of this bulletin.
NTB20-029b2021-02-06. Service bulletin. ELECTRICAL SYSTEM. 2021 MAXIMA AND ROGUE, 2020-2021 TITAN AND TITAN XD; TELEMATICS (IVC) SERVICE INFORMATION SERVICE INFORMATION The vehicles listed under APPLIED VEHICLES that come equipped with a factory installed SOS switch, located near the overhead map lamp, also come equipped with a wireless communication device called a Telematics Communication Unit (TCU). With an active NissanConnect Services™ subscription, the TCU communicates with the Nissan Data Center to provide various security and convenience services. This bulletin contains important service procedures that must be performed properly in order to set up and maintain the telematics/in-vehicle communications (IVC) system for the vehicles listed under APPLIED VEHICLES. • A table has been provided, on the next page, that lists the steps required to successfully configure a TCU after it has been replaced. • A check-off sheet has been provided in this bulletin to print and check off steps as they are completed. Staple the completed check-off sheet to the repair order.
NTB20-0952021-01-09. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM):SOFTWARE; ELECTRICAL SYSTEM. 2021 ROGUE; AWD COUPLER SERVICE INFORMATION SERVICE INFORMATION The AWD coupler on the APPLIED VEHICLE listed above, is available as a separate service part. When replacement of the AWD coupler is required, DO NOT follow the ESM procedure. Instead, follow the procedure outlined in this service bulletin.
NTB20-0932021-01-09. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE:BODY. 2021 ROGUE; INTELLIGENT KEY UNIT DTC B203D-14 DIAGNOSTIC PROCEDURE SERVICE INFORMATION DTC B203D-14 indicates a concern in the circuit between the inside key antenna and the intelligent key control unit. Currently, the ESM does not have a diagnosis or repair procedure for DTC B203D-14. When DTC B203D-14 is confirmed, perform the diagnosis and repair procedures, outlined in the ESM, for DTC B203C-14. • For DTC B203C-14 diagnosis and repair procedure, refer to the ESM section: BODY EXTERIOR, DOORS, ROOF & VEHICLE SECURITY > DOOR & LOCK >DTC/CIRCUIT DIAGNOSIS > B203C-14 INSIDE ANTENNA.
NTB20-052a2020-12-09. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM. REAR DOOR ALERT SERVICE INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB20-0852020-12-09. Service bulletin. COMMUNICATION:MANUFACTURER TELEMATICS; ELECTRICAL SYSTEM. TELEMATICS CONTROL UNIT RESET AFTER AUTOMATIC COLLISION NOTIFICATION SERVICE INFORMATION The Telematics Control Unit (TCU) has the ability to send an automatic collision notification when the vehicle is involved in an accident. Once an automatic collision notification is performed, the function becomes disabled. The TCU must be reset to re-enable the automatic collision notification function. This bulletin describes how to reset the TCU after an automatic collision notification has been performed.
NTB20-0842020-12-09. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM); ELECTRICAL SYSTEM; EQUIPMENT. INTELLIGENT KEY UNIT DTC P161D STORED IN THE ECM SERVICE INFORMATION DTC P161D (IMMOBILIZER) will not cause: • The MIL to turn ON. • The Remote Engine Start to become inoperative. • The “No Key Detected” message to appear. • An impact to any of the vehicle’s functions or performance. If other DTCs are stored with P161D, perform the diagnosis and repair procedures, outlined in the ESM, for the other DTCs first. • After the other DTCs have been resolved and P161D does not clear, proceed with the diagnosis and repair, outlined in the ESM, for DTC P161D.
NTB20-0812020-12-09. Service bulletin. ELECTRICAL SYSTEM:BODY CONTROL MODULE/BCM; POWER TRAIN. 2021 ROGUE; VIBRATION FROM REAR WHILE TURNING AT LOW SPEED IF YOU CONFIRM The customer experiences a vibration or a stick/slip/binding feeling from the rear of the vehicle when turning at low speed. ACTION Perform the AWD coupler clutch break-in procedure.
NTB20-0792020-12-09. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT. 2021 ROGUE; AV CONTROL UNIT REPLACEMENT PROCESS IF YOU CONFIRM The AV control unit needs to be replaced on an APPLIED VEHICLE. ACTION IMPORTANT: The AV control unit for the applied vehicle is new, different from the previous model year, and requires a new procedure when replacing. If the following procedures are not followed completely, all features will not work as intended. 1. Replace the AV control unit 2. Reprogram the AV control unit 3. Configure the AV control unit 4. Write the VIN to the AV control unit (Manual Input) IMPORTANT: Procedures 2-4 above must be performed in the order shown below.
NTB20-0742020-11-09. Service bulletin. ELECTRICAL SYSTEM. 2021 ROGUE AND 2020 SENTRA; BCM SERVICE INFORMATION SERVICE INFORMATION • When replacing the BCM, ALWAYS replace it with a new one. • Module configuration MUST BE performed before pairing the BCM and intelligent key unit. Once the BCM and intelligent key unit have been paired, portions of the configuration are locked and can no longer be changed. • When replacing the BCM, it is critical to follow the work procedure as detailed in the ESM. • For Rogue, go to ELECTRICAL & POWER CONTROL > BODY CONTROL SYSTEM > BASIC INSPECTION > ADDITIONAL SERVICE WHEN REPLACING BCM. • For Sentra, go to ELECTRICAL & POWER CONTROL > BODY CONTROL SYSTEM > BASIC INSPECTION > INSPECTION & ADJUSTMENT > ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM).

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.