WenmarOpen by Wenmar Pro

Service bulletins for the 2019 Nissan Pathfinder

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

145 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Electrical system are shown. Show all

Bulletins, newest first
NTB15-049t2020-03-07. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. TELEMATICS SERVICE INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB19-1012019-12-06. Service bulletin. ENGINE; STRUCTURE:BODY:DOOR; ELECTRICAL SYSTEM. 2019-2020 PATHFINDER; PUSH BUTTON IGNITION AND DOOR REQUEST SWITCHES INOPERATIVE IF YOU CONFIRM All of the conditions listed below are occurring on an Applied Vehicle with the Intelligent Key within range. • - The doors will not lock/unlock when the request switch on an exterior door handle is pressed. • - The doors will lock/unlock when the respective buttons are pressed on the Intelligent Key. • - The engine will not start when the ignition switch is pressed while depressing the brake. • - The engine will start when pressing the Remote Engine Start (RES) button on the Intelligent Key. • - The engine will start when pressing the ignition switch while holding the Intelligent Key in front of it. ACTION Replace the BCM. • - Refer to the Electronic Service Manual (ESM) for the procedure to replace the BCM: ELECTRICAL & POWER CONTROL > BODY CONTROL SYSTEM > BCM > REMOVAL AND INSTALLATION > BCM (BODY CONTROL MODULE)
NTB19-0712019-10-09. Service bulletin. ELECTRICAL SYSTEM; AIR BAGS. DTC B00A0-00 STORED IF YOU CONFIRM DTC B00A0-00 (OCCUPANT DETECTION SENSOR UNIT) is stored And OCS zero point reset cannot be performed (continued on the next page) And The following screen displays: ACTION 1. Check the Occupant Classification System (OCS) control unit using the ODS Analysis tool software. • Refer to SERVICE PROCEDURE on page 5. HINT: “OCS” may also be referred to as “ODS”. 2. Perform “75-zero RESET”.
NTB19-045a2019-10-08. Service bulletin. ELECTRICAL SYSTEM. MIL ON WITH DTC P0087, P0101, P0448, OR P2008 This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB19-0652019-09-10. Service bulletin. ELECTRICAL SYSTEM; ENGINE AND ENGINE COOLING. 2017-2019 PATHFINDER; MIL ON WITH DTC P0087 STORED IF YOU CONFIRM The Malfunction Indicator Light (MIL) is ON with Diagnostic Trouble Code (DTC) P0087 (FRP CONTROL SYSTEM) stored in the Engine Control Module (ECM), AND The fuel level indicates ¼ or less. ACTION Reprogram the ECM, if applicable.
NTB19-002a2019-08-19. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. 2018-2019 ARMADA AND PATHFINDER; DISPLAY CONTROL UNIT SERVICE INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB19-0292019-05-20. Service bulletin. EQUIPMENT:ELECTRICAL; ELECTRICAL SYSTEM. INTELLIGENT KEY DOES NOT WORK AFTER BATTERY REPLACEMENT SERVICE INFORMATION If the Intelligent Key of an APPLIED VEHICLE does not work after replacing the battery, inspect the positive (+) terminals. If the battery side of the Intelligent Key is held by pinching down on the terminals while removing the battery, it is possible to bend the terminals down far enough that they will not touch the contacts on the other half of the Intelligent Key. If the terminals are found to be bent down, pry them back up so that they will come in contact with the other half of the Intelligent Key?s contacts. - Refer to the photos on the following pages.
NTB16-028b2019-03-25. Service bulletin. ELECTRICAL SYSTEM. INTELLIGENT KEY BUTTONS INOPERATIVE BUT REQUEST SWITCHES WORK This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB15-049r2019-02-19. Service bulletin. EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM); ELECTRICAL SYSTEM:SOFTWARE. TELEMATICS SERVICE INFORMATION This bulletin applies only to vehicles equipped with a Telematics Communication Unit (TCU). This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB19-0022019-02-19. Service bulletin. ELECTRICAL SYSTEM. 2018-2019 ARMADA AND PATHFINDER; DISPLAY CONTROL UNIT SERVICE INFORMATION SERVICE INFORMATION If the Display Control Unit (DCU) needs to be replaced on an APPLIED VEHICLE for any reason, follow the steps in the SERVICE PROCEDURE to: - Confirm proper diagnosis and repair with TECH LINE to obtain DCU order approval. - Place the order with DENSO. - Configure the Multi AV system. NOTE: - The original DCU must be installed in the vehicle while performing part of this procedure. DO NOT remove the original DCU until instructed. - The DCU order approval process does not apply to 2017 Pathfinder vehicles. TECH LINE authorization is not needed for 2017 Pathfinder vehicles. For 2017 Pathfinder vehicles, refer to NTB16-104. - This process does not apply to 2017 Armada vehicles since it uses a different system.
NTB15-077b2018-12-03. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY. NISSAN; SIGNAL TECH-II INTELLIGENT KEY BATTERY TEST AND SIGNAL CHECK This bulletin has been amended. See Amendment History on the last page. Please discard previous versions of this bulletin.
NTB18-0712018-11-26. Service bulletin. ELECTRICAL SYSTEM:IGNITION:ANTI-THEFT:CONTROL MODULE; EQUIPMENT:ELECTRICAL:ANTI-THEFT DEVICES; STRUCTURE:BODY:DOOR. SECURITY ALARM SOUNDS AFTER USING MECHANICAL KEY TO UNLOCK DRIVER DOOR SERVICE INFORMATION Applied Vehicles listed above are no longer equipped with a door unlock sensor and/or Body Control Module (BCM) software to provide support for the door unlock sensor. Normal Functionality For Vehicles Built Without Door Unlock Sensor And/Or BCM Software To Support Door Unlock Sensor For Applied Vehicles built after the Applied Dates listed on page 1, using the mechanical key on the driver door will operate differently than vehicles built before the Applied Dates. For these later models, the BCM will not recognize operation of the mechanical key. If a mechanical key is used to lock the driver door: - The security system will not set. If the vehicle is broken into, the alarm will not sound. - Only the driver door will be locked. Other doors will not lock using the mechanical key. If a mechanical key is used to unlock the driver door: - Only the driver door will be unlocked. Other doors will not be unlocked. - If the security system is set, when the door is opened the alarm will sound. NOTE: Using the Unlock button on the Intelligent Key, pushing the request switch on the driver or passenger door with the Intelligent Key in range, or using the Intelligent Key to start the vehicle will silence the alarm. The mechanical key will not operate the power windows.
NTB16-018c2018-05-21. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT; ENGINE AND ENGINE COOLING. MIL ON WITH P0603 STORED FOR ECM BACK UP CIRCUIT This bulletin does NOT apply to Titan equipped with Cummins V8 Diesel engine. This bulletin has been amended to add a NOTE in the Applied Vehicles. No other changes have been made. Please discard previous versions of this bulletin.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.