WenmarOpen by Wenmar Pro

Service bulletins for the 2016 Nissan Maxima

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

278 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Bulletins, newest first
NTB15-015e2021-05-24. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:INTERNAL:CVT. Pathfinder, Quest, Murano, Maxima, Altima V6, CVT Judder and DTC P17F0 or P17F1 Stored
NTB15-014B2021-05-24. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:INTERNAL:CVT. Enhanced Diagnostic Logic for CVT Judder
NTB15-013B2021-05-24. Service bulletin. POWER TRAIN. Nissan; Procedure to clean CVT Transmission fluid coolers
NTB14-084C2021-05-24. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. 2-Sensor occupant classification System Diagnostics and Information
NTB12-103C2021-05-24. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:INTERNAL:CVT. CVT/TDCM Calibration Data "Write" Procedure
NTB12103D2021-05-10. Service bulletin. ELECTRICAL SYSTEM; POWER TRAIN. SERVICE INFORMATION The Service Procedure (starting on page 2) in this bulletin contains the steps to perform TCM Calibration Data Write Procedures. These procedures are used when a complete CVT is replaced, or a CVT control valve (valve body) is replaced, or a Transmission Control Module (TCM) is replaced. See this bulletin for further detail.
NTB11027B2021-05-10. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; TIRES. SERVICE INFORMATION Temporary tire Flat Spotting is common on New Dealer In-Stock vehicles that have not been occasionally moved. Flat Spotting can occur after the vehicle has been parked (not moved) for a few days, or longer. In most cases it is temporary. In extreme cases it can be permanent. Vehicles should be moved every 30 days, in one direction only, enough to rotate the tires 90° (see Figure 1). Moving vehicles as shown will prevent tire Flat Spotting. See this bulletin for further detail.
NTB160572021-05-10. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM):SOFTWARE. IF YOU CONFIRM * The MIL is ON with DTC P0507 (ISC SYSTEM) stored. ACTION 1. Refer to step 6 in the SERVICE PROCEDURE to confirm this bulletin applies to the vehicle you are working on. 2. If this bulletin applies, reprogram the ECM. Please see this bulletinf for further details.
NTB15013C2021-05-10. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:INTERNAL:CVT; POWER TRAIN; EQUIPMENT. IMPORTANT: Metal debris and friction material may become trapped in the radiator, cooling hoses, bypass valve or external CVT fluid cooler. This debris can contaminate the newly serviced transmission, control valve or torque converter. In severe cases this debris can block or restrict flow and may cause damage to the newly serviced CVT. SERVICE INFORMATION When a CVT, control valve or torque converter replacement is necessary for one of the applied vehicles, the CVT transmission fluid coolers (radiator based fluid cooler and external auxiliary cooler if present) must be flushed. Please see this bulletin for further details.
NTB15049H2021-05-10. Service bulletin. EQUIPMENT:ELECTRICAL; EQUIPMENT ADAPTIVE/MOBILITY. SERVICE INFORMATION The Applied Vehicles are equipped with a wireless communication device called a Telematics Communication Unit (TCU). With an active NissanConnectSM Services subscription, the TCU communicates with the NissanConnectSM Services Data Center to provide various security and convenience services. This bulletin contains important service procedures that must be performed properly in order to set-up and maintain the telematics system for the Applied Vehicles. See this bulletin for further detail.
NTB15015F2021-05-10. Service bulletin. POWER TRAIN; EQUIPMENT ADAPTIVE/MOBILITY. IF YOU CONFIRM: The customer reports a transmission judder (shake, shudder, single or multiple bumps or vibration) AND One of these DTCs is stored: - P17F0 (CVT_JUDDER (T/M INSPECTION)) - P17F1 (CVT_JUDDER (C/U INSPECTION)) NOTE - If a transmission judder (as described above) is not reported, this bulletin does not apply. - If either P17F0 or P17F1 are not stored, this bulletin does not apply. - NTB15-014, Enhanced Diagnostic Logic For CVT Judder, has reprogramming instructions that may apply. ACTIONS: Perform the SERVICE PROCEDURE, starting on page 3. - Review the Repair Flow Chart in this bulletin. NOTE: Essential Tool Tech Cam (borescope) J-51951 has been sent to dealers. This tool?s attachments make CVTinspection possible. See this bulletin for further detail.
NTB160462021-05-10. Service bulletin. AIR BAGS; EQUIPMENT. SERVICE INFORMATION Nissan is issuing this Technical Service Bulletin to clarify that a change has been made for the logic that controls the Occupant Classification System (OCS) and 'passenger airbag indicator' (PABI), as described in the Owner?s Manual. This TSB applies only to vehicles using the 2-sensor OCS. Those changes are: * PABI light is ON with an empty front passenger seat. Please see this bulletin for further details.
NTB09099A2021-05-10. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER; EQUIPMENT ADAPTIVE/MOBILITY. IF YOU CONFIRM A refrigerant leak at a refrigerant pipe/hose joint location. ACTIONS 1. Inspect the metal surfaces of the pipe/hose joint for damage or contamination. NOTE: Do not replace a refrigerant pipe, hose, or other A/C component if an o-ring seal will solve the leak incident, if it should occur. 2. If no damage is found to the joint metal surfaces, replace the O-ring seal. See this bulletin for further detail.
NTB09131B2021-05-10. Service bulletin. FORWARD COLLISION AVOIDANCE; EQUIPMENT:OTHER:LABELS. SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement "Certification Label" or "VIN Plate / Label" may be needed. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. See this bulletin for further detail.
NTB160402021-05-10. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM:WIRING:CONNECTORS/PLUGS/RECEPTACLES. IF YOU CONFIRM That the interior accent lighting flickers intermittently. ACTION 1. Disconnect the BROWN wire that is part of the Accessory Connector Harness used when the Kit was installed. 2. Please refer to the following SERVICE PROCEDURE which shows the wire which needs to be disconnected. Please see this bulletin for further details.
NTB15014B2021-05-10. Service bulletin. EQUIPMENT; POWER TRAIN:AUTOMATIC TRANSMISSION:INTERNAL:CVT; POWER TRAIN. IF YOU CONFIRM The customer reports a transmission judder (shake, shudder, single or multiple bumps or vibration). NOTE: A new diagnostic logic has been established to enhance the diagnostic process by storing diagnostic trouble codes (DTCs) on Applied Vehicles. The new DTCs are: P17F1 (CVT_JUDDER [C/U INSPECTION]) P17F0 (CVT_JUDDER [T/M INSPECTION]) ACTION 1. Refer to page 4, step 6 in the SERVICE PROCEDURE to confirm this bulletin applies to the vehicle you are working on. NOTE:The current TCM Part Numbers in this bulletin have been updated. The vehicle you are working on may require reprogramming per this bulletin again. 2. If this bulletin applies, reprogram the TCM (Transmission Control Module) See this bulletin for further detail.
NTB15044B2021-05-10. Service bulletin. EQUIPMENT; FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:FILLER PIPE AND CAP. SERVICE INFORMATION If the clip for the fuel filler cap tether becomes lost or is detached for any reason, it is no longer necessary to replace the fuel filler cap. The clip or "pin" is now available as a separate service part. NOTE - Do not replace the fuel filler cap if only the pin is needed. See this bulletin for further detail.
NTB160252021-05-10. Service bulletin. EQUIPMENT; BACK OVER PREVENTION; ELECTRICAL SYSTEM. SERVICE INFORMATION If an Air Bag Diagnosis Sensor Unit is replaced and the configuration of the old unit could not be saved, use the Service Procedure in this bulletin to: - Load the VIN specific configuration file from your electronic parts catalog (FAST or equivalent) onto a portable USB storage device (thumb drive) - Plug the thumb drive into your CONSULT PC. - Configure the new Air Bag Diagnosis Sensor Unit using the file that you loaded onto the thumb drive. See this bulletin for further detail.
NTB160222021-05-10. Service bulletin. EQUIPMENT. IF YOU CONFIRM The following incident, or the customer reports this incident: The vehicle has been parked (not running) in below freezing temperatures for an extended period (such as overnight). Then The Intelligent Key, key fob, or mechanical keyis used to perform door unlock. Then When attempting to open the door, the door will not open (using either outside or inside handle, or both), or the door will open, but will not latch when closed. Then The door lock and latch functions normally when the vehicle has warmed up (vehicle left in the sun, moved indoors, or driven for several minutes). NOTE: The above incident, if it should occur, could be confirmed or reported for one or more of the four doors. ACTION 1. Replace the door lock of the door(s) that do not open or latch. - Do not replace all four door locks automatically, only replace the door lock of the door(s) with the issue as outlined under IF YOU CONFIRM. 2. Apply RTV silicone sealant and add foam to the new door lock(s). 3. If the issue described under IF YOU CONFIRM applies to the front door(s), perform adjustments to the existing outside handle bracket(s). See this bulletin for further detail.
NTB03074J2021-05-10. Service bulletin. EXTERIOR LIGHTING. SERVICE INFORMATION Occasionally customers may notice water vapor or fog in the headlamps. The information, illustrations, and flow chart in this bulletin are provided to help you in determining if an incident for water/condensation in the headlamps is normal or not. Nissan?s new vehicle limited warranty does not cover physically damaged (cracked or broken) headlamps. All current headlamp assemblies are vented to the atmosphere (not sealed). - This is necessary to allow for expansion and contraction of air from temperature "variations" (warmer or colder) without damage to the headlamp. - Moisture in the air sometimes "travels" into and out of the headlamp assembly through these vents. - Certain environmental conditions may cause moisture to condense. - The fogging/cloudiness should disappear over time when the headlamp is in a dry environment. See this bulletin for further detail.
NTB160182021-05-10. Service bulletin. ELECTRICAL SYSTEM. IF YOU CONFIRM The MIL is "ON" with DTC P0603 (ECM BACK UP/CIRCUIT). ACTION 1. Confirm that the battery voltage is 11 volts, or more, with the ignition ON (engine OFF, not running). 2. Erase DTC 3. Perform DTC confirmation steps in the Service Procedure. 4. Confirm 1st trip DTC P0603 is not stored. NOTE: P0603 is often the result of low battery voltage, discharged battery or battery terminal disconnections. Please see this bulletin for furtner details.
NTB160172021-05-10. Service bulletin. VISIBILITY:FIXED PANARAMIC ROOF/SKY LIGHT ASSEMBLY. SERVICE INFORMATION When working on the Moonroof, several items can be replaced, repaired, or adjusted, without the need to replace the entire Moonroof assembly. Refer to the following procedures in this bulletin, as needed, to help resolve Moonroof issues. * Knock Insert (Knock) Replacement (Page 2) * Wind Deflector Replacement (Page 7) For wind deflector being damaged, scratched, or having a broken clip. * Trim Panel Replacement (Page 12) For trim panel being damaged, having seal issues or trim panel not being seated. * Moonroof Glass Adjustment (Page 16) For adjusting fit, tightening loose screws or for glass being out of position. * Front or Rear Sunshade Replacement (Page 24) For sunshade replacement due to discoloration,being jammed, out of track, loss of tension or popping/clicking while in motion. * Moonroof or Sunshade Motor Repair (Page 28) For inoperative or noisy. Please see this bulletin for further details.
NTB160142021-05-10. Service bulletin. EQUIPMENT; FORWARD COLLISION AVOIDANCE: SENSING SYSTEM: SONAR/ULTRASONIC. SERVICE INFORMATION When diagnosing the front sonar parking sensor for unwanted activation (e.g. sonar activates with no obstacle ahead), inspect the front license plate, front license plate frame and if equipped, the front license plate bracket. See page 2 for example photos. The front sonar parking sensor may activate if the front license plate is bent outward from its bracket (there is a gap between the license plate and the bracket) OR the front license plate frame is bent or loose and is hanging outward, away from the license plate and/or bracket (there is a gap between the license plate frame and the license plate and/or bracket) OR the bracket is loose and is hanging outward, away from the bumper (there is a gap between the bracket and the bumper). If any of these conditions are found, correct it by removing the gap (straighten the license plate, straighten and/or secure the license plate frame, or secure the bracket, as it applies). - Retest the operation of the front sonar parking sensor. If the issue is not resolved, go to ASIST and the related Electronic Service Manual (ESM) for further diagnosis. See this bulletin for further detail.
NTB09081C2021-05-10. Service bulletin. VISIBILITY. SERVICE INFORMATION The purpose of this bulletin is to give Nissan dealers guidelines to help determine if windshield breakage is covered under warranty or is the customer?s responsibility. Nissan North America (NNA) is not responsible for damage to glass that is a result of objects striking or scratching the glass. However, NNA is responsible for manufacturing issues such as distorted glass and cracks that are due to improper installation or damage to the glass during vehicle assembly. NNA typically does not find any type of cracks in the windshield due to stress after the dealership PDI. See this bulletin for further detail.
NTB15031A2021-05-10. Service bulletin. ELECTRICAL SYSTEM. SERVICE INFORMATION Combination Meter Self-Learning After Replacement 2015 Murano Combination Meters have a learning function when first installed. IMPORTANT: Immediately after initial installation and ignition ON, the combination meter adapts to the way the vehicle is equipped. Performing self-learning can be done only once. Once done, it cannot be changed. CAUTION: Never install a combination meter from an ADAS equipped 2015 Murano into a non-ADAS equipped 2015 Murano, or vice versa, for testing purposes or any other reason. If this incident occurs, the combination meter will need to be replaced. See this bulletin for further detail.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.