WenmarOpen by Wenmar Pro

Service bulletins for the 2025 Nissan Armada

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

9 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
NTB25-0632026-02-10. Service bulletin. ENGINE. VENT CONTROL VALVE IN ACTIVE TEST INOPERATIVE IN CONSULT 4 SERVICE INFORMATION An issue in CONSULT 4 has been identified in “EVAP system close” in Work support. · After selecting the "EVAP system close" in Work support, the “VENT CONTROL/V” in Active test becomes non-functional temporarily. · When selecting “EVAP system close” operation in Work support, wait 10 minutes before starting “VENT CONTROL/V” Active test or cycle the IGN switch ON/OFF for “VENT CONTROL/V” Active test to be operational. HINT: This bulletin applies to model years that use CONSULT 4 only.
NTB25-0132025-03-25. Service bulletin. ENGINE. ECM REPLACEMENT PROCEDURE REQUIRED FOR RES EQUIPPED VEHICLES SERVICE INFORMATION If any of the APPLIED VEHICLES equipped with Remote Engine Start (RES) requires Engine Control Module (ECM) replacement, the Body Control Module (BCM) must be replaced also at the same time. If you are not familiar with the Re/programming, Configuration procedure, refer to the Electronic Service Manual (ESM) and the CONSULT Operation Manual to reprogram the Electronic Control Unit (ECU). Follow all precautions in both manuals to prevent possible personal injury or death and/or damage to the ECU. • This procedure will go back and forth between the ECM and BCM steps as found in the ESM. • Damage will occur requiring the ECM and the BCM to be replaced a second time if the following SERVICE PROCEDURE is not followed. Perform the following steps from the Electronic Service Manual (ESM) in this order: A. Perform “Work Procedure (Before Replacing ECM)” to save the ECM data. B. Remove the ECM. C. Remove the BCM. D. Install the new BCM and then perform “Additional Service When Replacing BCM - Work Procedure” up to and including “Register of Vehicle Identification Number”. E. Install the new ECM and then perform “Additional Service When Replacing ECM - Work Procedure (After Replacing ECM)” up to and including “Writing MAC Key for ECM”. F. Complete the “Additional Service When Replacing BCM - Work Procedure”. G. Complete the “Additional Service When Replacing ECM - Work Procedure (After Replacing ECM)”.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.