WenmarOpen by Wenmar Pro

Service bulletins for the 2013 Nissan NV200

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

85 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
NTB17-082E2022-03-12. Service bulletin. FUEL SYSTEM, OTHER; ENGINE AND ENGINE COOLING. DTC P0456 CAUSED BY EVAP LEAK AT VENT CONTROL VALVE O-RING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB13-097J2022-03-12. Service bulletin. FUEL SYSTEM, OTHER; ENGINE AND ENGINE COOLING. EVAP LEAK DTC P0442, P0455, P0456 INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB13-027C2022-03-12. Service bulletin. ELECTRICAL SYSTEM; ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM). CAN COMMUNICATION – NETWORK DIAGNOSTIC FLOW CHART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
R21B3 2013-17 NV2022-01-08. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM). Engine Control Module (ECM) Reprogram Voluntary Emission Recall Campaign Campaign Summary: Nissan is issuing a Voluntary Emissions Recall Campaign on specific MY2013-2017 NV200 and MY2014-2017 NYC Taxi vehicles identified in Service Comm and DBS National Service History to reprogram the Engine Control Module (ECM). Nissan has determined that the software in the Engine Control Module (ECM) may not be calibrated properly. The On Board Diagnostic (OBD) monitor may not detect a manifold catalyst below the efficiency threshold in all circumstances as required by regulation. What Dealers Should Do: 1.Verify if vehicles are affected by this Voluntary Emissions Recall using Service Comm or DBS National Service history – Open Campaign I.D. R21B3 •New vehicles in dealer inventory can also be identified using DBS (Sales-> Vehicle Inventory, and filter by Open Campaign). •Refer to NPSB 15-460 for additional information •Please continue to check newly arriving inventory for campaign applicability. 2.Dealers should use NTB21-105 to remedy any vehicles subject to this campaign. 3.Once remedied, dealers should submit the claim, using the claims coding provided, and release the vehicle.
NTB150552021-05-10. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. SERVICE INFORMATION After ECM reprogramming, the Calibration Verification Number (CVN) needs to be automatically calculated prior to State emissions testing (also known as Inspection Maintainence, I/M, or SMOG testing depending upon location). Allowing the vehicle to idle for 22 minutes will allow for faster CVN calculation. It is recommended that customers utilize this method if the vehicle needs to be tested for emissions soon after ECM reprogramming. See this bulletin for further detail.
NTB141092021-05-10. Service bulletin. ELECTRICAL SYSTEM; ENGINE. SERVICE INFORMATION Starting with 2010 Model Year, Nissan vehicles have been gradually incorporating a new type of DTC known as Permanent DTC or P-DTC. If a vehicle is equipped with P-DTCs, all emission related DTCs will also set a P-DTC if the MIL is turned ON. A listing of which DTCs that will also set a P-DTC is found in the DTC Index in the EC-Engine Control section of the Electronic Service Manual (ESM). If a DTC repair is performed and the DTC erased, a vehicle may fail an Emission Inspection and Maintenance test if the P-DTC is not also erased. See this bulletin for further detail.
PC3272021-05-10. Service bulletin. ENGINE; ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM). Nissan is conducting an inventory inspection on 105,290 specific MY2013-15 Nissan ALT, PTH, LEF, MUR, NV2, NVT, SEN, and VER NOTE vehicles to inspect the software on the OCS ECU.
NTB12091A2021-05-10. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM); ENGINE. SERVICE INFORMATION Replacement Engine Control Modules (ECMs) for many newer Nissan vehicles are now "Blank" ECMs. Blank ECMs come without software and must be programmed (not reprogrammed) before they will function. See this bulletin for further detail.
NTB21-0042021-02-06. Service bulletin. ENGINE AND ENGINE COOLING. 2013-2019 SENTRA AND 2013-2021 NV200/TAXI; INDIVIDUAL FUEL PUMP SERVICE PARTS SERVICE INFORMATION If the “fuel level sensor, fuel filter and fuel pump assembly” (fuel pump assembly) needs to be replaced, due to an in tank fuel level sensor issue or fuel temp sensor DTC, the fuel level sensor (includes fuel temp sensor) can be ordered separately from the fuel pump assembly. • Refer to the Electronic Service Manual (ESM) for the service procedure to remove the fuel pump assembly. Sentra: PDF ESM – ENGINE > FL – Fuel System > MRA8DE (or) MR16DDT > FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUP ASSEMBLY > Removal and Installation. Web based ESM – ENGINE > FUEL SYSTEM > MRA8DE (or) MR20DE > REMOVAL AND INSTALLATION > FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY. NV200 and Taxi: PDF ESM – ENGINE > FL – Fuel System > MR20DE > REMOVAL AND INSTALLATION > FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY > Removal and Installation. Web based ESM – ENGINE > FUEL SYSTEM > MR20DE > REMOVAL AND INSTALLATION > FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY> Removal and Installation.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.