WenmarOpen by Wenmar Pro

Service bulletins for the 2015 Nissan Murano

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

281 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Bulletins, newest first
NTB160212021-05-10. Service bulletin. ELECTRICAL SYSTEM. IF YOU CONFIRM: Any one or a combination of the following after opening and/or closing a door (as it applies): * The auto headlights do not time out after the ignition is set to the OFF position. * The interior lights do not come ON. * Rogue only: The radio will not turn OFF after ignition is turned OFF. * The Vehicle Information Display in the combination meter showing "door ajar" when the doors are closed. * The Remote Engine Start feature is inoperative. ACTION: 1. Remove, and then reinstall, the screw of all four (4) door switches. 2. Confirm whichever issue has been occurring is resolved. NOTE: If the issue(s) is still not resolved, refer to ASIST and the appropriate Electronic Service Manual (ESM) for further diagnosis. Please see this bulletin for further details.
NTB03074J2021-05-10. Service bulletin. EXTERIOR LIGHTING. SERVICE INFORMATION Occasionally customers may notice water vapor or fog in the headlamps. The information, illustrations, and flow chart in this bulletin are provided to help you in determining if an incident for water/condensation in the headlamps is normal or not. Nissan?s new vehicle limited warranty does not cover physically damaged (cracked or broken) headlamps. All current headlamp assemblies are vented to the atmosphere (not sealed). - This is necessary to allow for expansion and contraction of air from temperature "variations" (warmer or colder) without damage to the headlamp. - Moisture in the air sometimes "travels" into and out of the headlamp assembly through these vents. - Certain environmental conditions may cause moisture to condense. - The fogging/cloudiness should disappear over time when the headlamp is in a dry environment. See this bulletin for further detail.
NTB160182021-05-10. Service bulletin. ELECTRICAL SYSTEM. IF YOU CONFIRM The MIL is "ON" with DTC P0603 (ECM BACK UP/CIRCUIT). ACTION 1. Confirm that the battery voltage is 11 volts, or more, with the ignition ON (engine OFF, not running). 2. Erase DTC 3. Perform DTC confirmation steps in the Service Procedure. 4. Confirm 1st trip DTC P0603 is not stored. NOTE: P0603 is often the result of low battery voltage, discharged battery or battery terminal disconnections. Please see this bulletin for furtner details.
NTB09081C2021-05-10. Service bulletin. VISIBILITY. SERVICE INFORMATION The purpose of this bulletin is to give Nissan dealers guidelines to help determine if windshield breakage is covered under warranty or is the customer?s responsibility. Nissan North America (NNA) is not responsible for damage to glass that is a result of objects striking or scratching the glass. However, NNA is responsible for manufacturing issues such as distorted glass and cracks that are due to improper installation or damage to the glass during vehicle assembly. NNA typically does not find any type of cracks in the windshield due to stress after the dealership PDI. See this bulletin for further detail.
NTB15031A2021-05-10. Service bulletin. ELECTRICAL SYSTEM. SERVICE INFORMATION Combination Meter Self-Learning After Replacement 2015 Murano Combination Meters have a learning function when first installed. IMPORTANT: Immediately after initial installation and ignition ON, the combination meter adapts to the way the vehicle is equipped. Performing self-learning can be done only once. Once done, it cannot be changed. CAUTION: Never install a combination meter from an ADAS equipped 2015 Murano into a non-ADAS equipped 2015 Murano, or vice versa, for testing purposes or any other reason. If this incident occurs, the combination meter will need to be replaced. See this bulletin for further detail.
NTB160082021-05-10. Service bulletin. ELECTRICAL SYSTEM. SERVICE INFORMATION The function to detect the last item to trigger the vehicles theft alarm system can now be accessed with CONSULT-III plus (C-III plus). This function can be accessed by selecting: * Diagnosis (All Systems) or Diagnosis (One System). Then * BCM Then * THEFT ALM Then * Work Support Then * THEFT ALM TRG. See this bulletin for further details.
NTB160012021-05-10. Service bulletin. ELECTRICAL SYSTEM. SERVICE INFORMATION When the BCM in an APPLIED VEHICLE is being replaced for any reason, all existing Intelligent Keys must be re-registered. If new Intelligent Keys are added to the existing Intelligent Keys at the same time the BCM is being replaced, the procedure in this bulletin must be followed. See this bulletin for further detail.
PC419A2021-05-10. Service bulletin. LATCHES/LOCKS/LINKAGES. This activity will expire on December 18th, 2015. Dealers can continue to schedule and repair vehicles eligible for this service action until close of business December 18th, 2015. Claims will be honored for RO?s opened on or before the 18th of December.
NTB160032021-05-10. Service bulletin. ELECTRICAL SYSTEM. SERVICE INFORMATION The Intelligent Keys used on the various Nissan vehicles may not be interchangeable between models and years. See this bulletin for further detail.
NTB15066A2021-05-10. Service bulletin. ELECTRICAL SYSTEM; VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM. SERVICE INFORMATION NOTE: If the information below determines both parts need replacement, do not replace them at different times. Make sure both parts are replaced at the same time. AV Control Unit Replacement Whenever an AV control unit on an applied vehicle is replaced for any reason, check the part number (P/N) of the A/C switch assembly (A/C Controller Assembly). A/C switch assembly (A/C Controller Assembly) Replacement: Whenever an A/C switch assembly on an applied vehicle is replaced for any reason, check the AV control unit?s software version for possible software update. See this bulletin for further detail.
PC4192021-05-10. Service bulletin. LATCHES/LOCKS/LINKAGES. Nissan is conducting a dealer inventory service action to inspect and, if necessary, replace the hood latch on certain MY 2015 Murano, MY2016 Maxima, and MY2015-16 Rogue and Pathfinder vehicles
NTB09022G2021-05-10. Service bulletin. ELECTRICAL SYSTEM. SERVICE INFORMATION Design and process changes have been made to improve battery voltage at dealer receipt. Our goal is to deliver vehicles to customers with a 12 volt battery in excellent condition. Proper dealership storage and maintenance of vehicle 12 volt batteries is essential to insuring good battery operating life and customer satisfaction. Dealers are responsible for maintaining vehicles in their inventory. 12 volt batteries in vehicle inventory should always be kept at a full charge to prevent excessive discharge during storage and so they are ready for delivery to customers at any time. See this bulletin for further detail.
NTB14068A2021-05-10. Service bulletin. VISIBILITY. SERVICE INFORMATION Power moonroof initialization procedures for the Applied Vehicles have been revised. The procedure described in this bulletin differs from the procedure in the Electronic Service Manual (ESM). At a later date and where possible, the applicable ESMs will be updated with the revised procedures. Follow the procedure in this bulletin should the power moonroof in an Applied Vehicle need to be initialized. See this bulletin for further details.
NTB13028A2021-05-10. Service bulletin. VISIBILITY. SERVICE INFORMATION Windshield "foreign material" that is on the surface of the glass in some cases can be cleaned off with a very particular type and grade of steel wool. * Most any foreign material on the surface of the Windshield can be cleaned off by using #0000 super fine steel wool. >The #0000 grade super fine steel wool can be found in most hardware stores. Please see this bulletin for further details.
NTB15009C2021-05-10. Service bulletin. EQUIPMENT. SERVICE INFORMATION Please share this bulletin with "sales staff" and staff associated with maintaining dealer stock vehicles. If an SD Map Card is removed from a Navigation/audio unit for any reason, the card MUST be returned to only the Navigation/audio unit that it came out of. SD Map Cards have data on them that is specific to the Navigation/audio unit that they are originally from, and may cause operational errors if installed into Navigation/audio units that they are not compatible with. - Keep track of any SD Map Cards that are removed from the vehicle by VIN, and return only to the same vehicle that it was removed from. - Do not remove the SD Map Card when returning the Navi/audio head unit for parts warranty. Head units must be returned with correct SD Map Cards or dealer will be charged back. See this bulletin for further detail.
NTB150982021-05-10. Service bulletin. ELECTRICAL SYSTEM. SERVICE INFORMATION NOTE: If the information below determines both parts need replacement, do not replace them at different times. Make sure both parts are replaced at the same time. Audio unit (with display) replacement: Whenever an audio unit on an applied vehicle is replaced for any reason, check the part number (P/N) of the A/C switch assembly (A/C Controller Assembly). A/C switch assembly (A/C controller assembly) replacement: Whenever an A/C switch assembly on an applied vehicle is replaced for any reason, check the P/N of the audio unit. Please see this bulletin for further information.
NTB150962021-05-10. Service bulletin. ENGINE AND ENGINE COOLING; POWER TRAIN; EQUIPMENT; ELECTRICAL SYSTEM. SERVICE INFORMATION For the Applied Vehicles, two (2) types of Power Moonroof "open operation" were made available. Type A - Opens all the way when the moonroof "open" switch is pressed once. Type B - Opens and stops slightly before the fully open position when the moonroof "open" switch is pressed once. NOTE - Refer to the Owner?s Manual for complete moonroof operation instructions. - The open operation (Type A or Type B) is controlled by the moonroof motor assembly. - As of September 1, 2015, ALL replacement moonroof motor assemblies have the Type B open operation. If a vehicle with Type A open operation has the moonroof motor assembly replaced for any reason, a moonroof motor assembly with Type B open operation will be supplied and will operate differently (as described above). See this bulletin for further detail.
NTB14114A2021-05-10. Service bulletin. PARKING BRAKE; SEAT BELTS; VEHICLE SPEED CONTROL. IF YOU CONFIRM All "hands free" functions of the Intelligent Key (I-Key) do not work. For example, the doors will not lock or unlock when pressing either front door request switch. NOTE: - The issue of all I-Key "hands free" functions not working may occur intermittently or all the time. - The message "No Key Detected" or similar may show on the Vehicle Information Display (located in the combination meter). - All I-Key remote button functions (door lock/unlock, etc.) WILL work normally when all I-Key "hands free" functions are NOT working. ACTION 1. Inspect the I-Key?s battery on its negative contact side. 2. If excessive scratching is found, replace the battery. 3. Verify all I-Key functions (both "hands free" and remote) work properly after battery replacement. NOTE: Do NOT replace the BCM, I-Key, or other parts for the issue described under IF YOU CONFIRM, if it should occur. See this bulletin for further detail.
NTB150922021-05-10. Service bulletin. EQUIPMENT:ELECTRICAL. SERVICE INFORMATION BOSE® audio systems are found in 2015 Murano Platinum, SL, and SV models equipped with the Premium Package only. Center speaker grilles on 2015 Murano vehicles equipped with a BOSE® audio system built after and starting with the VIN and date given in this bulletin do not have a BOSE emblem. Do not replace a center speaker grille* under warranty because it does not have a BOSE emblem. Replacement of this part for this reason on this model is not covered under warranty. * If the 2015 Murano Platinum, SL, or SV vehicle with Premium Package was built after and starting with the VIN and date given in this bulletin. See this bulletin for further detail.
NTB11069C2021-05-10. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM. IF YOU CONFIRM The customer states HomeLink will not operate or has improper operation. ACTIONS 1. To significantly reduce unnecessary repairs, make sure: a. The vehicle is not in "Transit Mode" (if equipped). - Not in Transit Mode: With the turn signal switch is in the OFF (center) position, turn the ignition from OFF to ON. If the turn signal indicators stay OFF (do not illuminate), the vehicle is not in Transit Mode. b. The "Extended Storage Switch" (if equipped) is in the "Customer Delivery" position (pushed in). - The Extended Storage Switch is located on the fuse block that is located in the interior of the vehicle. 2. Confirm the customer is familiar with the HomeLink programming procedure located in the vehicle?s owner?s manual. 3. Test HomeLink operation with special tool HomeLink Transmitter Tester J-41540. See this bulletin for further detail.
NTB13088A2021-05-10. Service bulletin. BACK OVER PREVENTION; WHEELS; SERVICE BRAKES; LANE DEPARTURE. SERVICE INFORMATION This bulletin has compiled Tire Pressure Monitor System (TPMS) and Low Tire Pressure Warning System (LTPWS) information for: - Basic diagnosing of TPMS/LTPWS systems - Radio frequency interference causing a "No Data" (C1708, C1709, C1710, C1711) condition - Sensor leaks - Moving TPMS/LTPWS wheel assemblies from one vehicle to another and TPMS/LTPWS sensor registration - Air pressure changes with altitude and ambient temperatures - Aftermarket tire sealers - Aftermarket wheels - Inflating/deflating tires with TPMS/LTPWS sensors See this bulletin for further detail.
NTB14057A2021-05-10. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:FLUID/LUBRICANT. SERVICE INFORMATION The information in this bulletin is provided to help ensure correct diagnosis and repair of fluid leaks. All fluid leaks, when properly diagnosed, should be repaired (whether under warranty or customer pay) to ensure proper vehicle operation. However, certain normal operating conditions can be misdiagnosed as a leak requiring repair. Unnecessary repair or replacement of parts in connection with incorrectly diagnosed "leaks" can negatively impact customer satisfaction, be time consuming and costly, and if not performed correctly can lead to future repairs. See this bulletin for further detail.
NTB150672021-05-10. Service bulletin. VEHICLE SPEED CONTROL. SERVICE INFORMATION The operation of the Automatic Back Door has changed. Please see this bulletin for further details.
NTB14115C2021-05-10. Service bulletin. EQUIPMENT. SERVICE INFORMATION For the Applied Vehicles in this bulletin, when an ABS Actuator and Electric Unit (ABS control unit) is replaced for any reason, Configuration of the ABS Control Unit must be performed. If Configuration is not performed, DTC C1170 (VARIANT CODING) will be stored. The Service Procedure in this bulletin contains the steps for performing ABS Control Unit Manual Configuration. See this bulletin for further detail.
NTB15001C2021-05-10. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. SERVICE INFORMATION If the AV control unit needs to be replaced in an Applied Vehicle for any reason, follow the Service Procedure in this bulletin to make sure all necessary configurations and registration are completed correctly. NOTE: - The Apps mode will not function if the AV control unit registration code is not registered. - Do not remove the SD Map Card when returning the Navi/audio head unit for parts warranty. Head units must be returned with correct SD Map Cards or the dealer will be charged back. See this bulletin for further detail.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.