WenmarOpen by Wenmar Pro

Service bulletins for the 2019 Nissan Murano

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

158 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Equipment and accessories are shown. Show all

Bulletins, newest first
NTB20-0112020-03-07. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT. 2015-2020 MURANO; CARPET PULLED OUT FROM UNDER INNER KICKING PLATE IF YOU CONFIRM The carpet is pulling out from under the driver side front, passenger side front or the passenger side rear inner kicking plates (See Figure 1 for example). ACTION Add foam padding to the floor spacer plate near the affected area of the vehicle. • - See page 2 for Driver Side Front. • - See page 6 for Passenger Side Front. • - See page 9 for Passenger Side Rear.
NTB18-035b2020-03-07. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT. 2015-2020 MURANO; FRONT PASSENGER CARPET PULLED OUT FROM UNDER TRIM This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB15-049t2020-03-07. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. TELEMATICS SERVICE INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB19-0472019-07-22. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT; STRUCTURE:BODY:DOOR; LATCHES/LOCKS/LINKAGES:DOORS:LATCH. 2019 MURANO; BACK DOOR WILL RELEASE, BUT WILL NOT RAISE WITH BACK DOOR REQUEST SWITCH IF YOU CONFIRM The customer states that the Automatic Back Door (ABD) will unlatch, but will not raise - Only when using the open request switch located on the back door, And - The Extended Storage Switch (ESS) is pushed in and is not in transit mode. ACTION 1. Refer to page 8, step 18 in the SERVICE PROCEDURE to confirm if ABD CU reprogramming is needed. - Reprogram the ABD CU, if needed. - If the ABD CU is reprogrammed, perform Automatic Back Door Manual Configuration (see page 18). - If the ABD CU is reprogrammed, perform Automatic Back Door Calibration (see page 23).
NTB15-049s2019-07-22. Service bulletin. EQUIPMENT. TELEMATICS SERVICE INFORMATION This bulletin applies only to vehicles equipped with a Telematics Communication Unit (TCU). This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB19-0432019-07-15. Service bulletin. EQUIPMENT. ENGINE SUPPORT TOOLS SERVICE INFORMATION A new Engine Support Tool and Engine Support Bracket are now available to allow the CVT to be removed from the Applied Vehicles without having to remove the engine. The procedure in this bulletin is different from the procedure currently in the Electronic Service Manual (ESM), which will be updated with this information at a later date. Please refer to the SERVICE PROCEDURE to use these new tools.
NTB19-0292019-05-20. Service bulletin. EQUIPMENT:ELECTRICAL; ELECTRICAL SYSTEM. INTELLIGENT KEY DOES NOT WORK AFTER BATTERY REPLACEMENT SERVICE INFORMATION If the Intelligent Key of an APPLIED VEHICLE does not work after replacing the battery, inspect the positive (+) terminals. If the battery side of the Intelligent Key is held by pinching down on the terminals while removing the battery, it is possible to bend the terminals down far enough that they will not touch the contacts on the other half of the Intelligent Key. If the terminals are found to be bent down, pry them back up so that they will come in contact with the other half of the Intelligent Key?s contacts. - Refer to the photos on the following pages.
NTB18-035a2019-05-20. Service bulletin. EQUIPMENT. 2015-2019 MURANO; FRONT PASSENGER CARPET PULLED OUT FROM UNDER TRIM This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB19-0222019-04-15. Service bulletin. EQUIPMENT; FUEL SYSTEM, OTHER. NISSAN; P0171 AND P0174 SERVICE INFORMATION SERVICE INFORMATION Diagnosis for DTCs P0171 (FUEL SYS LEAN B1) and P0174 (FUEL SYS LEAN B2) have been revised for the APPLIED VEHICLES listed above. When performing diagnosis for either of these DTCs, start by using the SERVICE PROCEDURE section of this bulletin. NOTE: The related Electronic Service Manuals (ESM) will be revised in the future to include these diagnostic steps.
NTB15-049r2019-02-19. Service bulletin. EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM); ELECTRICAL SYSTEM:SOFTWARE. TELEMATICS SERVICE INFORMATION This bulletin applies only to vehicles equipped with a Telematics Communication Unit (TCU). This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB18-0712018-11-26. Service bulletin. ELECTRICAL SYSTEM:IGNITION:ANTI-THEFT:CONTROL MODULE; EQUIPMENT:ELECTRICAL:ANTI-THEFT DEVICES; STRUCTURE:BODY:DOOR. SECURITY ALARM SOUNDS AFTER USING MECHANICAL KEY TO UNLOCK DRIVER DOOR SERVICE INFORMATION Applied Vehicles listed above are no longer equipped with a door unlock sensor and/or Body Control Module (BCM) software to provide support for the door unlock sensor. Normal Functionality For Vehicles Built Without Door Unlock Sensor And/Or BCM Software To Support Door Unlock Sensor For Applied Vehicles built after the Applied Dates listed on page 1, using the mechanical key on the driver door will operate differently than vehicles built before the Applied Dates. For these later models, the BCM will not recognize operation of the mechanical key. If a mechanical key is used to lock the driver door: - The security system will not set. If the vehicle is broken into, the alarm will not sound. - Only the driver door will be locked. Other doors will not lock using the mechanical key. If a mechanical key is used to unlock the driver door: - Only the driver door will be unlocked. Other doors will not be unlocked. - If the security system is set, when the door is opened the alarm will sound. NOTE: Using the Unlock button on the Intelligent Key, pushing the request switch on the driver or passenger door with the Intelligent Key in range, or using the Intelligent Key to start the vehicle will silence the alarm. The mechanical key will not operate the power windows.
NTB03-074m2018-05-21. Service bulletin. EQUIPMENT; EXTERIOR LIGHTING:FOG LIGHTS. FOG LAMP AND/OR HEADLAMP FOGGING This bulletin has been amended to add Fog Lamps and modify one step in the flow chart on page 3. No other changes have been made. Please discard previous versions of this bulletin.
NTB16-018c2018-05-21. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT; ENGINE AND ENGINE COOLING. MIL ON WITH P0603 STORED FOR ECM BACK UP CIRCUIT This bulletin does NOT apply to Titan equipped with Cummins V8 Diesel engine. This bulletin has been amended to add a NOTE in the Applied Vehicles. No other changes have been made. Please discard previous versions of this bulletin.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.